A new insight into suction and dilution effects in capillary electrophoresis coupled to mass spectrometry via an electrospray ionization interface. Part I-Suction effect

The hyphenation of CE with MS is nowadays accepted as a powerful analytical approach. Employing ESI, the most common interface, one challenge is to provide quantitative information, which is quite a difficult task, as it is linked, among other factors, to suction and dilution effects. In the coaxial ESI configuration, the suction effect has been presented in literature as stemming from nebulizing gas (NG) flow rate and drying gas temperature. But as this interface consists in three concentric capillaries, allowing for BGE, sheath liquid (SL) and NG mixing, it is demonstrated herein that other parameters are also involved in this suction effect: the CE capillary protrusion from the interface needle, SL flow rate, and overall BGE flow rate and velocity profile. Whereas NG flow rate is the parameter affecting suction to a greater extent, separation capillary protruding length, SL, and overall BGE flow rate have a significant additional impact on this phenomenon. It is shown that SL flow rate can affect suction differently according to the NG velocity, which may be explained by modification of the Taylor cone geometry. Furthermore, it appears that suction effect is noticeably favored by a parabolic velocity profile of the BGE, again probably due to the Taylor cone shape modification. Finally, the temperature gradient created by the contact between the heated NG and the separation capillary enhances this effect.     

Evidence of different stoichiometries for the limiting carbonate complexes across the lanthanide(III) series: a capillary electrophoresis-mass spectrometry study

The electrophoretic mobilities (mu ep,Ln) of twelve lanthanides (not Ce, Pr and Yb) were measured by CE-ICP-MS in 0.15 and 0.5 mol L(-1) Alk2 CO3 aqueous solutions for Alk+ = Li+, Na+, K+ and Cs+. In 0.5 mol L(-1) solutions, two different mu ep,Ln values were found for the light (La to Nd) and the heavy (Dy to Tm) lanthanides, which suggests two different stoichiometries for the carbonate limiting complexes. These results are consistent with a solubility study that attests the Ln(CO3)3(3-) and Ln(CO3)4(5-) stoichiometries for the heavy (small) and the light (big) lanthanides, respectively. The Alk+ counterions influence the mu ep,Ln Alk2 CO3 values, but not the overall shape of the mu ep,Ln Alk2 CO3 plots as a function of the lanthanide atomic numbers: the counterions do not modify the stoichiometries of the inner sphere complexes. The influence of the Alk+ counterions decreases in the Li+ > Na+ > K+ > Cs+ series. The K3,Ln stepwise formation constants of the Ln(CO3)3(3-) complexes slightly increase with the atomic numbers of the lanthanides while K4,Ln, the stepwise formation constants of Ln(CO3)4(5-) complexes, slightly decrease from La to Tb, and is no longer measurable for heavier lanthanides.     

Solid phase microextraction sampling for a rapid and simple on-site evaluation of volatile organic compounds emitted from building materials

An automated on-line method for the determination of the substituted aniline compounds was developed using in-tube solid-phase microextraction coupling to high-performance liquid chromatography (HPLC). In this work, oxidized multiwalled carbon nanotubes (MWCNTs-COOH) coated on the outer surface of the fused-silica tube and inserted in the polyether ether ketone (PEEK) tubing, which was fixed directly on the six-port injection valve to substitute for the sample loop. The extraction procedure was performed by a constant flow pump frequently driving the sample solution through the PEEK tubing and the analytes were adsorbed onto MWCNTs-COOH materials when the six-port valve set to load position. After extraction, the valve switched to inject position and the extracted analytes were desorbed by mobile phase in dynamic mode. High extraction capacity was achieved for the investigated analytes and great improvement of the limits of detection was obtained in comparison with other methods. The calibration plots were linear (r(2)> or =0.9949) over the concentration range of 1.04-104ngmL(-1) for 4-nitroaniline, 1.02-102ngmL(-1) for 2-nitroaniline, 1.68-168ngmL(-1) for 2-chloroaniline and 1.09-109ngmL(-1) for 2,4-dichloroaniline. The detection limit ranged from 0.04ngmL(-1) to 0.13ngmL(-1) (at S/N=3). The possibility of applying the established method to water samples analysis was also studied.     

Synthesis and micellar properties of 1-decyl-2,3-dimethylimidazolium bromide surfactant in water and water-ethanolamine mixtures at 298.15 K

1-Decyl-2,3-dimethylimidazolium bromide (ddmimBr) has been synthesized by the reaction of 1,2-dimethylimidazole and 1-bromodecane. Micellization of ddmimBr surfactant in water (W) and water-ethanolamine (W-EA) with the weight percent of EA changing within the range 0-39.79%, has been investigated at 298.15 K. Information about the influence of the added EA on the critical micelle concentration (CMC) was obtained through density and surface tension measurements. This last provides information about the dependence of the surface excess concentration, the minimum area per surfactant molecule and the surface pressure at the CMC on the added weight percentage of organic solvent. The effect of binary aqueous mixtures of W-EA on the apparent molar volume (phi V) of the ddmimBr has been investigated. The apparent molar volume upon aggregation (Delta phi V) shows a maximum at about 15 wt% of EA, this behavior is discussed in terms of the changes of the solvent structure. Partial specific volume data, obtained by density measurements, indicate that the fraction of solvent molecules interact with the surfactant remained roughly constant.     

Synthesis of condensed pyridones by using a new ring switching reaction

A new ring‐switching reaction of enaminoesters behaving as bisnucleophiles towards other enaminoesters behaving as biselectrophiles is described. By starting from pyroglutamic derivatives, this reaction provided easy access to methyl 5‐oxo‐1,2,3,5‐tetrahydro‐3‐indolizinecarboxylates substituted by an aminoester side chain in position 6.     

Oxidative coupling of acridinones: Synthesis of new C2‐symmetry atropisomers

The preparation of symmetric 2,2′‐dimethoxy‐10,10′‐biacridinyl‐9,9′‐dione atropisomers were obtained by the oxidative coupling of 9(10H)‐acridinone with 1,3‐dibromo‐5,5‐dimethyl‐imidazolidine‐2,4‐dione     

Multiphase telomerisation of butadiene with acetic acid and acetic anhydride

Two different routes to acetoxyoctadiene are presented. The first one uses the well-known telomerisation of butadiene with acetic acid operating in a multiphase semi-batch mode. The second reaction involves the cleavage of acetic anhydride, hydrogen transfer via ketene formation and thus a telomerisation as well.     

Fluorescence and phosphorescence properties of the low temperature forms of the MAl2Si2O8:Eu (M=Ca, Sr, Ba) compounds

The fluorescence and phosphorescence properties of Europium-doped MAl₂Si₂O₈ (M=Ca, Sr, Ba) are reinvestigated and discussed on the basis of the propensity of an activator to agglomerate with an oxygen vacancy. Due to a stronger attraction of the anion vacancy towards Eu²⁺ cations going from BaAl₂Si₂O₈ to SrAl₂Si₂O₈ and CaAl₂Si₂O₈ host lattices, the interpretation of the fluorescence spectra turns out to be less trivial in the Ca and Sr host lattices than in the Ba one and requests the account for Eu²⁺ cations lying at alkaline-earth sites with or without vacancy in their neighborhood. Phosphorescence in these compounds is highlighted.