Miscibility of bisphenol-A polycarbonate with poly(methyl methacrylate)

The miscibility of bisphenol-A polycarbonate (PC) with poly(methyl methacrylate) (PMMA) has been reexamined using differential scanning calorimetry (DSC) and optical indications for phase separation on heating, i.e., lower critical solution temperature (LCST) behavior. Various methods have been used to prepare the blends including methylene chloride (CH₂Cl₂) and tetrahydrofuran (THF) solution casting, melt mixing, and precipitation of PC and PMMA simultaneously from THF solution by using the nonsolvents methanol and heptane. It is shown that the resulting phase behavior for PC/PMMA blends is strongly affected by the blend preparation method. However, these blends are miscible over the whole blend composition range (unambiguous single composition-dependent T_g's and LCST behavior) when prepared by precipitation from solution using heptane as the nonsolvent. To the contrary, solution-cast and melt-mixed PC/PMMA blends were all phase separated, which may be attributed to the “solvent” effect and LCST behavior, respectively, not discovered in previous reports. Methanol precipitation does not lead to fully mixed blends, which demonstrates the importance of the choice of nonsolvent when using the precipitation method.     

Conformational analysis of dipeptide‐derived polyisocyanides

The conformational properties of polymers derived from isocyanodipeptides have been investigated with a combination of model calculations, X‐ray diffraction, and circular dichroism spectroscopy. Depending on the configuration of the side chains, defined arrays of hydrogen bonds along the polymeric backbone are formed. This leads to a well‐defined conformation as, for example, expressed in the formation of lyotropic liquid‐crystalline phases and increased helical stability. Upon the disruption of the hydrogen bonds by a strong acid, a less well‐defined macromolecular conformation is observed. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 1725–1736, 2003     

Analysis of tunable diode-laser spectra of Q(J,0) lines in CH3F near 1475 cm using a multispectrum fitting technique

We have analyzed the methyl fluoride ^RQ(J,0)Q branch lines located near 1475 cm⁻¹ using a simultaneous multi-spectrum fitting technique. In this analysis we have used previously recorded diode-laser data in which we collected many data points covering only one or two Q branch lines in a particular run. The analysis consists of simultaneously fitting 57 spectra collected with numerous pressure and path length conditions for all absorption lines. The data are concatenated to create one continuous spectrum of the Q branch. We have determined the intensity and self-broadened widths at 296 K for 23 ^RQ(J,0) lines.     

Investigation of organic impurities adsorbed on and incorporated into electroplated copper layers

At room temperature electroplated copper layers exhibit changes in resistivity, residual stress, and microstructure. This process, known as self-annealing, is intimately linked to the release of organic impurities, which stem from the incorporation of organic additives into the Cu layer in the course of the electroplating process. The behavior of these impurities during self-annealing, represented by the carbon content, could be detected by analytical radio frequency glow discharge optical emission spectrometry (GD-OES) and carrier gas hot extraction (CGHE). The precondition of a quantitative determination is a surface cleaning procedure to remove adsorbed organics from the copper surface. It was observed that at first almost all impurities have to leave the Cu metallization before an accelerated abnormal grain growth can start. The small amount of remaining organic species after self-annealing could be quantified by both examination techniques, GD-OES and CGHE.     

Ein Verfahren zur Trennung des Zinks von allen Metallen seiner Gruppe

Ohne Zusammenfassung     

Asymptotic Analysis of the Current-Voltage Curve of a pnpn Semiconductor Device

We consider the one-dimensional steady-state semiconductor deviceequations modelling a pnpn device. There are two relevant scalingsof the equations corresponding to small and large applied voltages.In both scalings, the semiconductor equations can be consideredas singularly perturbed. It turns out that the small-voltagescaling breaks down for current values between two saturationcurrents. In that interval, the large-voltage scaling has tobe employed. For both scalings, we derive the first-order termsof an asymptotic expansion and show that the reduced problemhas a solution. An example verifies that the current-voltagecurves obtained have the expected qualitative structure.     

Bulk and microprobe analysis for trace elements with synchrotron radiation

Blood serum samples were irradiated by monochromatic synchrotron radiation (15 keV) and by 2.4-MeV protons to compare their performance for the detection of trace elements by x-ray fluorescence (XRF) spectrometry. Absolute concentration assignment was based on the addition of an internal standard and on a method which uses the incoherent and coherent radiation as a flux monitor of the incoming beam. Preliminary experiments with a synchrotron XRF microprobe are reported.     

Representations of Positive Projections II

In this paper we obtain a number of Maharam-type slice integral representations, with respect to scalar measures, for positive projections in Dedekind complete vector lattices and f-algebras. AMS Classification: 47B65, 46A40, 06F25