A comparison of the absolute reactivity of vinyl monomers. I. Kinetic studies on radical polymerization of vinyl monomers initiated by a Mn3+–diglycolic acid redox system

The kinetics of polymerization of acrylamide (AM), acrylic acid (AA), and acrylonitrile (AN) initiated by the redox system Mn³⁺–diglycolic acid (DGA) was studied. All three systems followed the same mechanism; namely, initiation by an organic free radical arising from the oxidation of diglycolic acid and termination by the interaction of polymer radicals with Mn³⁺ ion. The rate coefficients k_i/k₀ and k_p/k_t were related to monomer and polymer radical reactivity, respectively. An inverse relation between monomer and polymer radical reactivity was observed. Monomers with higher Q values gave higher k_i/k₀ values but lower k_p/k_t values. The e values of the monomers were important in determining the reactivities of monomers with nearly the same Q values.     

Enthalpic and entropic stages in alpha-helical peptide unfolding, from laser T-jump/UV Raman spectroscopy

The alpha-helix is a ubiquitous structural element in proteins, and a number of studies have addressed the mechanism of helix formation and melting in simple peptides. However, fundamental issues remain to be resolved, particularly the temperature (T) dependence of the rate. In this work, we report application of a novel kHz repetition rate solid-state tunable NIR (pump) and deep UV Raman (probe) laser system to study the dynamics of helix unfolding in Ac-GSPEA3KA4KA4-CO-D-Arg-CONH2, a peptide designed for helix stabilization in aqueous solution. Its T-dependent UV resonance Raman (UVRR) spectra, excited at 197 nm for optimal enhancement of amide vibrations, were decomposed into variable contributions from helix and coil spectra. The helix fractions derived from the UVRR spectra and from far UV CD spectra were coincident at low T but deviated increasingly at high T, the UVRR curve giving higher helix content. This difference is consistent with the greater sensitivity of UVRR spectra to local conformation than CD. After a laser-induced T-jump, the UVRR-determined helix fractions defined monoexponential decays, with time-constants of approximately 120 ns, independent of the final T (Tf = 18-61 degrees C), provided the initial T (Ti) was held constant (6 degrees C). However, there was also a prompt loss of helicity, whose amplitude increased with increasing Tf, thereby defining an initial enthalpic phase, distinct from the subsequent entropic phase. These phases are attributed to disruption of H-bonds followed by reorientation of peptide links, as the chain is extended. When Ti was raised in parallel with Tf (10 degrees C T-jumps), the prompt phase merged into an accelerating slow phase, an effect attributable to the shifting distribution of initial helix lengths. Even greater acceleration with rising Ti has been reported in T-jump experiments monitored by IR and fluorescence spectroscopies. This difference is attributable to the longer range character of these probes, whose responses are therefore more strongly weighted toward the H-bond-breaking enthalpic process.     

Alkaline degradation of the organophosphorus pesticide fenitrothion as mediated by cationic C12, C14, C16, and C18 surfactants

The effect of varying surfactant chain length (C12, C14, C16, C18) on the alkaline hydrolysis of the organophosphorus pesticide fenitrothion was determined for the following series of inert counterion cationic surfactants: dodecyltrimethylammonium bromide (DTABr), tetradecyltrimethylammonium bromide (TTABr), hexadecyltrimethylammonium bromide (CTABr), and octadecyltrimethylammonium bromide (OTABr). Plots of kobs versus [surfactant] at constant [KOH] showed saturation behavior at low total [Br-], and (constrained) S-shaped curvature was observed at high total [Br-]. kobs values increased with increasing surfactant chain length but decreased with added KBr. For systems exhibiting saturation behavior, further analysis of the results using the PPIE treatment as modified to account for HO-/Br- exchange allowed the evaluation of substrate binding constants, KS, and micellar rate constants, k2m. The binding constants increased with chain length (hydrophobicity), but ionic strength had no effect on KS. Meanwhile, because of the increased KS values as the surfactant chain length increased, the rate enhancements observed for fenitrothion degradation correspondingly increased. However, rate enhancements decreased with ionic strength because reactive counterions could not compete against the bromide anion for micellar binding sites. Low k2m/k2w ratios revealed that the observed rate enhancements were due to the so-called concentration effect rather than true catalysis. Finally, where the PPIE model failed (displaying S-shaped curvature), our results support the intervention of sphere-to-rod transitions that are favored at high ionic strength (>0.01 M Br-) and lower temperatures as the cause of the S-shaped curvature.     

