Mineralogical analysis of auriferous ores from the El Diamante mine, Colombia

X-ray diffraction (XRD), Mössbauer spectrometry (MS), secondary ions mass spectroscopy (SIMS) and laser-ablation microprobe–inductively coupled plasma–mass spectrometry (LAM–ICP–MS) were used to study mineral samples of Colombian auriferous ores collected from the “El Diamante” mine, located in the municipality of Guachavez-Nariño, in Colombia. The samples were prepared as polished thin sections and polished sections. From XRD data, quartz, sphalerite and pyrite were detected and their respective cell parameters were estimated. From MS analyses, pyrite, arsenopyrite and chalcopyrite were identified; their respective hyperfine parameters and respective texture were deduced. Multiple regions of approximately 200 × 200 μm in each sample were analyzed with SIMS; the occurrence of “invisible gold” associated mainly with pyrite and secondarily with arsenopyrite could thus be assigned. It was also found that pyrite is of the arsenious type. Spots from 30 to 40 μm in diameter were analyzed with LAM–ICP–MS for pyrite, arsenopyrite and sphalerite; Au is “homogeneously” distributed inside the structure of the arsenious pyrite and the arsenopyrite (not as inclusions); the chemical composition indicates similarities of this “invisible gold”, forming a solid solution with arsenious pyrite and arsenopyrite. One hundred nineteen and 62 ppm of ‘invisible gold’ was quantified in 21 spots analyzed on pyrite and in 14 spots on arsenopyrite, respectively.     

Low dose 60Co gamma-irradiation effects on electronic carrier transport and DC characteristics of AlGaN/GaN high-electron-mobility transistors

The impact of internal irradiation with secondary Compton electrons, generated by gamma-photons, on the characteristics of III-N/GaN-based devices was explored. N-channel AlGaN/GaN high-electron-mobility transistors (HEMTs) were exposed to gamma-radiation from a ⁶⁰Co source for doses up to 600?Gy. Temperature-dependent electron beam-induced current (EBIC) was employed to measure minority carrier transport properties. For low doses below ～250?Gy, the minority carrier diffusion length in AlGaN/GaN HEMTs is shown to increase by about 40%. This increase is likely due to longer minority carrier lifetime induced by internal Compton electron irradiation. An associated decrease in activation energy, extracted from temperature-dependent EBIC, was also found. The obtained increase in transconductance and decrease in gate leakage current indicate an improvement in performance of the devices after low doses of irradiation. For high doses of gamma-irradiation, above ～300?Gy, the performance of HEMTs showed a deterioration. The deterioration results from the onset of increased carrier scattering due to additional radiation-induced defects, as is translated in a decrease of minority carrier diffusion length.     

Material parameter computation for multi-layered vocal fold models

Today, the prevention and treatment of voice disorders is an ever-increasing health concern. Since many occupations rely on verbal communication, vocal health is necessary just to maintain one's livelihood. Commonly applied models to study vocal fold vibrations and air flow distributions are self sustained physical models of the larynx composed of artificial silicone vocal folds. Choosing appropriate mechanical parameters for these vocal fold models while considering simplifications due to manufacturing restrictions is difficult but crucial for achieving realistic behavior. In the present work, a combination of experimental and numerical approaches to compute material parameters for synthetic vocal fold models is presented. The material parameters are derived from deformation behaviors of excised human larynges. The resulting deformations are used as reference displacements for a tracking functional to be optimized. Material optimization was applied to three-dimensional vocal fold models based on isotropic and transverse-isotropic material laws, considering both a layered model with homogeneous material properties on each layer and an inhomogeneous model. The best results exhibited a transversal-isotropic inhomogeneous (i.e., not producible) model. For the homogeneous model (three layers), the transversal-isotropic material parameters were also computed for each layer yielding deformations similar to the measured human vocal fold deformations.     

Ankyrin repeat and SOCS box containing protein 4 (Asb-4) colocalizes with insulin receptor substrate 4 (IRS4) in the hypothalamic neurons and mediates IRS4 degradation

Background

Cigarette smoking enhances the risk of stroke. However, the underlying molecular mechanisms are largely unknown. The present study established an in vivo rat secondhand cigarette smoking (SHS) model and examined the hypothesis that SHS upregulates endothelin receptors with increased cerebrovascular contraction via the Raf/extracellular signal-regulated kinase (ERK)/mitogen-activated protein kinases (MAPK) pathway.

Results

Rats were exposed to SHS for up to 8 weeks. The cerebral artery vasoconstriction was recorded by a sensitive myograph. The mRNA and protein expressions for endothelin receptors in cerebral arteries were studied by real-time PCR and Western blot. Compared to fresh air exposed rats, cerebral arteries from SHS rats exhibited stronger contractile responses (P < 0.05) mediated by endothelin type A (ET_A) receptors. The expressions of mRNA and protein for ET_A receptors in the cerebral arteries from SHS rats were higher (P < 0.05) than that in control. SHS did not affect endothelin type B (ET_B) receptor-mediated contractions, mRNA or protein levels. The results suggest that SHS upregulates ET_A, but not ET_B receptors in vivo. After SHS exposure, the mRNA levels of Raf-1 and ERK1/2, the protein expression of phosphorylated (p)-Raf-1 and p-ERK1/2 were increased (P < 0.05). Raf-1 inhibitor, GW5074 suppressed the enhanced ET_A receptor-mediated contraction, mRNA and protein levels induced by SHS. In addition, GW5074 inhibited the SHS-caused increased mRNA and phosphorylated protein levels of Raf-1 and ERK1/2, suggesting that SHS induces activation of the Raf/ERK/MAPK pathway.

Conclusions

SHS upregulates cerebrovascular ET_A receptors via the Raf/ERK/MAPK pathway, which provides novel understanding of mechanisms involved in SHS-associated stroke.     

