Electronic, epr and magnetic studies of Co(II), Ni(II) and Cu(II) complexes with thiosemicarbazone (L1) and semicarbazone (L2) derived from pyrole-2-carboxyaldehyde

Co(II), Ni(II) and Cu(II) complexes are synthesized with thiosemicarbazone (L(1)) and semicarbazone (L(2)) derived from pyrole-2-carboxyaldehyde. These complexes are characterized by elemental analysis, molar conductance, magnetic susceptibility measurements, mass, IR, electronic and EPR spectral studies .The molar conductance measurements of the complexes in DMSO correspond to non-electrolytic nature except Co(L1)2(NO3)2 and Ni(L1)2(NO3)2 complexes which are 1:2 electrolytes. All the complexes are of high-spin type. On the basis of spectral studies an octahedral geometry may be assigned for Co(II) and Ni(II) complexes except Co(L1)2(NO3)2 and Ni(L1)2(NO3)2 which are of tetrahedral geometry. A tetragonal geometry may be suggested for Cu(II) complexes.     

Spectroscopic study of association of a hemicyanine dye in mixed aqueous binary solvents

Electronic absorption and steady state emission properties of a hemicyanine dye [4-[4-(dimethylamino)styryl]-1-docosylpyridinium bromide], have been studied in several pure solvents and two mixed binary solvents (water+ethanol and water+acetonitrile). In pure solvents the band-width of the absorption spectrum correlates well with the Stoke's shift. In mixed aqueous solvents two different molecular forms of the solute, viz. the monomer and the dimer of the solute exists in equilibrium. Thermodynamic parameters (e.g. the Delta G degrees and Delta H degrees ) characterizing the equilibrium have been determined. While the value of Delta G degrees changes very slightly with the composition of the binary mixture, the value of Delta H degrees has been observed to depend significantly with solvent composition.     

Validated Chiral LC Method for the Enantiomeric Separation of β-Amino-β-(3-Methoxyphenyl) Propionic Acid

A chiral liquid chromatographic method for enantiomeric resolution of β-amino-β-(3-methoxyphenyl) propionic acid was developed and validated. The “hybrid” π-electron donor–acceptor based stationary phase (R,R) Whelk-01 was found to be enantiomerically selective for (R) and (S) enantiomers of β-amino-β-(3-methoxyphenyl) propionic acid with a resolution greater than 2.0. The effects of isopropyl alcohol and ethanol on enantioselectivity and resolution of enantiomers were evaluated. Calibration curves were linear over the range of 0.10–1.00, with a regression coefficient (r) of 0.999. The limit of detection (LOD) and limit of quantification (LOQ) were 300 and 1,000 ng mL⁻¹ respectively for 10 μL injection volume. The percentage RSD of the peak area of six replicate injections of (S) enantiomer at LOQ concentration was 2.8. The percentage recovery of (S) enantiomer from (R) enantiomer samples ranged from 92 to 102. The test solution was observed to be stable up to 24 h after the preparation. The developed normal phase chiral LC method can be used for the enantiomeric purity evaluation of R-β-amino-β-(3-methoxyphenyl) propionic acid.     

NMR spectroscopic study of the inclusion complex of desloratadine with β-cyclodextrin in solution

Desloratadine (DES) is an antihistamine used in the treatment of allergies and chronic urticaria. ¹H NMR spectroscopic study of varying ratios of DES and β-Cyclodextrin (β-CD) in D₂O suggests the formation of a 1:1 inclusion complex formed by the penetration of Cl-substituted aromatic ring into the β-CD cavity. The stoichiometry and binding constant of the complex were determined by Scott’s method.     

Novel solid-phase extraction and preconcentration technique coupled with ICP-AES for the determination of Cr(III), Ni(II), and Zn(II) in various water samples

