Cu~+、Ag~+、Au~+与乙硫醇的气相化学反应

利用激光溅射 分子束的技术 ,结合反射飞行时间质谱计 ,研究了Cu+、Ag+、Au+与乙硫醇的气相化学反应。结果显示这三种金属离子与 (CH3 CH2 SH) n 反应形成一系列团簇离子M+(CH3 CH2 SH) n,且团簇离子尺寸不一样。Ag+、Au+与乙硫醇的反应还生成了 (CH3 CH2 SH) +n ,由此推测Cu+、Ag+、Au+与乙硫醇团簇的反应存在两种通道 ,一种通道是生成M+(CH3 CH2 SH) n,另一种是生成 (CH3 CH2 SH) +n 。Cu+、Au+与乙硫醇的反应还生成了M+(H2 S) (M =Cu、Au) ,但是实验中没有观察到Ag+(H2 S) ,理论计算表明Ag+(H2 S)很不稳定。另外 ,分析产物离子M+(CH3 CH2 SH) n 的强度发现 ,n =1～ 2之间存在明显的强度突变现象     

On the orthogonality of natural modes of vibration

The natural modes of a discrete linear system are orthogonal with respect to the mass and stiffness matrices in a generalized sense. However, these modes are usually not orthogonal to each other in the ordinary sense. The purpose of this paper is to document a number of conditions under which the modes are also orthogonal in an ordinary fashion.     

Soluble,saturated‐red‐light‐emitting poly(p‐phenylenevinylene) containing triphenylamine units and cyano groups

A conjugated poly(p‐CN‐phenylenevinylene) (PCNPV) containing both electron‐donating triphenylamine units and electron‐withdrawing cyano groups was prepared via Knoevenagel condensation in a good yield. Gel permeation chromatography suggested that the soluble polymer had a very high weight‐average molecular weight of 309,000. A bright and saturated red emission was observed under UV excitation in solution and film. Cyclic voltammetry showed that the polymer presented quasi‐reversible oxidation with a relatively low potential because of the triphenylamine unit. A single‐layer indium tin oxide/PCNPV/Mg–Ag device emitted a bright red light (633 nm). © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 3947–3953, 2004     

Combined effects of clay modifications and compatibilizers on the formation and physical properties of melt‐mixed polypropylene/clay nanocomposites

The melt mixing technique was used to prepare various polypropylene (PP)‐based (nano)composites. Two commercial organoclays (denoted 20A and 30B) served as the fillers for the PP matrix, and two different maleated (so‐called) compatibilizers (denoted PP‐MA and SMA) were employed as the third component. The results from X‐ray diffraction (XRD) and transmission electron microscope (TEM) experiments revealed that 190 °C was an adequate temperature for preparing the nanocomposites. Nanocomposites were achieved only if specific pairs of organoclay and compatibilizer were simultaneously incorporated in the PP matrix. For example, PP/20A(5 wt %)/PP‐MA(10 wt %) and PP/30B(5 wt %)/SMA(5 wt %) composites exhibited nanoscaled dispersion of 20A or 30B in the PP matrix. Differential scanning calorimetry (DSC) results indicated that the organoclays served as nucleation agents for the PP matrix. Generally, their nucleation effectiveness increased with the addition of compatibilizers. The thermal stability enhancement of PP after adding 20A was confirmed with thermogravimetric analysis (TGA). The enhancement became more evident as a suitable compatibilizer was further added. However, for the 30B‐included composites, thermal stability enhancement was not evident. The dynamic mechanical properties (i.e., storage modulus and loss modulus) of PP increased as the nanocomposites were formed; the properties increment corresponded to the organoclay dispersion status in the matrix. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4139–4150, 2004     

Fluorescent-based single-strand conformation polymorphism/heteroduplex capillary electrophoretic mutation analysis of the P53 gene.