Fabrication of interdigitated high-performance zinc oxide nanowire modified electrodes for glucose sensing

Diabetes is a metabolic disease with a prolonged elevated level of glucose in the blood leads to long-term complications and increases the chances for cardiovascular diseases. The present study describes the fabrication of a ZnO nanowire (NW)-modified interdigitated electrode (IDE) to monitor the level of blood glucose. A silver IDE was generated by wet etching-assisted conventional lithography, with a gap between adjacent electrodes of 98.80 μm. The ZnO-based thin films and NWs were amended by sol–gel and hydrothermal routes. High-quality crystalline and c-axis orientated ZnO thin films were observed by XRD analyses. The ZnO thin film was annealed for 1, 3 and 5 h, yielding a good-quality crystallite with sizes of 50, 100 and 110 nm, and the band gaps were measured as 3.26, 3.20 and 3.17 eV, respectively. Furthermore, a flower-modeled NW was obtained with the lowest diameter of 21 nm. Our designed ZnO NW-modified IDE was shown to have a detection limit as low as 0.03 mg/dL (correlation coefficient = 0.98952) of glucose with a low response time of 3 s, perform better than commercial glucose meter, suitable to instantly monitor the glucose level of diabetes patients. This study demonstrated the high performance of NW-mediated IDEs for glucose sensing as alternative to current glucose sensors.     

SERS of 7-azaindole adsorbed on Ag doped sol–gel film and Ag sol: a comparative investigation

Surface enhanced Raman scattering (SERS) studies have been undertaken on Ag doped sol–gel derived film with 7-azaindole (7-AI) used as the reference compound. The enhancement factor in the film is comparable with the result of the chloride aggregated silver citrate sol. Along with the spectral observation and assignments of the frequencies, the significance of colloidal sol–gel film in which the size of the metal is in the dimensions of nanometers have been discussed.     

Effect of side-chain substituents on self-assembly of perylene diimide molecules: morphology control

Effect of side-chain substitutions on the morphology of self-assembly of perylene diimide molecules has been studied with two derivatives modified with distinctly different side-chains, N,N'-di(dodecyl)-perylene-3,4,9,10-tetracarboxylic diimide (DD-PTCDI) and N,N'-di(nonyldecyl)-perylene-3,4,9,10-tetracarboxylic diimide (ND-PTCDI). Due to the different side-chain interference, the self-assembly of the two molecules results in totally different morphologies in aggregate: one-dimensional (1D) nanobelt vs zero-dimensional (0D) nanoparticle. The size, shape, and topography of the self-assemblies were extensively characterized by a variety of microscopies including SEM, TEM, AFM, and fluorescence microscopy. The distinct morphologies of self-assembly have been obtained from both the solution-based processing and surface-supported solvent-vapor annealing. The nanobelts of DD-PTCDI fabricated in solution can feasibly be transferred to both polar (e.g., glass) and nonpolar (e.g., carbon) surfaces, implying the high stability of the molecular assembly (due to the strong pi-pi stacking). The side-chain-dependent molecular interaction was comparatively investigated using various spectrometries including UV-vis absorption, fluorescence, X-ray diffraction, and differential scanning calorimetry. Compared to the emission of ND-PTCDI aggregate, the emission of DD-PTCDI aggregate was significantly red-shifted (ca. 30 nm) and the emission quantum yield decreased about three times, primarily due to the more favorable molecular stacking for DD-PTCID. Moreover, the aggregate of DD-PTCDI shows a pronounced absorption band at the longer wavelength, whereas the absorption of ND-PTCDI aggregate is not significant in the same wavelength region. These optical spectral observations are reminiscent of the previous theoretical investigation on the side-chain-modulated electronic properties of PTCDI assembly.     

On the Derivative Counting Processes of First- and Second-order Aggregated Semi-Markov Systems

Methodology and Computing in Applied Probability - In this paper, first- and second-order discrete-time semi-Markov systems are considered with their finite state space divided into three subsets...     

Structural and electronic properties of polyyne and cumulene chains with phenylene as central aromatic group: a density functional theory study

Structural Chemistry - The present work studies effects of the introduction of phenylene group as the central aromatic group on the structural and electronic properties of polyyne (Pol-[HCN]2Ph)...     

Kinetics of polymerization of vinyl monomers initiated by lead tetraacetate

A systematic study of the thermal polymerization of α-chloroacrylic acid and α-bromoacrylic acid in aqueous nitric acid was carried out. The effect of variation of monomer concentration lead tetraacetate concentration, hydrogen ion concentration, ionic strength, and temperature on the rate of monomer disappearance was carried out. Based on the experimental observations, suitable reaction schemes were proposed for the polymerization of the above monomers. The rate constants and the thermodynamic parameters were evaluated.