Electrical behavior of the Au/MoS2 interface studied by light emission induced by scanning tunneling microscopy

Light emitted in the tunneling junction of a scanning tunneling microscope has been used to establish the electrical characteristics of nanojunctions made of Au islands deposited on flat MoS₂ surfaces. It is shown that these characteristics are those of rectifying contacts when the gold islands are isolated and that they evolve toward those of ohmic contacts when the island density increases. It is observed that the rectifying behavior also evolves over time as on infinite metal/semiconductor contacts. Using the STM tip, single gold islands can be manipulated on the MoS₂ surface so that their electrical behavior can be changed depending on their position with regard to the other islands.     

Effects of sputter deposition parameters and post-deposition annealing on the electrical characteristics of LaAlO3 dielectric films on Si

The influence of processing parameters on the electrical characteristics of RuO₂/LaAlO₃/Si metal-oxide-semiconductor structures was investigated. In particular, the sputtering regime during deposition of LaAlO₃ on Si and the atmosphere used in the post-deposition annealing step were addressed by determining capacitance-voltage and gate current-voltage characteristics. These results were correlated with compositional information obtained by Rutherford backscattering spectrometry and nuclear reaction analysis. A post-deposition annealing step in oxygen at 600 °C resulted in better electrical characteristics of the final structure as compared to the same treatment performed in nitrogen. This result is explained by oxygen ability to heal oxygen vacancies in the LaAlO₃ film, especially at the dielectric/semiconductor interface region. A thermalized sputtering regime during deposition of LaAlO₃ on Si leads to capacitors with electrical characteristics superior to those deposited in ballistic regime. PACS 77.84.Dy; 81.15.Cd; 81.40.Gh; 73.40.Qv; 82.80.Yc     

EPR-detected photoinduced electron transfer in three structurally related molecular triads

A comparative electron paramagnetic resonance (EPR) study has been performed on a series of structurally related molecular triads which undergo photoinduced electron transfer and differ one from the other in terms of the acceptor or donor moieties. The molecular triads, C-P-C₆₀, TTF-P-C₆₀ and C-P-P_F, share the same free-base, tetraarylporphyrin (P) as the primary electron donor, which after light excitation initiates the electron transfer process, but differ either in terms of the electron acceptor (fullerene derivative, C₆₀, versus fluorinated free-base porphyrin, P_F), or in terms of the final electron donor (carotenoid polyene, C, versus tetrathiafulvalene, TTF). All these molecular triads can be considered artificial photosynthetic reaction centers in their ability to mimic several key properties of the reaction center primary photochemistry. Photoinduced charge separation and recombination have been followed by time-resolved EPR in a glass of 2-methyltetrahydrofuran and in the nematic phase of the uniaxial liquid crystal E-7. All the triads undergo photoinduced electron transfer, with the generation of charge-separated states in both the low-dielectric environment of the 2-methyl-tetrahydrofuran glass and in anisotropic E-7 medium. Different photochemical pathways have been recognized depending on the specific donor and acceptor moieties constituting the molecular triads. In the presence of the tetrathiafulvalene electron donor singlet- and triplet-initiated electron transfer routes are concurrently active. Recombination to the low-lying carotenoid triplet state occurs in the carotene-based triads, while singlet recombination is the only active route for the TTF-P-C₆₀ triad, where a low-lying triplet state is lacking. Long-lived charge separation has been observed in the case of TTF-P-C₆₀: about 8 μs for the singlet-born radical pair in the glassy isotropic matrix and about 7 μs for the triplet-born radical pair in the nematic phase of E-7. For all the molecular triads, a weak exchange interaction (J?1 G) between the electrons in the final spin-correlated radical pair has been evaluated by simulation of the EPR spectra, providing evidence for superexchange electronic interactions mediated by the tetraarylporphyrin bridge.     

Smart Geodesic Tracing in GRworkbench

We have developed a new tool for numerical work in General Relativity: GRworkbench. We discuss how GRworkbench's implementation of a numerically-amenable analogue to Differential Geometry facilitates the development of robust and chart-independent numerical algorithms. We consider, as an example, geodesic tracing on two charts covering the exterior Schwarzschild space-time.     

