Widely tunable, high-repetition-rate, dual signal-wave optical parametric oscillator by using two periodically poled crystals

This paper reports on a high-repetition-rate dual signal-wave (DSW) optical parametric oscillator (OPO) operating at the 1.5 μm band with tunable wavelength intervals from 2.5 nm to 69.1 nm. Two periodically poled crystals, a periodically poled lithium niobate (PPLN) with multiple gratings and a single grating MgO-doped PPLN (PPMgOLN), are cascaded in the same OPO cavity to generate dual signal-waves by using quasi-phase-matched (QPM) technique. The pump source was a Q-switched diode-pumped Nd:YVO₄ laser operating at 50 kHz. At an incident pump power of 3 W, an average output power of 169.6 mW at 1489.2 nm and 1558.3 nm has been achieved.     

矿山尾矿中微量银元素快速检测方法的研究

针对矿山尾矿中微量银元素测定的技术难题,提出了一种基于超短光路原理的能量色散X荧光能谱快速检测的方法。提高元素测量分辨率,提高样品分析效率,降低光管功率,延长仪器使用寿命。能谱系统优化了滤片以及探测器屏蔽物等设计,准直器采用对X射线基本无散射的聚四氟乙烯,达到微量银元素的检测要求。实际尾矿测试中,银的检出限达到0.1 mg·kg-1,RSD在0.1%～2.6%之间,准确度在87%～115%之间。对比尾矿、原矿及精矿的检测实验,证明了在能量色散X荧光能谱中引入超短光路设计方法,能够提升系统峰/本底比,满足微量银元素的检测要求。     

CCD紫外增强薄膜旋涂法工艺优化

在硅基探测器的入射窗上制备荧光下转换薄膜,是一种有效降低成本的紫外荧光增强技术。从理论上探讨了由聚二甲基硅氧烷与颜料黄101混合胶体的紫外荧光薄膜旋涂工艺参数与性能之间关系,搭建紫外荧光薄膜应用于光谱分析的性能测试实验平台,对紫外荧光增强薄膜旋涂工艺参数质量配比、旋涂转速进行优化。光谱分析探测器有两个主要指标,光谱响应灵敏度和光谱分辨率,分析与实验结果表明,利用旋涂法制备紫外增强荧光薄膜,旋涂转速将直接影响薄膜的厚度、表面粗糙度和荧光物质的分布,从而影响光谱分析系统的分辨率;紫外荧光增强薄膜的增强效率与荧光溶剂聚二甲基硅氧烷与荧光物质颜料黄101的质量比密切相关,质量比低无法满足对紫外响应效率的提高,但高质量比,荧光物质处在聚集态荧光自猝灭严重,也不利于增强薄膜的紫外响应效率。最终,在薄膜旋涂工艺优化的基础上,旋涂转速2 500～3 000 r·min-1,荧光物质与荧光溶剂质量比为7∶100制备出紫外荧光增强薄膜。汞灯特征光谱测试结果表明该薄膜313 nm紫外波长处探测响应灵敏度提高了1.6倍左右,对比分析镀膜前后特征光谱的半波带宽,镀制紫外增强荧光薄膜对其影响很小。     

光电经纬仪机电一体化耦合特性

区别于传统刚体控制模型,将结构动态设计方法与控制理论相结合,构建了光电经纬仪的柔性机电耦合控制模型,分析了该模型的结构基频、阻尼比等机械因素与控制带宽的耦合关系,并提出了光电经纬仪动态量化设计准则.实验表明:光电经纬仪结构谐振频率ω_n应尽可能地远大于系统谐振频率ω_r,至少满足ω_n≥3ω_r.该方法有效可行,可解决高精度大型经纬仪机电谐振问题,为设计快速响应、高跟踪精度的光电经纬仪提供了工程依据.     

长波红外无线激光通信脉冲宽度调制实验研究

为实现长波红外无线激光通信,建立了基于脉宽调制的长波红外无线激光通信系统模型,对系统性能进行了分析,给出了系统误码率的计算公式.搭建了实验系统,对CO_2激光器的平均输出光功率随占空比的变化情况进行了分析,对不同占空比条件下接收端对应的激光平均脉冲宽度以及脉冲宽度受噪声影响的随机变化情况进行了分析,得到了激光输出平均光功率、平均脉冲宽度与占空比之间的关系,以及脉宽的分布规律,并将实验结果与理论分析结果进行了对比,在此基础上得到了脉宽最佳判决门限和系统各类工作参数同误码率之间的关系.结果表明,基于CO_2激光器的脉冲宽度调制能够实现长波红外无线激光通信.     

Baryon rapidity loss in relativistic Au + Au collisions

An excitation function of proton rapidity distributions for different centralities is reported from AGS Experiment E917 for Au+Au collisions at 6, 8, and 10.8 GeV/nucleon. The rapidity distributions from peripheral collisions have a valley at midrapidity which smoothly change to distributions that display a broad peak at midrapidity for central collisions. The mean rapidity loss increases with increasing beam energy, whereas the fraction of protons consistent with isotropic emission from a stationary source at midrapidity decreases with increasing beam energy. The data suggest that the stopping is substantially less than complete at these energies.     

用光栅式位移传感器测金属丝的杨氏模量

本文介绍了用光栅式位移传感器测量金属丝微小伸长量的实验方法。     

拉曼激发激光诱导电子荧光流场测量系统中标记过程的研究

研制了一套拉曼激光发激光诱导电子荧光空气流场测速系统,利用Nd:YAG激光器的二次谐波及其抽运的氧气受激拉曼散射作为标记光源,以ArF准分子激光作为荧光再现光源,并用像增强CCD摄像机（ICCD）记录荧光图像,成功地获得了纯氧及空气中的标记线的荧光图像,并进行了氧气喷流速度测量的初步研究。     

Study of N*(1440) from J/Ψ decays

For J/Ψ↦ pπ⁰ and pπ⁺π^-, the π⁰ p and pπ⁺π^- systems are limited to be pure isospin-(1/2) due to isospin conservation. This is a big advantage in studying N^* resonances from J/Ψ decays, compared with πN and γN experiments. The process J/Ψ↦ N ^* or p provides a new way to probe the internal structure of the N^* resonances. Here we report a quark model calculation for J/Ψ↦ p, N ^*(1440) and N ^*. The implication for the internal structure of N ^*(1440) is discussed. Received: 1 June 2001 / Accepted: 20 June 2001     

One-step synthesis of the green phosphor Ce-Tb-Mg-Al-O system with spherical particle shape and fine size

Spray pyrolysis method was applied to the preparation of Ce_0.6Tb_0.4MgAl₁₁O₁₉ green phosphor particles. The characteristics of as-prepared particles such as photoluminescence, crystallinity, and morphology were compared with those of post-treated particles. The as-prepared particles at 1700 °C had higher crystallinity and photoluminescence properties compared with those of post-treated particles. The morphology of as-prepared particles obtained at low temperatures changed from spherical shape to plate-like shape after post-treatment at 1400 °C for 3 h. The particles directly prepared at 1700 °C had the mean size of 0.7 μm and non-aggregation characteristics. This study has demonstrated that without post-treatment processing/annealing, spherical phosphor particles having complex composition could be prepared by a one-step synthesis. Received: 20 December 1999 / Accepted: 25 May 2000 / Published online: 9 August 2000