Indirect Determination of Sulfide by Cold Vapor Atomic Absorption Spectrometry

A method for the determination of sulfide based on its interference with the determination of Hg by cold vapor atomic absorption spectrometry is described. The decrease in mercury absorbance at 253.7nm is proportional to the concentration of sulfide over the range of 10–320ngmL^–1. The limit of detection was found to be 7ngmL^–1 and the relative standard deviation (R.S.D.) for the determination of different concentrations of sulfide was in the range of 1.8–2.2%. This method was applied to the determination of sulfide in whole human blood after gas-phase separation.     

Synthesis and properties of novel fluoroalkyl end‐capped oligomers having adamantane units in the main chains via a radical process

Fluoroalkanoyl peroxides were reacted with adamantane in the presence of radical polymerizable monomers such as acrylic acid, acryloylmorpholine, and N,N‐dimethylacrylamide to afford fluoroalkyl end‐capped oligomers having adamantane units in the main chains via a radical process under very mild conditions. Thermal stability of these new fluorinated adamantane co‐oligomers thus obtained became higher than that of the corresponding fluorinated homo‐oligomers having no adamantane units. Interestingly, these fluorinated adamantane co‐oligomers exhibited good solubility in traditional organic solvents such as methanol, ethanol, tetrahydrofuran, chloroform, benzene, dimethylsulfoxide and N,N‐dimethylformamide including water, although the parent adamantane exhibited no solubility in water, methanol and dimethylsulfoxide. Furthermore, these adamantane co‐oligomers were able to reduce the surface tension effectively to form the nanometer size‐controlled self‐assembled fluorinated molecular aggregates. Copyright © 2005 John Wiley & Sons, Ltd.     

Low-temperature electrothermal vaporization of thenoyltrifluoroacetone complex of Sc(III) and Y(III) for sample introduction in an inductively coupled plasma atomic emission spectrometry,and their determination in biological samples

A new method for inductively coupled plasma atomic emission spectrometry (ICP-AES) determination of trace Sc and Y, based on gaseous compound introduction into the plasma as their thenoyltrifluoroacetone (TTA) complexes by electrothermal vaporization was developed. Using the reagent TTA as chemical modifier can not only enhance the analytical signals, but also reduce the vaporization temperature. At a temperature of 1,000 °C the trace Sc and Y can be vaporized completely into ICP. The factors affecting the formation of the chelate and its vaporization behavior, such as drying time, vaporization temperature/time, reaction medium and the amount of TTA, were investigated in detail. Under the optimized conditions (drying temperature/time 100 °C/10 s, vaporization temperature/time 1,000 °C/4 s), the limits of detection for Sc and Y were 19 pg and 34 pg (3), respectively, and the relative standard deviations for Sc and Y were 4.2% (c _Sc=0.2 g mL^–1; n=7) and 2.6% (c _Y=0.5 g mL^–1; n=7). The linear ranges of the calibration graphs cover three orders of magnitude. The method was applied to the analysis of the biological reference materials (GBW 07602, bush branches and leaves; GBW 07604, poplar leaves), and the results obtained were in good agreement with the certified values.     

Microcalorimetry as a possible tool for phenanthrene toxicity evaluation to eukaryotic cells

Microcalorimetry and measurement of culture turbidity using a Bioscreen C Analyzer System were applied to study the toxic effect of phenanthrene on Cunninghamella elegans IM 1785/21Gp spore germination. The results of C. elegans spore incubation in Bioscreen C microbiology reader showed the inhibition of spore germination by 70% (with 25 mg l⁻¹ of phenanthrene) and total inhibition of the fungus growth with a higher content of the xenobiotic (50-100 mg l⁻¹). The microcalorimetric technique showed to be useful for the estimation of metabolic activity of C. elegans spores in growth medium up to xenobiotic concentrations of 90 mg l⁻¹. These data corresponded with the microscopic observations. The obtained results showed that the microcalorimetry method could be a valuable supplement in the study on the mechanism of PAHs detoxification by fungi.     

