Mössbauer, X-ray, electrical and magnetic properties of lithium borosilicate glasses containing iron and manganese Part I. Mössbauer measurements

The effect of the replacement of MnO₂ by Fe₂O₃ on the oxidation states of iron in some lithium borosilicate glasses were studied using Mössbauer spectroscopy. DTA and infrared measurements showed the presence of two glassy phases, one of them containing iron and the other manganese. The Mössbauer spectra were measured at room temperature for all the glass samples. The spectra revealed the presence of Fe ions only in ferric state in both tetrahedral and octahedral coordination. Also, it was observed that the ratio between the number of iron ions in both coordination states has not changed with the increase of MnO₂ content.     

Inclusive semileptonic decays of B mesons

The probability of inclusive semileptonic decay of B mesons is calculated in the constituent-quark model. A compact formula is obtained for the differential decay width of a B meson in terms of the corresponding decay width of a free b quark and the wave function of the internal motion of the quarks in the B meson. Numerical values of semileptonic-decay widths are obtained for a series of models of the wave function. Pis’ma Zh. éksp. Teor. Fiz. 65, No. 10, 734–737 (25 May 1997)     

Experimental study of the emission spread at gyrotron cathodes by current-voltage characteristics

A scheme for automated study of current-voltage characteristics of gyroresonance devices is developed. The effective emission spread at the cathodes of powerful gyrotrons is studied by analysis of current-voltage characteristics. Experimental data on the effective emission spread parameter for different modes are given. The permissible emission spread at the cathodes of powerful gyrotrons is estimated, and the dependence of the electron beam parameters on the cathode emission spread is presented. A complex measurement technique showing the contribution of different physical mechanisms to the cathode emission spread is proposed. Institute of Applied Physics, Russian Academy of Sciences, Nizhny Novgorod, Russia. Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Radiofizika, Vol. 40, No. 4, pp. 506–516, April, 1997.     

Fluorination of diamond — C4F9I and CF3I photochemistry on diamond (100)

The radiation-induced decomposition of C₄F₉I and CF₃I overlayers at 119 K on diamond (100) surfaces has been shown to be an efficient route to fluorination of the diamond surface. X-ray photoelectron spectroscopy has been used for photoactivation as well as for studying the photodecomposition of the fluoroalkyl iodide molecules, the attachment of the photofragments to the diamond surface, and the thermal decomposition of the fluoroalkyl ligands. Measured chemical shifts agree well with ab initio calculations of both C 1s and F 1s binding energies. It is found that chemisorbed CF₃ groups on diamond (100) decompose by 300 K whereas C₄F₉ groups decompose over the range 300 to 700 K and this reactivity difference is rationalized on steric grounds. Both of these thermal decomposition processes produce surface C---F bonds on the diamond. The surface C---F species thermally decompose over a wide temperature range extending up to 1500 K. Hydrogen passivation of the diamond surface is ineffective in preventing free radical attack from the photodissociated products of the fluoroalkyl iodides; I atoms produced photolytically abstract H from surface C---H bonds to yield hydrogen iodide at 119 K allowing diamond fluorination. The attachment of chemisorbed F species to the diamond (100) surface causes band bending as the surface states are occupied as a result of chemisorption. This results in a shift to higher binding energy of the diamond-related C 1s levels present in the surface and subsurface regions which are sampled by XPS on the diamond. The use of photoactivation of fluoroalkyl iodides for the fluorination of diamond surfaces provides a convenient route compared to other methods involving the action of atomic F, molecular F₂, XeF₂ and F-containing plasmas.     

The gas dynamics of current-limiting devices during immobility time

The aim of this paper is to extend our knowledge about the gas-dynamic processes in arcs during immobility time. For this purpose, the conservation equations in a magnetohydrodynamic approximation were coupled with the thermochemical and Maxwell equations. Special features arc the introduction of dissociation and ionization of nitrogen and oxygen, and the simultaneous calculation of the distributions of current density and magnetic induction in the arc. Numerical calculations were performed with a reduced two-dimensional (2-D) time-dependent model. Results of the calculations were compared with measurements. The development in time of the measured and calculated are voltage and arc chamber pressure show very good agreement. The pumping effect of the double vortex in the arc region was confirmed by optical measurements. It is concluded that the three-layer model is a good representation for the main physical features during the immobility time, and that the presence of highly conducting gas in the downstream region of the arc is essential for its downstream movement     

Phase shift moiré studies of processing-induced residual strains in Nickel 200 spot welds

Processing-induced residual strains in solid cylinders of Nickel 200 were investigated using phase shifting moiré interferometry. Two different experimental approaches were used to study the strains produced during Tungsten-inert gas spot welding. A comparison of results for a ‘hot/fast’ and a ‘cool/slow’ weld demonstrate the capabilities of the general approach. Both experimental methods revealed distinct differences in the residual displacement and strain fields between the two types of welds.     

Dissipative Nonlinear Evolution Equations and Chaos

In this article we have studied the nonlinear interaction between ellipticity and dissipation in a set of model equations (1.1) and established the relation between this interaction and chaos. In addition to theoretical investigations, extensive numerical simulations with these equations have been made, and different routes to chaos have been found. The numerical studies have revealed the chaotic nature of the solutions.     

Recombination of Au25+ with free electrons at low energies

The origin of the widely observed enhancement of rates for electron-ion recombination at very low energies is still unknown. We investigated the recombination of Au²⁵⁺ with free electrons in a merged-beams experiment at the UNILAC accelerator of the GSI in Darmstadt. At E _rel= 0 eV we found an enormous enhancement factor of 365 compared to the theory of radiative recombination. An increase of the electron density by a factor of 10 had not much influence on the measured rate coefficient. This revised version was published online in July 2006 with corrections to the Cover Date.     

On asymptotic approximations for slow wave processes in nonlinear dispersive media

We consider the application of asymptotic methods of nonlinear mechanics (the Krylov-Bogolyubov-Mitropol'skii method) and the method of separation of motions in nonlinear systems for the construction of an approximate solution of a nonlinear equation that describes a nonstationary wave process. Translated from Ukrainskii Matematicheskii Zhurnal, Vol. 50, No. 3, pp. 357–371, March, 1998.