Local asymptotic stability for dissipative wave systems

We study the question of asymptotic stability, as time tends to infinity, of solutions of dissipative wave systems, governed by time-dependent nonlinear damping forces and by strongly nonlinear potential energies. This problem had been considered earlier for potential energies which arise from restoring forces, whereas here we allow as well for the effect of amplifying forces. Global asymptotic stability can then no longer be expected, and should be replaced by local stability. The conclusions are related to and supplement earlier work of Payne and Sattinger [7], who treated the nondissipative case, and of Hale [1], who showed the existence of connected global attractors.     

2‐Diazo‐2H‐indoles

2‐Diazo‐2H‐indoles were prepared by diazotization of the corresponding 1H‐indol‐2‐amines and subsequent neutralization. On the basis of NMR data and ab initio and semiempirical calculations, we suggest that the zwitterionic form A is the most representative structure for 2‐diazo‐2H‐indoles. In fact, spectral data are compatible with a 1H‐indole structure, and the fully optimized molecules gave distances in agreement with those reported for the anion obtained from 1H‐indole. The calculated charges are compatible with a zwitterionic structure in which the negative charge is mainly located at the ring N‐atom at variance with the case of diazopyrroles and 3‐diazo‐3H‐indoles where the negative charge is essentially located on the ipso C‐atom.     

Sol-Gel Preparation and Characterization of Ag-TiO2 Nanocomposite Thin Films

Ag-TiO₂ thin films were prepared with a sol-gel route, using titanium isopropoxide and silver nitrate as precursors, at 0.03 and 0.06 Ag/Ti nominal atomic ratios. After drying at 80°C, the films were fired at 300°C and 500°C for 30 min. The films were analysed by X-ray diffraction (XRD) with glancing angle, and X-ray photoelectron spectroscopy (XPS), with depth profiling of the concentration. XPS analysis showed the presence of C and N as impurities in the nanocomposite films. Their concentration decreased with increasing the firing temperature. Chemical state analysis showed that Ag was present in metallic state, except for the very outer layer where it was present as Ag⁺. For the films prepared with a Ag/Ti concentration of 0.06, depth profiling measurements of the film fired at 300°C showed a strong Ag enrichment at the outer surface, while composition remained almost constant within the rest of the film, at 0.019. For the films heated to 500°C, two layers were found, where the Ag/Ti ratios were 0.015 near the surface and 0.026 near the substrate.     

Protein binding onto surfactant-based synthetic vesicles

Synthetic vesicles were prepared by mixing anionic and cationic surfactants, aqueous sodium dodecylsulfate with didodecyltrimethylammonium or cetyltrimethylammonium bromide. The overall surfactant content and the (anionic/cationic) mole ratios allow one to obtain negatively charged vesicles. In the phase diagram, the vesicular region is located between a solution phase, a lamellar liquid crystalline dispersion, and a precipitate area. Characterization of the vesicles was performed by electrophoretic mobility, NMR, TEM, and DLS and we determined their uni-lamellar character, size, stability, and charge density. Negatively charged vesicular dispersions, made of sodium dodecylsulfate/didodecyltrimethylammonium bromide or sodium dodecylsulfate/cetyltrimethylammonium bromide, were mixed with lysozyme, to form lipoplexes. Depending on the protein/vesicle charge ratio, binding, surface saturation, and lipoplexes flocculation, or precipitation, occurs. The free protein in excess remains in solution, after binding saturation. The systems were investigated by thermodynamic (surface tension and solution calorimetry), DLS, CD, TEM, 1H NMR, transport properties, electrophoretic mobility, and dielectric relaxation. The latter two methods give information on the vesicle charge neutralization by adsorbed protein. Binding is concomitant to modifications in the double layer thickness of vesicles and in the surface charge density of the resulting lipoplexes. This is also confirmed by developing the electrophoretic mobility results in terms of a Langmuir-like adsorption isotherm. Charges in excess with respect to the amount required to neutralize the vesicle surface promote lipoplexes clustering and/or flocculation. Protein-vesicle interactions were observed by DLS, indicating changes in particle size (and in their distribution functions) upon addition of LYSO. According to CD, the bound protein retains its native conformation, at least in the SDS/CTAB vesicular system. In fact, changes in the alpha-helix and beta-sheet conformations are moderate, if any. Calorimetric methods indicate that the maximum heat effect for LYSO binding occurs at charge neutralization. They also indicate that enthalpic are by far the dominant contributions to the system stability. Accordingly, energy effects associated with charge neutralization and double-layer contributions are much higher than counterion exchange and dehydration terms.     

Rapid Resolution Liquid chromatography/High Resolution Tandem Mass Spectrometry to Characterize Metabolic Changes in Subjects Involved in MARS500 Project

A rapid resolution liquid chromatography-tandem mass spectrometry analysis was applied to human urine samples to discover new molecular biomarkers of the alteration of psychophysical well-being due to the environmental, physiological and confinement stress conditions achieved in the MARS500 project. Urine samples of crew members were submitted to metabolomic studies by means of separative techniques coupled with mass spectrometric techniques and data analysis. More than 2,000 metabolite features were found in each comparison, and more than 150 metabolites were identified for every differential analysis. Significant modifications in eight metabolites were shared by the subjects under study.     

