Quasi-distributed displacement sensor for structural monitoring using a commercial OTDR

A quasi-distributed displacement sensor for structural monitoring using an optical time domain reflectometer is demonstrated. Four displacement sensing heads are placed along a standard single mode optical fibre in several locations with different intervals. Their configurations introduce power loss through the decrease of their fibre loop radius when displacement is applied. The decrease of the light intensity with displacement variation is reported. Losses of 9 dB for a 120 mm displacement with a sensitivity of 0.027 dB/mm are reported. The quasi-distributed configuration is able to address sensors with 1 m distance resolution between them.     

Self-injection length in La0.7Ca0.3MnO3-YBa2Cu3O7-δ ferromagnet-superconductor multilayer thin films

We have carried out extensive studies on the self-injection problem in barrierless heterojunctions between La_0.7Ca_0.3MnO₃ (LCMO) and YBa₂Cu₃O_7-δ (YBCO) thin films. The heterojunctions were formed in situ by sequentially growing LCMO and YBCO films on 〈100〉 LaAlO₃ (LAO) substrate using a pulsed laser deposition (PLD) system. YBCO micro-bridges with 64 μm width were patterned both on the LAO (control) and LCMO side of the substrate. Critical current, I _c, was measured at 77 K on both the control side as well as the LCMO side for different YBCO film thickness. It was observed that while the control side showed a J _c of ∼ 2 × 10⁶ A/cm², the LCMO side showed about half the value for the same thickness (1800 ?). The difference in J _c indicates that a certain thickness of YBCO has become ‘effectively’ normal due to self-injection. From the measurement of J _c at two different thicknesses (1800 ? and 1500 ?) of YBCO films both on the LAO as well as the LCMO side, the value of self-injection length (at 77 K) was estimated to be ∼ 900 ?. To the authors’ best knowledge, this is the first time that self-injection length has been quantified. A control experiment carried out with LaNiO₃ deposited by PLD on YBCO did not show any evidence of self-injection.     

The microscopic investigation of structures of moving flux lines by neutron and muon techniques

We have used a variety of microscopic techniques to reveal the structure and motion of flux line arrangements, when the flux lines in low T _c type II superconductors are caused to move by a transport current. Using small-angle neutron scattering by the flux line lattice (FLL), we are able to demonstrate directly the alignment by motion of the nearest-neighbor FLL direction. This tends to be parallel to the direction of flux line motion, as had been suspected from two-dimensional simulations. We also see the destruction of the ordered FLL by plastic flow and the bending of flux lines. Another technique that our collaboration has employed is the direct measurement of flux line motion, using the ultra-high-resolution spectroscopy of the neutron spin-echo technique to observe the energy change of neutrons diffracted by moving flux lines. The muon spin rotation (μSR) technique gives the distribution of values of magnetic field within the FLL. We have recently succeeded in performing μSR measurements while the FLL is moving. Such measurements give complementary information about the local speed and orientation of the FLL motion. We conclude by discussing the possible application of this technique to thin film superconductors.     

Magneto-transport properties of La0.7Ca0.3MnO3/SrTiO3/La0.7Ce0.3MnO3 tunnel junction

Hole-doped rare-earth manganite La_0.7Ca_0.3MnO₃ and the electron-doped manganite La_0.7Ce_0.3MnO₃ both show a metal-insulator transition around 250 K associated with a ferromagnetic transition and colossal magnetoresistance. In an earlier publication we have reported the rectifying characteristic of La_0.7Ca_0.3MnO₃/SrTiO₃/La_0.7Ce_0.3MnO₃ tunnel junction at room temperature, showing that it is possible to fabricate a diode out of the polaronic insulator regime of doped manganites. Here we report the magneto-transport properties of such a tunnel junction above and below the metal-insulator transition. We show, from the large positive magnetoresistance of the tunnel junction at low temperature, that La_0.7Ce_0.3MnO₃ could be a minority spin carrier ferromagnet. The implication of this observation is discussed.     

The valence state of M-ions in the chemically stabilized YSr2Cu3-xMxO7+δ (M=Mo, W and Re) superconductors

 Single phase Ba-free Sr-based YSr₂Cu _3-x M _x O_7+δ (M=Mo, W and Re) compounds have been stabilized by chemical doping. Superconductivity is observed for these phases in the range 30–45 K. X-ray diffraction studies suggest a relatively small orthorhombicity compared to Ba-analogue. X-ray photoelectron spectroscopic investigations reveal that the stabilizing cations are in the hexavalent state. The observation of the higher oxidation state of M-ions accounts for the excess oxygen content in these phases which is in accordence with the diffraction results. Received: 10 June 1996 / Accepted: 20 September 1996     

Structure and morphology of laser-ablated WO3 thin films

The structure and surface morphology of WO₃ thin films deposited by a laser-ablation technique have been found to be strongly dependent on the deposition conditions and the nature of the substrate. By precisely controlling the substrate temperature and the oxygen partial pressure, amorphous, polycrystalline, nano-crystalline and iso-epitaxial WO₃ thin films were successfully grown. The structure and surface morphological features of the films from X-ray diffraction and atomic force microscopy data are described in relation to the deposition conditions. PACS 81.15.Fg; 68.55.-a; 68.37.Ps     

Effect of sulphur doping on manganese clusters: an ab initio study

We report a structural, electronic and magnetic analysis of minimal Mn_nS clusters, n = 1–13, from ab initio calculations. Total geometry optimizations were performed by considering compact manganese clusters, doped with a single sulphur atom. The doping was added to the cluster by considering substitution, interstitial and adsorbed positions. To further investigate the influence of the sulphur doping on the magnetic properties of manganese clusters, we performed non collinear magnetic calculations within the local spin density approximation (LSDA) for the exchange-correlation. We find that the electronic properties can be better controlled when the cluster is doped with a sulphur atom, and less size dependent. There are no differences in the magnetic properties of doped and non-doped clusters, except for n=7 and 8, in which the total magnetic moment per atom are smaller in doped clusters.     

Peak effect at microwave frequencies in swift heavy ion irradiated YBa2Cu3O7-δ thin films

The vortex dynamics at microwave frequencies in YBa₂Cu₃O_7-δ (YBCO) films have been studied. We observe a peak in the microwave (4.88 and 9.55 GHz) surface resistance in some films in magnetic fields up to 0.8 T. This is associated with the ‘peak-effect’ phenomenon and reflects the order-disorder transformation of the flux line lattice near the transition temperature. Introduction of artificial pinning centers like columnar defects created as a result of irradiation with 200 MeV Ag ion (at a fluence of 4×10¹⁰ ions/cm²) leads to the suppression of the peak in films previously exhibiting ‘peak effect’.