Fluorescent-based single-strand conformation polymorphism (F-SSCP) analysis with capillary electrophoresis (CE) is the most common method for the detection of mutation because of its high sensitivity and resolution. In this study, we prepared an inexpensive linear polyacrylamide (LPA), and successfully applied it to CE-SSCP analysis and tandem CE-SSCP/heteroduplex analysis (HA) of the P53 gene on an ABI capillary genetic analyzer. A comparison of the sieving capabilities of a homemade LPA and commercial polydimethylacrylamide (PDMA) demonstrates that the homemade LPA has a higher resolution, a shorter analysis time, and is more suitable for tandem SSCP/HA than commercial PDMA. To show the usefulness, mutations of P53 gene exon 7 - 8 in 37 tumor samples were investigated by using homemade LPA. The results indicate that 10 mutations were found in 9 of 37 cases; the majority of P53 mutations were missense mutations, and 70% were located in exon 7, which plays an important role in neoplastic progression in human tumorigenesis.     

Synthesis of Cationic PEM Emulsion and Application in Waste Water Treatment

Cationic polymer as a kind of flocculant is widely applied in purification treatment of waste water. Because it has positive charge group, it is able to connect strongly the suspended matters, short cellulose and other microparticles. The research on synthesis of cationic polymer and application in treatment of waste water is very universal abroad. But domestic research on those is not general. The technology of synthesis of PEM is simple, and the production cost is low. It is easy to apply in treatment of waste water.Synthesis of PEM Emulsion FlocculantSome distilled water, PVA(poly(vinyl alcohol)), EA(ethyl acrylate), and K2S2O8(potassium persulfate) were put into reaction vessel. Kept stirring up under nitrogen. When heated the solution to 40℃, dropped the water solution of MTA[(2-methacryloxylethyl)trimethyl ammonium].Maintained the temperature at 70℃, reacted about 7-8 hours. Then got the PEM emulsion. Changed the ratio of EA and MTA. Obtained a series of PEM emulsions.Stability and Convertibility of PEM EmulsionThe test results showed that when the EA/MTA was 85/15, the PEM emulsion was most stable.When the total monomer quantity was 35%, the convertibility of PEM emulsion was the highest,i.e.98.6%.The MTA Copolymerization Ratio and Morphology of PEM EmulsionWhen the monomers EA/MTA=85/15 and total monomer quantity was 35%, the MTA copolymerization ratio of PEM emulsion was 95.15%(the highest), and the PEM emulsion was some microspheres with 100-180nm of diameter.The Test Results of PEM Emulsion in Treatment of Waste Water The PEM emulsion flocculant was applied in treatment of waste water of paper mill, and measured the precipitation time(t) and transmittancy(T). The test results were showed in table 1. The optimum value of PEM which was able to make the waste water of paper mill into clear water was 0.008%.     

On many‐sorted algebraic closure operators

A theorem of Birkhoff‐Frink asserts that every algebraic closure operator on an ordinary set arises, from some algebraic structure on the set, as the corresponding generated subalgebra operator. However, for many‐sorted sets, i.e., indexed families of sets, such a theorem is not longer true without qualification. We characterize the corresponding many‐sorted closure operators as precisely the uniform algebraic operators. (© 2004 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Kuratowski Convergence of Holomorphic Functions

The notion of Kuratowski convergence is applied to describe a kind of convergence in the context of holomorphic functions. We associate it to a convenient topology, explore its relation with the compact-open topology, thus providing a new set theoretic point of view of this classic topology, and present it in the framework of set-valued mappings.     

高速色散补偿系统中喇曼放大器性能研究

利用喇曼放大器的非线性偏微分耦合方程组,对带喇曼放大器的色散补偿系统进行了仿真,并与传统的仿真方法进行了比较.结果表明:在色散完全补偿系统中,当传输速率较高时,忽略色散后的传统仿真方法的结果,与采用色散补偿技术后使整个系统色散为零的仿真结果有一定偏差,此时不能忽略色散的作用.还对前补偿系统和后补偿系统进行了研究,利用Q值性能判别法,分别得到了信号光脉冲的最佳占空比和最佳脉冲阶数.