On the Reality of the Eigenvalues for a Class of -Symmetric Oscillators

 We study the eigenvalue problem with the boundary conditions that decays to zero as z tends to infinity along the rays , where is a real polynomial and . We prove that if for some we have for all , then the eigenvalues are all positive real. We then sharpen this to a larger class of polynomial potentials. In particular, this implies that the eigenvalues are all positive real for the potentials when with , and with the boundary conditions that decays to zero as z tends to infinity along the positive and negative real axes. This verifies a conjecture of Bessis and Zinn-Justin. Received: 16 January 2002 / Accepted: 1 May 2002 Published online: 6 August 2002     

MODEL COMPARISON FOR ACOUSTIC SCATTERING BY A SPHERICAL AIR BUBBLE IN WATER

The oscillation of a bubble has many vibrational modes, contributing to different portions in acoustic scattering. Without approximations a priori, an hydrodynamic approach is applied to investigate acoustic scattering by a bubble in water, taking into account the heat exchange and viscosity. The scattering function is derived for a wide range of frequencies. Examples are shown to illustrate the thermal and viscous effects on sound scattering. Comparison is made with three existing models. While these models are known not to be applicable for high frequencies, it is shown here that even in the low-frequency region, there are also noticeable discrepancies between the exact solution and the three existing models with regard to the scattering properties such as the scattering cross-section, and the quality factor of resonant peaks. By numerical simulation, we claim that the discrepancies may be due to the incomplete consideration of the thermal exchange process in the previous models. The approach presented here is valid for any other fluid enclosure in liquids.     

Magnetic properties of oxygenated carbon nitride films from RF-discharge in an acetylene, nitrogen, and oxygen mixture environments

Properties of oxygenated carbon nitride films have attracted the attention of physics researchers due to their magnetic and physical properties, as well as for their usefulness in the industry. The free radicals were investigated using electron paramagnetic resonance applied in the study of spin concentration due to the different mechanism of preparation of carbon nitride films by RF-discharge with different kinds of plasma. Unpaired spin concentrations, in the order of 10²⁰ per cm³, were measured and their time recombination dependency was important in those films. The films were grown by plasma enhanced chemical vapor deposition using mixtures of hydrocarbons, N₂ and O₂ in different proportions.     

Three-dimensional radiative transfer in an anisotropically scattering, semi-infinite medium: generalized reflection function

Three-dimensional radiative transfer in an anisotropic scattering medium exposed to spatially varying, collimated radiation is studied. The generalized reflection function for a semi-infinite medium with a very general scattering phase function is the focus of this investigation. An integral transform is used to reduce the three-dimensional transport equation to a one-dimensional form, and a modified Ambarzumian's method is applied to formulate a nonlinear integral equation for the generalized reflection function. The integration is over both the polar and azimuthal angles; hence, the integral equation is said to be in the double-integral form. The double-integral, reflection function formulation can handle a variety of anisotropic phase functions and does not require an expansion of the phase function in a Legendre polynomial series. Complicated kernel transformations of previous single-integral studies are eliminated. Single and double scattering approximations are developed. Numerical results are presented for a Rayleigh phase function to illustrate the computational characteristics of the method and are compared to results obtained with the single-integral method. Agreement between the two approaches is excellent; however, as the transform variable increases beyond five the number of quadrature points required for the double-integral method to produce accurate solutions significantly increases. A new interpolation scheme produces accurate results when the transform variable is large.     

A comprehensive study of the long pulse Nd:YAG laser drilling of multi-layer carbon fibre composites

The results of an extensive experimental study of the free running Nd:YAG laser drilling of a multi-layer carbon fibre composite, where adjacent layers have differently orientated fibres, are reported. For holes drilled with the laser operating in fixed-Q mode at 1064 nm, parallel sections of blind holes illustrating discontinuities in the hole size along a given section direction will be shown to occur at the interface between adjacent layers. An explanation for this effect is proposed. Detailed single pulse drilling characteristics will be presented illustrating the exit hole diameter as a function of pulse energy and material thickness. These characteristics illustrate a ‘stable' drilling regime in which the exit hole diameters are least sensitive to changes in pulse energy or material thickness and a less ‘stable' regime in which they are more strongly dependent on these parameters. Drilling characteristics will be given for two different beam qualities, illustrating the greater drilling depth and reduced hole size achievable with an improved beam quality. Finally holes drilled through a 2 mm thick sample of material with multiple pulses are considered. Size distribution curves for entrance and exit holes will be presented. The total energy required (number of pulses × pulse energy) to drill through 2 mm thick material will be reported as a function of pulse energy in stationary air and argon atmospheres and in a partial vacuum, illustrating a threshold energy which is dependent upon the drilling atmosphere. The threshold energies will be discussed with reference to plasma formation and the reactivity of the drilling atmosphere.     

Rb saturation spectroscopy with an optically narrowed FM diode laser

A fast-frequency modulated (FM) diode laser has been optically narrowed using the technique of resonant optical feedback, to provide linewidths in each FM mode of ≈ 200 kHz peak-to-peak. With a drive frequency of 50 MHz and modulation index of 0.2, the FM laser has been used for the first time to obtain Doppler-free FM spectra of the Rb D₁ line at 795 nm. The potential use of this system for laser frequency stabilisation is discussed.