pH sensitivity of Si--C linked organic monolayers on crystalline silicon surfaces.

The electrochemical behavior of Si--C linked organic monolayers is studied in electrolyte-insulator-Si devices, under conditions normally encountered in potentiometric biosensors, to gain fundamental knowledge on the behavior of such Si electrodes under practical conditions. This is done via titration experiments, Mott-Schottky data analysis, and data fitting using a site-binding model. The results are compared with those of native SiO(2) layers and native SiO(2) layers modified with hexamethyldisilazane. All samples display pH sensitivity. The number of Si--OH groups on the alkylated samples is calculated to be less than 0.7 % of that of a pure SiO(2) insulator, which still causes a pH sensitivity of approximately 25 mV per pH unit in the pH range: 4-7. The alkylated samples hardly suffer from response changes during up- and down-going titrations, which indicates that very little oxide is additionally formed during the measurements. The pK(a) values of all samples with monolayers (4.0-4.4) are lower than that of native SiO(2) (6.0). The long-term drift (of approximately 1 mV h(-1)) is moderate. The results indicate that biosensors composed of alkylated Si substrates are feasible if a cross-sensitivity towards pH in the sensor signal is taken into account.     

Anordnung und Orientierung kationischer Tenside auf ebenen Silicatoberflächen

Zusammenfassung Die n-Alkylammoniumderivate der glimmerartigen Schichtsilicate können als Modellsubstanzen für die Anordnung kationischer Tenside an Festkörpergrenzflächen herangezogen werden. Im ersten Teil der Arbeit wird die Darstellung durch Kationenaustausch aus den natürlichen Schichtsilicaten beschrieben. Es wird ausführlich auf die Fehlerquellen hingewiesen, die reproduzierbare Messungen erschweren.

---

Summary The n-alkylammonium derivatives of mica-type layer silicates are suitable models for studies about the arrangement of cationic tensides at solid interfaces. Part I of the paper deals with the preparation of these compounds by a simple cation exchange reaction. Sources for errors in obtaining reproducible data are discussed in detail.

---

---

Mit 1 Abbildung in 3 Einzeldarstellungen und 3 Tabellen     

Low temperature absorption spectra of TcO 4 − and ReO 4 − in KClO4

The low temperature spectra of TcO ₄ ^– and ReO ₄ ^– both show two band systems with pronounced vibrational structures. The bands are identified as¹ A ₁¹ T ₂ transitions. No other bands are observed with certainty. It seems likely that the KClO₄ crystals contain KReO₄ crystallites. They are therefore not pure mixed crystals. It is concluded that the virtual orbital (2e) used in the construction of the low lying states resembles an atomic nd orbital more and more when going from n=3, Mn to n=5, Re.

---

Zusammenfassung Die Tieftemperaturspektren von TcO ₄ ^– und ReO ₄ ^– zeigen beide zwei Bandensysteme mit ausgeprägten Schwingungsstrukturen. Die Banden werden als ¹ A ₁¹ T ₂-Übergänge identifiziert. Keine anderen Banden werden mit Sicherheit beobachtet. Es scheint wahrscheinlich, daß die KClO₄-Kristalle KReO₄-Kristallite enthalten und deswegen keine reinen Mischkristalle sind. Es wird geschlossen, daß das virtuelle Orbital (2e), welches zur Konstruktion der tiefliegenden Zustände gebraucht wird, in der Reihe n=3, Mn bis n=5, Re immer weitgehender einem nd-Atomorbital ähnelt.

---

---

Nachwuchsstipendiat, Schweizerischer Nationalfonds.     

Crystal structure and reactivity of 2-chloro-3,5-dinitrothiophene and of 2-phenylsulphonyl-3,5-dinitrothiophene with nucleophiles

The geometry obtained by a crystal structure determination of the title compounds, as compared with that of the analogous benzene derivatives, along with results of ab initio calculations, is used to interpret the different S_NAr reactivities in some thiophene and benzene compounds. The smaller rotation of the nitro groups with respect to the aromatic rings observed in thiophene derivatives should be considered a relevant factor in the higher reactivity in the thiophene series.     

Neue Näherungsgleichung zur einheitlichen Berechnung von Wärmeübertragern

Zusammenfassung Es wird eine für alle Stromführungen einheitliche Näherungsgleichung mit drei oder vier anpaßbaren Parametern zur Berechnung des Korrekturfaktors für die mittlere logarithmische Temperaturdifferenz angegeben. Die anpaßbaren Parameter wurden für etwa 50 verschiedene Stromführungen durch Ausgleichsrechnung bestimmt. Die Genauigkeit der Gleichung ist für die Berechnung im praktisch wichtigen Bereich mehr als ausreichend.

---

New approximate equation for uniform heat exchanger design

An approximate equation with three or four empirical parameters for the uniform calculation of the LMTD-correction factor of all heat exchanger configurations is proposed. The empirical parameters have been determined for about 50 different flow configurations using least squares estimation. The accuracy of the equation is more than sufficient for practical design purposes.

---

Formelzeichen A Übertragungsfläche - a, b, c, d Parameter der Näherungsgleichung - Wärmekapazitätsstrom - F Korrekturfaktor für die logarithmische mittlere Temperaturdifferenz - k Wärmedurchgangskoeffizient - m, n Zahl der Durchgänge oder Einzelapparate - NTU Anzahl der Übertragungseinheiten (number of transfer units); NTU_i=kA/ _i - P dimensionslose Temperaturänderung - R Wärmekapazitätsstromverhältnis;R ₁=₁/₂;R ₂=₂/₁ - relativer Fehler - Mittelwert von NTU₁ und NTU₂ Indizes 1, 2 Stoffstrom 1, 2 - G Gegenstrom - s Schätzwert Herrn Prof. Dr.-Ing. E.h. K. Stephan zum 65. Geburtstag gewidmet.     

A stable Nyström interpolant for some Mellin convolution equations

We consider the numerical solution of second kind integral equations of the form $$u(y) - \int\limits_0^1 {k(y/x)\frac{{u(x)}}{x}dx = f(y), 0 \le y \le 1,} $$ for some given kernelk(t). These equations, usually indicated as of Mellin type, arise in a variety of applications. In particular, we examine a Nyström interpolant based on the following product quadrature rule: $$\int\limits_0^1 {k(y/x)\frac{{u(x)}}{x}dx \approx \sum\limits_{i = 0}^n {w_{ni} (y)u(x_{mi} ).} } $$ This rule is obtained by interpolatingu(x) by the Lagrange polynomial associated with the set of Gauss-Radau nodes {x _ni}. Under certain assumptions on the kernelk(t), we are able to prove the stability of our interpolant and derive convergence estimates.     

Lelong numbers of positive plurisubharmonic currents

A (k,k)-current T on an open subset of C^N is plurisubharmonic if is positive. Positive plurisubharmonic currents admit Lelong numbers; we prove here that they are independent on the coordinates system. Moreover, if Y is an analytic subset of pure dimension, then the Lelong numbers of T on Y are given by a non negative weakly plurisubharmonic function.