Development and validation of a liquid chromatography/atmospheric pressure photoionization-tandem mass spectrometric method for the analysis of mycotoxins subjected to commission regulation (EC) No. 1881/2006 In cereals

A sensitive and reliable liquid chromatography/photoionization (APPI) tandem mass spectrometry method has been developed for determining nine selected mycotoxins in wheat and maize samples. The analytes were chosen on the basis of the mycotoxins under EU Commission Regulation (EC) No. 1881/2006, i.e., deoxynivalenol (DON), zearalenone (ZON), aflatoxins (AFs), and ochratoxin A (OTA), and considering the possibility of a near future regulation for T-2 and HT-2 toxins. Mycotoxins were extracted from samples by means of an one-step solvent extraction without any cleanup. The developed multi-mycotoxin method permits simultaneous, simple, and rapid determination of several co-existing toxins separated in a single chromatographic run, in which AFs, T-2 and HT-2 toxin are acquired in positive, while OTA, DON and ZON in negative mode. Although a moderate signal suppression was noticeable, matrix effect did not give significant differences at p = 0.05. Then, calibration in standard solution were used for quantitation. Based on the EU Commission Decision 2002/657/EC, the method was in-house validated in terms of ruggedness, specificity, linearity, trueness, within-laboratory reproducibility, decision limit (CCα) and detection capability (CCβ). For all the analytes, the regression coefficient r ranged between 0.8752 (DON in wheat) and 0.9465 (ZON in maize), biases related to mean concentrations were from −13% to +12% of the nominal spiking level, and the overall within-laboratory reproducibility ranged 3–16%; finally, CCα values did not differ more than 20% and CCβ not more than 42% from their respective maximum limit. Method quantification limits ranged from 1/20 (AFG1) to 1/4 (AFG2 and OTA) the maximum limit established by European Union in the Commission Regulation (EC) No. 1881/2006 and its subsequent amendments.     

Reversible Deactivation of Enzymes by Redox‐Responsive Nanogel Carriers

Novel redox‐responsive polymeric nanogels that allow highly efficient enzyme encapsulation and reversible modulation of enzyme activity are developed. The nanogel synthesis and encapsulation of enzyme are performed simultaneously via in situ crosslinking of pyridyldisulfide‐functionalized water‐soluble reactive copolymers, which are synthesized via reversible addition–fragmentation chain transfer copolymerization. Obtained nanogels with loaded cellulase demonstrate very good colloidal stability in aqueous solutions. The enzymatic activity of cellulase is greatly reduced when encapsulated in the nanogels and rapidly recovered in 10 × 10⁻³ m dithiothreitol solution. Fluorescence resonance energy transfer (FRET)‐based experiments indicate that the recovered enzymatic activity is mainly ascribed to the release of the enzyme due to the degradation of the disulfide crosslinking network after addition of dithiothreitol (DTT), instead of the enhanced substrate transport rate. The developed enzyme immobilization method opens new possibilities for reversible activation/deactivation of enzymes and opens up new directions for targeted protein therapy and biotechnology applications.

     

Use of Gemini surfactants to stabilize TiO2 P25 colloidal dispersions

Photocatalytically active TiO₂ P25 nanoparticles, widely used for practical applications, were investigated. The nominal size of TiO₂ P25 nanoparticles is 21 nm, but they easily agglomerate in aqueous media, depending on pH and ionic strength. TiO₂ P25 aqueous dispersions were stabilized by alkanediyl-α,ω-bis-N-dodecyl-N, N′-dimethyl-ammonium bromide, cationic Gemini surfactant. The optimal conditions required to obtain stable dispersions, without formation of large agglomerates, were experienced. The stabilization of TiO₂ P25 nanoparticles by cationic Gemini surfactant was investigated in some details. Different amounts of Gemini surfactant were used, at concentrations between 1.0 and 250 × 10⁻⁶ mol L⁻¹, well below the critical micelle concentration. Dynamic light scattering and zeta potential analyses estimated the particle size and the dispersions stability. When the proper amount of Gemini surfactant was used, the resulting nanoparticles were still poly-disperse, but large agglomerates disappeared and were remarkably redispersible.     

Transition from enantioselective high performance to ultra-high performance liquid chromatography: A case study of a brush-type chiral stationary phase based on sub-5-micron to sub-2-micron silica particles

Three brush-type chiral stationary phases (CSPs) differing in the particle size of the starting silica particles have been prepared by covalent grafting of the π-acidic bis-(3,5-dinitrobenzoyl)-derivative of trans-1,2-diaminocyclohexane (DACH-DNB). Starting silica particles of 4.3, 2.6 and 1.9 micron were used to generate the final CSPs using an improved, highly reproducible synthetic methodology, that allowed to assemble and surface-graft the whole chiral selector in only two steps. The different CSPs have been packed in columns of various length and diameters, and fully characterized in terms of flow permeability, kinetic performances and enantioselectivity using a set of test solutes. Very high speed and high resolution applications together with stereodynamic HPLC examples are demonstrated on the columns with reduced particle diameters, on which separations of several enantiomeric pairs are routinely obtained with analysis times in the 15–40 s range.