Tunnel magnetoresistance in alumina, magnesia and composite tunnel barrier magnetic tunnel junctions

Using magnetron sputtering, we have prepared Co-Fe-B/tunnel barrier/Co-Fe-B magnetic tunnel junctions with tunnel barriers consisting of alumina, magnesia, and magnesia-alumina bilayer systems. The highest tunnel magnetoresistance ratios we found were 73% for alumina and 323% for magnesia-based tunnel junctions. Additionally, tunnel junctions with a unified layer stack were prepared for the three different barriers. In these systems, the tunnel magnetoresistance ratios at optimum annealing temperatures were found to be 65% for alumina, 173% for magnesia, and 78% for the composite tunnel barriers. The similar tunnel magnetoresistance ratios of the tunnel junctions containing alumina provide evidence that coherent tunneling is suppressed by the alumina layer in the composite tunnel barrier.     

Spatial and temporal resolution effects on dynamic contrast-enhanced magnetic resonance mammography

We tested the hypothesis that partial volume effects due to poor in-plane resolution and/or low temporal resolution used in clinical dynamic contrast-enhanced magnetic resonance imaging results in erroneous diagnostic information based on inaccurate estimates of tumor contrast agent extravasation and tested whether reduced encoding techniques can correct for dynamic data volume averaging. Image spatial resolution was reduced from 469 x 469 microm2 to those reported below by selecting a subset of k-space data. We then compared the top five K(trans)/V(T) "hot spots" obtained from the original data set, 469 x 469-microm in-plane spatial resolution and an 18-s temporal resolution processed by fast Fourier transform (FFT), with values obtained from data sets having in-plane spatial resolutions of 938 x 938, 1875 x 1875 and 2500 x 2500 microm2 and a temporal resolution of 18 s, or data sets with temporal resolutions of 36, 54 and 72 and a spatial resolution of 469 x 469 microm2, and found them to statistically differ from the parent data sets. We then tested four different post processing methods for improving the spatial resolution without sacrificing temporal resolution: zero-filled FFT, keyhole, reduced-encoding imaging by generalized-series reconstruction (RIGR) and two-reference RIGR (TRIGR). The top five values of K(trans)/V(T) obtained from data sets, the in-plane spatial resolutions of which were improved to 469 x 469 microm2 by zero-filling FFT, Keyhole and RIGR, statistically differed from those obtained from the original 469 x 469 microm2 FFT parent image data set. Only the 938 x 938 and 1875 x 1875 microm2 data sets reconstructed to 469 x 469 microm2 with TRIGR reconstruction method yielded values of the top five K(trans)/V(T) hot spots statistically the same as the original parent data set, 469 x 469 microm2 in-plane spatial and 18-s temporal-resolution FFT. That is, partial volume effects from data sets of different in-plane spatial resolution resulted in statistically different values of the top five K(trans)/V(T) hot spots relative to a high spatial and temporal resolution data set, and TRIGR reconstruction of these low resolution data sets to high resolution images provided statistically similar values with a savings in temporal resolution of 2 to 4 times.     

Rapid surface-to-volume ratio and tortuosity measurement using Difftrain

Analysis of diffusion measurements as a function of observation time (Delta), to calculate surface-to-volume ratios (S/V) and tortuosities (kappa), is a useful tool in the characterisation of porous media using NMR. However, using conventional pulsed field gradient (PFG) measurements, this requires long total experiment times (typically hours). Here, we show how the rapid diffusion measurement pulse sequence, Difftrain, can be used to provide the required experimental data much more rapidly (typically within minutes) with a consequential reduction in total experiment time of typically over an order of magnitude. Several novel modifications to the Difftrain pulse sequence are also presented to tailor it to this particular application; these include a variable delay between echoes (to ensure optimal echo position with respect to Delta) and a variable tip angle for the refocusing pulse (to ensure optimal use of available signal). Difftrain is applied to measure both S/V and kappa for a model glass bead pack; excellent agreement is found with both a conventional PFG measurement and with a bulk gravimetric measurement of S/V.     

Improved rejection of multiply scattered photons in confocal microscopy using dual-axes architecture

We perform Monte Carlo simulations to show that the dual-axes (DA) confocal architecture has superior rejection of multiply scattered photons in tissue to that of single axis. As a result, the DA configuration provides improved signal-to-noise ratio and dynamic range, and thus is sensitive to ballistic photons from deeper within tissue, features that are particularly useful for performing vertical cross-sectional reflectance images in tissue.     

Narrowband, tunable, frequency-doubled, erbium-doped fiber-amplifed transmitter

We report on the development of a fiber-based laser transmitter designed for active remote sensing spectroscopy. The transmitter uses a master oscillator power amplifier (MOPA) configuration with a distributed feedback diode-laser master oscillator and an erbium-doped fiber amplifier. The output from the MOPA is frequency-doubled with a periodically poled potassium titanium oxide phosphate crystal. With 35 W of single-frequency peak optical pump power, 8 W of frequency-doubled peak power was achieved. The utility of this single-frequency, wavelength tunable, power scalable laser was then demonstrated in a spectroscopic measurement of diatomic oxygen A band.     

Heavy flags undergo spontaneous oscillations in flowing water

By immersing a compliant yet self-supporting sheet into flowing water, we study a heavy, streamlined, and elastic body interacting with a fluid. We find that above a critical flow velocity a sheet aligned with the flow begins to flap with a Strouhal frequency consistent with animal locomotion. This transition is subcritical. Our results agree qualitatively with a simple fluid dynamical model that predicts linear instability at a critical flow speed. Both experiment and theory emphasize the importance of body inertia in overcoming the stabilizing effects of finite rigidity and fluid drag.