Study on the Thermodynamic Stabilities of Te-Substituted Di-n-butyltellurium Ylide

SincethediscoveryofphosphoniumylidebyWittig',carbanionsstabilizedbyadjacentfifthorsixthgrouponiumionshavebeendevelopedasavaluablereactiveintermediate.However,despitethegreateffortsinylidechemistryinthepastfewdecades',relativelylittleisknownaboutthethermodynamicstabilitiesofylidecarbanions.Itiswellknowthatthequantitativemeasuresofthecarbanionstabilityhavecontributedagreatdealtothedevelopmentoforganicchemistry,thereforeitshouldbeexpectedthattheknowledgeaboutylidestabilitywillalsoprovidavaluableg…     

Contractions with a unilateral shift summand are reflexive

If T is a contraction on the Hilbert space H and there is an invariant subspace K for T such that T/K is similar to a backward shift, then T is reflexive. If similarity is replaced by quasi-similarity, then the same conclusion holds under the additional condition that the defect index of T be finite.This research was partially supported by National Science Council (Republic of China).     

Filtered backprojection for the reconstruction of a high-resolution (4,2)D CH3-NH NOESY spectrum on a 29 kDa protein

Projection-reconstruction (PR) NMR enables rapid collection of multidimensional NMR data. NOESY represents a particularly difficult challenge for currently existing reconstruction algorithms, as it requires the quantitative reconstruction of an unknown number of peaks, at full sensitivity. We have demonstrated the successful application of PR-NMR to NOESY by determining the 4D methyl/amide NOESY spectrum of a 29 kDa protein, human carbonic anhydrase II, from 2D projections, using filtered backprojection for reconstruction. Compared with a 3D control spectrum, all expected peaks were faithfully reconstructed, with correct volumes and with no artifacts. Filtered backprojection thus provides a way to obtain high-resolution 4D NOESY data in the time required for conventional 3D data collection.     

两种胶原纤维固化单宁对La3+的吸附特性研究

以皮胶原纤维为基质,通过交联剂分别将黑荆树单宁和杨梅单宁固化在胶原纤维上制备吸附材料。实验表明,这两种吸附材料对稀土金属离子La^3＋有很好的吸附作用。在pH为4.5的条件下,当吸附剂用量为0.1 g,La^3＋初始浓度为9.952 mmol·L^-1,固化杨梅单宁的平衡吸附量为0.388 mmol·g^-1,比固化黑荆树单宁略大,其吸附平衡均符合Freundlich方程。进一步研究了固化杨梅单宁的吸附动力学、温度、pH值等对吸附平衡的影响。结果表明,温度对吸附平衡的影响不明显;pH值对吸附平衡有较大影响,在适当范围内提高pH值会增加平衡吸附量;吸附动力学可用拟二级速度方程来描述。当吸附温度为293 K时,由拟二级速率方程计算所得的平衡吸附量与实测的平衡吸附量误差在3%以内。同时固化杨梅单宁也具有良好的柱动力学特性。     

Preparation and Properties of Urease Immobilized onto Glutaraldehyde Cross-linked Chitosan Beads

Urease was immobilized onto the glutaraldehyde cross-linked chitosan beads that were prepared under microwave irradiation. The activity and the yield of activity of immobilized urease was 10.83 U/g B and 47.7%, respectively. The conditions of urease immobilization were optimized. The properties of the immobilized urease were investigated and compared with that of the free enzyme.     

Quantitative analysis of 23-hydroxybetulinic acid in mouse plasma using electrospray liquid chromatography/mass spectrometry

23-Hydroxybetulinic acid is a newly isolated derivative of betulinic acid. The agent exhibits potential anti-tumor activity and functions in this regard via apoptosis. In support of pharmacokinetic and toxicological evaluations, a new assay based on liquid chromatography/mass spectrometry (LC/MS) was developed for the quantitative analysis of 23-hydroxybetulinic acid. Sample preparation consisted of extraction of the plasma by the addition of methylene chloride followed by centrifugation. Aliquots of the supernatant were analyzed using an isocratic reversed-phase high-performance liquid chromatography (HPLC) system coupled to a negative ion electrospray mass spectrometer. Molecules of 23-hydroxybetulinic acid and the internal standard limonin were detected using selected ion monitoring at m/z 471 and 469, respectively. The limit of detection of 23-hydroxybetulinic acid was 0.05 pg (0.11 fmol) injected on-column (10 pg/mL, 5 microL injection volume), and the limit of quantitation was 10 pg (21.19 fmol, 2 ng/mL, 5 muL injection volume). 23-Hydroxybetulinic acid was stable in plasma samples at -20 degrees C for at least 3 weeks. The intra-day and inter-day coefficients of variation of the assay were 3.0 and 4.8%, respectively. The utility of the assay was demonstrated by measuring 23-hydroxybetulinicacid in mouse plasma following intragastric administration (IG) in vivo. Pharmacokinetic parameters were calculated using the 3P97 pharmacokinetic software package. A two-compartment, first-order model was selected for pharmacokinetic modeling. The result showed that after IG of 200 mg/kg 23-hydroxybetulinic acid, the plasma concentrations reached peaks at 2 h with C(max) of 3.1 microg/mL. The 200 mg/kg 23-hydroxybetulinic acid suspension IG doses were found to have long elimination half-lives of 25.6 h and low bioavailability of 2.3%. No interference was noted due to endogenous substances. These analytical methods should be of value in future studies related to the development and characterization of 23-hydroxybetulinic acid.     

