An automated FTIR method for the routine quantitative determination of moisture in lubricants: An alternative to Karl Fischer titration

An accurate primary Fourier transform infrared (FTIR) method for the determination of moisture in mineral and ester based lubricants has been developed based on the extraction of moisture into dry acetonitrile. FTIR evaluation of acetonitrile extracts from new and used lubricants as well as common lubricant additives and contaminants which might co-extract indicated that phenolic constituents interfered significantly with moisture measurements. By measuring moisture at 3676 cm⁻¹ on the shoulder of the asymmetric OH stretching band, spectral interferences from extracted phenolic constituents were minimized. The spectra of calibration standards (0-2100 ppm), prepared by gravimetric addition of water to dry acetonitrile, were recorded in a 1000-μm CaF₂ transmission flow cell and produced linear standard curves having an S.D. of ∼±20 ppm. Lubricant sample preparation involved the vigorous shaking (20 min) of a 1:1.5 (w/v) mixture of lubricant and dry acetonitrile, centrifugation to separate the phases, acquisition of the FTIR spectrum of the upper acetonitrile layer, and subtraction of the spectrum of the dry acetonitrile used for extraction. A Continuous Oil Analyzer and Treatment (COAT^®) FTIR system was programmed to allow the automated analysis of acetonitrile extracts, and the methodology was validated by analyzing 58 new and used oils, independently analyzed by the Karl Fischer (KF) method. Linear regression of FTIR versus KF results for these oils produced a linear plot with a between-method S.D. of ±80 ppm. As implemented on the COAT^® system, this FTIR method is capable of analyzing 72 acetonitrile extracts/h and provides a high-speed alternative to the KF titrimetric procedures for the determination of water in lubricants.     

Factors controlling the regioselectivity of additions to α-enones—III: Reactions of 3-aryl α-enones with phosphorylated anions

Reaction of phosphonoester 2 and phosphononitrile 3 with chalcone and p-methoxychaleone in THF-t-BuOK at room temperature gives only the product resulting from CC double bond attack. The same reagents with benzalacetone lead to mixture of products resulting from CC double bond and carbonyl attack, though phosphine oxide 4 gives only the products of CC attack. Dypnone gives products of carbonyl attack with 3 and does not react with 2.These results are discussed in terms of perturbation theory: C₄ attack increases with delocalization of the reagent's negative charge and lowering of the α-enone LUMO level.     

Stereochimie de l'hydrogenation des (±) Δ3(3a)-hydrindenones-4. Comparaison avec le cas de la (+) methyl-3 Δ3(3a)-hydrindenone-4 et de ses dioxolannes

We show that the four studied 4-hydrindenones (with or without a methyl substituant at C3 or C7a) give by hydrogenation on Raney nickel or on Pd/C, in various solvants, the cis 4-hydrindanones, by a kinetically controlled process. During the hydrogenation, the double bond can migrate only in the positions conjugated to the carbonyl group.In contrast, when the carbonyle is protected as a dioxolanne, the double bond is free to migrate around the five membered ring. In spite of this mobility the optical purity of the saturated dioxolannes formed is high. In the case of the (+)3-methyl Δ^3(3a) 4-hydrindenone, the enantiomeric hydrindanones $\text{9a}$ obtained by direct hydrogenation or with isomerization of the double bond are not the same. Therefore, the optical purity of the product is low, but its value allows an estimation of the relative importance of the two reaction pathways.     

Comparative analysis by gas chromatography-mass spectrometry of the essential oils from bark and leaves of Cedrelopsis grevei Baill, an aromatic and medicinal plant from Madagascar

The essential oils from bark and leaves of Cedrelopsis grevei Baill (Ptaeroxylaceae), an aromatic and medicinal plant from Madagascar, are widely used in folk medicine. These two commercially available oils have been examined separately by means of GC-MS. The oil constituents were identified according to their mass spectra and their relative retention indices determined on both polar and non-polar stationary phase capillary columns. A total of 55 compounds have been identified constituting 76.7% (bark) and 91.6% (leaves) of the volatile constituents. Both oils were found to have a similar composition; however the relative percentages of some compounds notably differed. The bark essential oil contained beta-pinene (17.1%), cis-sesquisabinene hydrate (12.8%) and caryophyllene oxide (7.0%) as the main components whereas the leaf essential oil was largely dominated by trans-beta-farnesene (35.6%); beta-pinene (12.8%), cis-sesquisabinene hydrate (9.8%) and ar-curcumene (8.6%) were also present as major components. As far as we know, this is the first report on the Cedrelopsis grevei bark and leaf essential oils which therapeutic properties may be attractive for aromatherapy.     

Self-assembly of phosphate fluorosurfactants in carbon dioxide

Anionic phosphodiester surfactants, possessing either two fluorinated chains (F/F) or one hydrocarbon chain and one fluorinated chain (H/F), were synthesized and evaluated for solubility and self-assembly in liquid and supercritical carbon dioxide. Several surfactants, of both F/F and H/F types and having varied counterions, were found to be capable of solubilizing water-in-CO2 (W/C), via the formation of microemulsions, expanding upon the family of phosphate fluorosurfactants already found to stabilize W/C microemulsions. Small-angle neutron scatteringwas used to directly characterize the microemulsion particles at varied temperatures, pressures, and water loadings, revealing behavior consistent with previous results on W/C microemulsions.     

A host-guest complex between a metal-organic cyclotriveratrylene analog and a polyoxometalate: [Cu6(4,7-phenanthroline)8(MeCN)4]2PM12O40(M = Mo or W)

The synthesis and crystal structure of Cu(6)(4,7-phenanthroline)(8)(MeCN)(4)(6+) a novel Cu(i)-molecular hexamer is described in which the metal cations and phenanthroline molecules self-assemble into a dimer of shallow triangular-shaped bowls, within which are located large spherical polyoxometalate anions PM(12)O(40)(3-)(M = Mo or W).     

Emulsion copolymerization of styrene and methyl methacrylate. II. Molecular weights

A mathematical model for the time evolution of both number-average molecular weight and weight-average molecular weight is described. The model results in a set of ordinary differential equations and its application is not limited by the maximum number of radicals per particle. The model was used to analyze the effect of the monomer molar ratio in the initial charge on the weight-average molecular weight during the emulsion copolymerization of styrene and methyl methacrylate in a batch reactor.