Newly synthesized 2-propylpiperidine-1-carbodithioate (2-PPC) was used for the extraction of Cr(III), Ni(II), and Zn(II) from various water samples. In the present investigation, the use of a syringe loaded with sorbent for the separation and enrichment of Cr(III), Ni(II), and Zn(II) prior to their determination by inductively coupled plasma-atomic emission spectrometry (ICP-AES) was proposed to substitute the batch and column techniques. The described method was compared with the column technique with respect to fastness, simplicity, recovery, and risk of contamination. The syringe was loaded with 1.0 g of sorbent in order to retain the analyte elements. Next, 7.0 mL of sample solution (pH 5.0 ± 0.2) was drawn into the syringe in 15 s and discharged over 15 s. Then, an eluent (3.0 M HCl) was drawn into the syringe and ejected back to desorb the analyte elements. At the optimum conditions, the percentage recoveries of Cr(III), Ni(II), and Zn(II) were in the range of 94.50 to 99.62% with a standard deviation (S.D.) of 0.03%. The elements could be concentrated by drawing and discharging several portions of sample successively and eluting only one time. The detailed study of various interferences proved the method to be highly selective. The risk of contamination is less than that with the column technique. The method was successfully applied to the determination of Cr(III), Ni(II), and Zn(II) in spiked and natural water samples. The results obtained are in good agreement with those obtained by the reported methods at the 95% confidence level. The text was submitted by the authors in English.     

Electrocatalytic activity of binary Palladium Ruthenium anode catalyst on Ni-support for ethanol alkaline fuel cells

In search for a cheaper anode catalyst for the oxidation of ethanol for development of direct alcohol fuel cells, Pd has been considered here as an interesting substitute for Pt in Pt Ru binary electrodeposite. The binary catalyst when co-deposited on nickel support has been found to increase the current density and decrease the anodic overvoltage significantly with respect to pure Pt, Pd and Ni. Its electrocatalytic capability is also comparable with that of the Pt-Ru binary electrocatalyst on Ni-support, when studied in 1 M EtOH containing 1 M NaOH solution. The effect of loading of Pd Ru electrocatalyst on Ni support has also been tested. The electrocatalytic activity of the electrodes for oxidation of ethanol has been explained by studies of cyclic voltammetry, chronopotentiometry, steady-state polarization, and conjugated scanning electron microscopy–energy dispersion X-ray spectroscopy. It has been found that electrode containing the higher amount of deposit are less affected by carbonaceous poisons.     

A water soluble nanostructured platinum (0) metal catalyst from platinum carbonyl molecular clusters: Synthesis, characterization and application in the selective hydrogenations of olefins, ketones and aldehydes

High nuclearity platinum carbonyl cluster anions (Chini's clusters) have been used as precursors to prepare a platinum nanocatalyst. The ionic polyelectrolyte poly(diallyldimethylammonium chloride) has been used as the support material for anchoring [Pt₃₀(CO)₆₀]²⁻ via ion-pairing and subsequent stabilization of the nanoparticles. The polymer-supported material has been studied by spectroscopy (NIR, ¹³C NMR, and IR) and TEM before and after its use as a water soluble hydrogenation catalyst. The nanocatalyst is found to be effective for the chemoselective hydrogenation of olefinic, aldehydic and ketonic double bonds. For most of the substrates isolation of the product and reuse of the catalyst are extremely easy due to the automatic phase separation of the products from the catalyst. The spectral features of the fresh catalyst show retention of the carbonyl ligands and molecular identity of the parent cluster, but after use the carbonyl ligands appear to be lost. TEM of the supported material before and after use as a catalyst shows the presence of platinum nanoparticles with majority (≥70%) of the particles in the range of 2–6 nm. Smaller particles are dominant in the used catalyst and this observation is rationalized on the basis of the known reactivity of Chini's clusters with dihydrogen.     

Determination of rhodium in water samples using cloud point extraction (CPE) coupled with flame atomic absorption spectrometry (FAAS)

Cloud point extraction was applied as a method for preconcentration of rhodium after formation of a complex with 2-propylpiperidine-1-carbodithioate (2-PPC), and later determined by flame atomic absorption spectrometry using TritonX-114 as surfactant. Rhodium was complexed with 2-PPC in an aqueous phase and kept for 15 min in a thermostatted bath at 40 °C. Separation of the two phases was accomplished by centrifugation for 15 min at 4000 rpm. The chemical variables affecting the cloud point extraction were optimized and successfully applied to rhodium determination in various water samples. Under optimized conditions, the preconcentration system (100 mL sample) permitted an enhancement factor of 50. The detection limits obtained under optimal conditions was 0.052 ng mL⁻¹. The extraction efficiency was investigated at different rhodium concentrations (7.0–42.0 μg mL⁻¹), and good recoveries (96.42–99.14%) were obtained using this method. It has been applied to the determination of rhodium in water and was compared with reported methods in terms of Student’s ‘t’-test and variance ratio ‘f’-test.