R12 hydrate formation kinetics based on laser light scattering technique

Gas hydrates are non-stoichiometric crystalline compounds of water with gas at a certain temperature and pressure. Compared to the thermodynamics of hydrate formation, our knowledge on the kinetics aspect is rather immature. It is well known that the kinetics of hydrate formation/dissociation plays an important role in many industrial cases, such as the exploitation of methane hydrate underground, the storage and transportation of natural gas in solid hydrate state, the inhibition of hydrate i…     

Improving MCM‐41 as a Nitrosamines Trap through a One‐Pot Synthesis

Copper oxide was incorporated into MCM‐41 by a one‐pot synthesis under acidic conditions to prepare a new mesoporous nitrosamines trap for protection of the environment. The resulting composites were characterized by XRD, N₂ adsorption–desorption, and H₂ temperature‐programmed reduction techniques, and their adsorption capabilities were assessed in the gaseous adsorption of N‐nitrosopyrrolidine (NPYR). The adsorption isotherms were consistent with the Freundlich equation. The copper salt was deposited onto MCM‐41 during the evaporation stage and was fixed on the host in the calcination process that followed. MCM‐41 was able to capture NPYR in air below 373 K but not at 453 K. Loading of copper oxide on MCM‐41 greatly improved its adsorption capability at elevated temperatures. The influence of the incorporation of copper into MCM‐41 samples and the adsorption behavior of these samples are discussed in detail.     

Highly accurate gas chromatographic analysis of reference gases for use in vehicle emission measurements

 A highly accurate gas chromatographic analytical method has been developed for the determination of the composition of gas mixtures. It was tested using a reference gas as an example consisting of 3.5% of CO, 14% of CO₂, 0.2% of propane and residual N₂ intended for the use in vehicle emission measurements. The method is based on comparison measurements with samples of a calibration gas, whose composition is iteratively adapted to that of the sample investigated using a gravimetric gas mixing method. For the gas chromatographic measurement, a molecular sieve column and a polymer column are used in parallel and in isothermal operation. All gas components can be determined by a single gas chromatographic measurement, and the relative uncertainty of measurement achievable is ?0.4%. Received: 6 March 1996/Revised: 30 May 1996/Accepted: 6 June 1996     

γ-irradiation of polypropylene in vacuum and in air

Polypropylene films were irradiated with ⁶⁰Co γ-rays in vacuum or in air and stored in air. Just after irradiation, the concentration of carbonyl group of the sample irradiated in air only increased with dose. The concentrations of both samples increased with storage time. The more the absorbed doses, the higher the increasing rates. The increasing rate of the concentration of carbonyl group during irradiation in air was higher than those during storage in air. Just after irradiation, the tensile strengths and the elongations of the both samples somewhat increased with dose at the doses less than 5 Mrad, but decreased at doses more than 13 Mrad. The tensile strength and the elongation of the sample irradiated in air decreased with storage time. Those of the sample irradiated in vacuum also decreased with storage time but the decreasing rates were much smaller than those in the sample irradiated in air. The gel fractions of the samples irradiated in vacuum and annealed in vacuum were somewhat higher than those irradiated in vacuum and not annealed. To elucidate high oxidation rate in the sample irradiated in air during and after irradiation, reaction mechanisms were discussed. To clarify the difference of mechanical properties between the samples irradiated in vacuum and in air, the effect of crosslink was considered, together with the oxidation.     

Effects of nonionic sugar surfactants on the phase transition of DPPC membranes

The influence of newly synthesized N-alkanoyl-N-methyllactitolamines (decanoyl [C₁₀MELA], lauoroyl [C₁₂MELA] and miristoyl [C₁₄MELA]) on the thermotropic phase transition of phosphatidylcholine bilayer was compared with common sugar-based surfactants N-dodecyl-β-d-glucopyranoside [C12G1] and decanoyl-N-methyl glucamide [MEGA-10]. The results indicate that C_nMELA are very active at the membrane surface and disturb the phospholipid bilayer structure less than commercially used MEGA-10 and C12G1.     

Flow injection analysis: Rayleigh light scattering technique for total protein determination

A novel flow injection analysis (FIA) method with Rayleigh light scattering (RLS) detection was developed for the determination of total protein concentrations. This method is based on the weak intensity of RLS of bromothymol blue (BB) (3',3"-dibromothymolsulfonephthalein) which can be enhanced by the addition of protein in weakly acidic solution. A common spectrofluorimeter was used as a detector. It was proved that the application of this method to quantify the total proteins in real samples by using bovine serum albumin was possible. The RLS signal was detected at lambda(ex)= lambda(em)=572 nm. The linear range was 7.0-70.0 microg mL(-1), the detection limit was 3.75 microg mL(-1), the reproducibility was 5.5% (n=7), and the sample throughput was 26 h(-1).