The composite comprised of zinc oxide quantum dots and poly(amic acid) (PAAc) was prepared and studied by X-rays diffraction, X-ray photoelectron spectroscopy, light scattering, UV absorbance and UV fluorescence. The UV absorbance of the ZnO/PAAc composite was found to be much larger than that of its components taken separately. The fluorescence of the ZnO/PAAc composite was found to be shifted to longer wavelengthes in comparison with pure ZnO. The presence of the dopant dodecylbenzenesulfonic acid was found to affect the observed fluorescence. 相似文献
Based on a rigorous vectorial analysis, a fast travelling-wave Mach–Zehnder modulator is modelled and designed. The cross-section of the semiconductor layer stack and the lossy electrodes are carefully modelled using the method of lines in order to investigate propagation characteristics, velocity and losses. This yields an accurate microwave and optical field distribution to explain the behaviour of the component. In order to enhance the modulation efficiency, design curves are derived and the cross-sectional dimensions for minimum microwave loss are determined. The loss of the optimized modulator agrees very well with small-signal measurements up to 40 GHz and HFSS simulations. The layerstack of the fabricated device is suitable for integration with InP multi-wavelength lasers. 相似文献
We propose and experimentally demonstrate a stable dual-wavelength erbium-doped polarization-maintaining (PM) fiber laser
with tunable wavelength spacing using an all-PM linear cavity that makes use of two reflection peaks from the PM fiber Bragg
grating (PM-FBG). Experimental results show stable dual lasing lines with a wavelength separation of ∼0.22 nm and a large
optical signal-to-noise ratio (OSNR) of over 40 dB under room temperature. By applying axial strain to the PM-FBG, the center
wavelengths of the two lasing lines can be tuned over several nanometers and the wavelength separation between the lasing
lines can also be tuned to as small as 0.05 nm, which, to our knowledge, is the smallest wavelength spacing ever obtained
from a stable room-temperature dual-wavelength fiber laser. The proposed laser configuration has the advantages of simple
structure, low loss, stable dual-wavelength operation and a very small lasing linewidth of ∼5 kHz .
PACS 42.55.Wd; 42.81.-i; 42.81.Gs 相似文献
Synthetic routes to BEDT-TTF derivatives bearing side chain carboxylic ester and amide groups are reported. Methyl ET-ethanoate was prepared in five steps from vinylacetic acid; amide groups were installed early in the synthesis by mixed anhydride methods before the final coupling reaction. 相似文献
Nickel complexes 1–4 ligated with 2,9-disubstituted-1,10-phenanthroline were synthesized and characterized by FT-IR spectra and elemental analysis.
The molecular structure of complex 2 was confirmed by X-ray crystal diffraction analysis. Activated with methylaluminoxane (MAO), those complexes showed moderate
activities for ethylene oligomerization.
Published in Kinetika i Kataliz, 2007, Vol. 48, No. 5, pp. 710–714.
This article was submitted by the authors in English. 相似文献
Current methodologies used for the inference of thin film stress through curvature measurement are strictly restricted to stress and curvature states that are assumed to remain uniform over the entire film/substrate system. These methodologies have recently been extended to a single layer of thin film deposited on a substrate subjected to the non-uniform misfit strain in the thin film. Such methodologies are further extended to multi-layer thin films deposited on a substrate in the present study. Each thin film may have its own non-uniform misfit strain. We derive relations between the stresses in each thin film and the change of system curvatures due to the deposition of each thin film. The interface shear stresses between the adjacent films and between the thin film and the substrate are also obtained from the system curvatures. This provides the basis for the experimental determination of thin film stresses in multi-layer thin films on a substrate. 相似文献
This research aimed to reduce the variability on the data obtained from differential scanning calorimetric (DSC) analysis of the isothermal crystallization kinetics of cocoa butter.
To enable transformation of the DSC crystallization peak to a sigmoid crystallization curve, the DSC peak area has to be integrated. Usually, the start and end points of the crystallization peak are determined visually. The result of this visual determination appeared to be very much dependent on the operator, but also differed considerably when the same operator performed the integration several times. By proposing an objective calculation algorithm to determine the start and end points of integration, the variability caused by the operator during the integration procedure could be eliminated. Furthermore, sample preparation and the DSC heating protocol to melt the sample prior to crystallization were studied. Three heating protocols (65 °C for 15 min, 65 °C for 30 min and 80 °C for 15 min) were compared and it was shown that holding at 65 °C for 15 min was sufficient to eliminate any influence of sample history. Two different sample preparation procedures were compared and it appeared that a change in sample preparation procedure had a significant influence on the measured crystallization process. It is thus important to keep this method constant to eliminate the variability caused by it. 相似文献
We study the Gauss-Manin connection for the moduli space of an arrangement of complex hyperplanes in the cohomology of a complex rank one local system. We define formal Gauss-Manin connection matrices in the Aomoto complex and prove that, for all arrangements and all local systems, these formal connection matrices specialize to Gauss-Manin connection matrices.
The oxides A(Ti0.5Te1.5)O6 (A = K, Rb, Cs, Tl), A(Ti0.5W1.5)O6 (A = Rb, Cs, Tl), and Cs(B0.5W1.5)O6 (B = Zr, Hf) have been obtained as polycrystalline powders giving X-ray diffraction patterns characteristic of defect cubic pyrochlores, space group
(No. 227), Z = 8. The best discrepancy R factors, from 0.0265 for Rb(Ti0.5Te1.5)O6 to 0.0554 for Cs(Zr0.5W1.5)O6, were obtained for the B cations randomly distributed at 16(d), A ions at one quarter of 32(e), and oxygen atoms at 48(f) positions. A linear relationship is observed between the a unit cell parameters and the ionic radii of the A cations, as well as the average ionic radii of the B atoms. The results of electrical resistivity measurements for A(Ti0.5Te1.5)O6 (A = K, Rb, Cs, Tl) are given. 相似文献