纳秒强激光场中苯电离产生高价离子的研究

用25 ns脉冲Nd-YAG 532 nm的激光，在1010～1011 W•cm－2的光场强度下，利用飞行时间质谱对He、 N2、Ar载气条件下苯的激光电离过程进行了研究.发现当利用氩作为载气时，除观察到C2＋、C2H2+、C3H3+、C6H6+离子外，还观察到很强的Cq＋(q=1～3)高价离子.这些离子都有很高的平动能， C2＋的最可几平动能为12.9 eV， C3＋为37.5 eV.通过改变载气种类和压力及在不同光场强度条件下的实验，可以认为这些高价离子来源于含苯团簇的库仑爆炸过程.     

A novel microwave dielectric ceramic Ca2Zn4Ti16O38: Preparation and dielectric properties

A novel microwave dielectric powder with composition of Ca₂Zn₄Ti₁₆O₃₈ was synthesized through a citrate sol-gel process. The development of crystalline phases with heat-treating temperature for the gel derived powders was evaluated by using thermo-gravimetric analysis and X-ray powder diffraction analysis techniques. The pure phase of Ca₂Zn₄Ti₁₆O₃₈ with crichtonite crystal structure was obtained at relatively low temperature of 1000 °C. The synthesized powder has high reactivity and the dense ceramics with single crystalline phase were obtained at low sintering temperature of 1100 °C. Impedance spectroscopy and microwave dielectric measurements on sintered samples showed the present compound to be a modest dielectric insulator with excellent dielectric properties of ε_r∼47-49, Qf value ∼27,800-31,600 GHz and τ_f∼+45 to +50 ppm/°C. It shows comparable microwave dielectric properties to other moderate-permittivity microwave dielectrics, but much lower sintering temperature of 1100 °C.     

The video-rate imaging of sub-10 nm plasmonic nanoparticles in a cellular medium free of background scattering

Plasmonic nanoparticles (e.g., gold, silver) have attracted much attention for biological sensing and imaging as promising nanoprobes. Practical biomedical applications demand small gold nanoparticles (Au NPs) with a comparable size to quantum dots and fluorescent proteins. Very small nanoparticles with a size below the Rayleigh limit (usually <30–40 nm) are hard to see by light scattering using a dark-field microscope, especially within a cellular medium. A photothermal microscope is able to detect very small nanoparticles, down to a few nanometers, but the imaging speed is usually too slow (minutes to hours) to image living cell processes. Here an absorption modulated scattering microscopy (AMSM) method is presented, which allows for the imaging of sub-10 nm Au NPs within a cellular medium. The unique physical mechanism of AMSM offers the remarkable ability to remove the light scattering background of the cellular component. In addition to having a sensitivity comparable to that of photothermal microscopy, AMSM has a much higher imaging speed, close to the video rate (20 fps), which allows for the dynamic tracking of small nanoparticles in living cells. This AMSM method might be a valuable tool for living cell imaging, using sub-10 nm Au NPs as biological probes, and thereby unlocking many new applications, such as single molecule labeling and the dynamic tracking of molecular interactions.

An absorption modulated scattering microscopy technique that allows for the imaging of sub-10 nm gold nanoparticles within a cellular scattering medium is presented.     

Electroosmotic flow controllable coating on a capillary surface by a sol-gel process for capillary electrophoresis

A simple coating procedure employing a sol-gel process to modify the inner surface of a bare fused-silica capillary with a positively charged quaternary ammonium group is established. Scanning electron microscopic studies reveal that a smooth coating with 1 to approximately 2 microm thickness can be obtained at optimized coating conditions. With 40 mM citrate as a running electrolyte, the plot of electroosmotic flow (EOF) versus pH shows a unique three-stage EOF pattern from negative to zero and then to positive over a pH range of 2.5 to 7.0. At pH above 5.5, the direction of the EOF is from the anode to the cathode, as is the case in a bare fused-silica capillary, and the electroosmotic mobility increases as the pH increases. However, the direction of the EOF is reversed at pH below 4.0. Over the pH range of 4.0 to 5.5, zero electroosmotic mobility is obtained. Such a three-stage EOF pattern has been used to separate six aromatic acids under suppressed EOF and to separate nitrate and nitrite with the anions migrating in the same direction as the EOF. The positively charged quaternary ammonium group on the coating was also utilized to minimize the adsorption problem during the separation of five basic drugs under suppressed EOF and during the separation of four basic proteins with the cations migrate in the opposite direction as the EOF. Also, the stability and reproducibility of this column are good.