Simulation of spray combustion in a lean-direct injection combustor

Large-eddy simulation (LES) of a liquid-fueled lean-direct injection (LDI) combustor is carried out by resolving the entire inlet flow path through the swirl vanes and the combustor. A localized dynamic subgrid closure is combined with a subgrid mixing and combustion model so that no adjustable parameters are required for both non-reacting and reacting LES. Time-averaged velocity predictions compare well with the measured data. The unsteady flow features that play a major role in spray dispersion, fuel–air mixing and flame stabilization are identified from the simulation data. It is shown that the vortex breakdown bubble (VBB) is smaller with more intense reverse flow when there is heat release. The swirling shear layer plays a major role in spray dispersion and the VBB provides an efficient flameholding mechanism to stabilize the flame.     

Dielectron widths of the Gamma(1S,2S,3S) resonances

We determine the dielectron widths of the Gamma(1S), Gamma(2S), and Gamma(3S) resonances with better than 2% precision by integrating the cross section of e+e- -->Gamma over the e+e- center-of-mass energy. Using e+e- energy scans of the Gamma resonances at the Cornell Electron Storage Ring and measuring Gamma production with the CLEO detector, we find dielectron widths of 1.252+/-0.004(sigma(stat))+/-0.019(sigma(syst)) keV, 0.581+/-0.004+/-0.009 keV, and 0.413+/-0.004+/-0.006 keV for the Gamma(1S), Gamma(2S), and Gamma(3S), respectively.     

Changes in the vibrational modes of carbon nanotubes induced by electron‐beam irradiation: resonance Raman spectroscopy

Influence of electron‐beam (e‐beam) irradiation on multi‐walled (MW) and single‐walled (SW) carbon nanotube films grown by microwave chemical vapor deposition technique is investigated. These films were subjected to an e‐beam energy of 50 keV from a scanning electron microscope for 2.5, 5.5, 8.0, and 15 h, and to 100 and 200 keV from a transmission electron microscope for a few minutes to ∼2 h continuously. Such conditions resemble an increased temperature and pressure regime enabling a degree of structural fluidity. To assess structural modifications, they were analyzed prior to and after irradiation using resonance Raman spectroscopy (RRS) in addition to in situ monitoring by electron microscopy. The experiments showed that with extended exposures, both types of nanotubes displayed various local structural instabilities including pinching, graphitization/amorphization, and formation of an intramolecular junction (IMJ) within the area of electron beam focus possibly through amorphous carbon aggregates. RRS revealed that irradiation generated defects in the lattice as quantified through (1) variation of the intensity of radial breathing mode (RBM), (2) intensity ratio of D to G band (I_D/I_G), and (3) positions of the D and G bands and their harmonics (D* and G*) and combination bands (D + G). The increase in the defect‐induced D band intensity, quenching of RBM intensity, and only a slight increase in G band intensity are some of the implications. The MW nanotubes tend to reach a state of saturation for prolonged exposures, while the SW ones transform from a semiconducting to a quasi‐metallic character. Softening of the q = 0 selection rule is suggested as a possible reason to explain these results. Furthermore, these studies provide a contrasting comparison between MW and SW nanotubes. Copyright © 2006 John Wiley & Sons, Ltd.     

Electrical characterization of strontium tartrate single crystals

The a.c. and d.c. conductivity of SrC₄H₄O₆·3H₂O are measured and are found to lie between usual conductivities of semiconductor and insulator. Temperature dependence of d.c. conductivity shows intrinsic conduction, which is confirmed by the slope of versus data. Due to application of thermal energy, noticeable conductivity peaks imply liberation of water molecules during dehydration and the formation of strontium oxalate. The conductivity plot has a nature similar to the intrinsic-to-extrinsic transition found in normal semiconductors. There occurs Efros hopping conduction in our samples.     

UV planar laser induced fluorescence imaging of hot carbon dioxide in a high-pressure flame

UV planar laser-induced fluorescence (PLIF) images of hot carbon dioxide (CO₂) are obtained in a laminar flame (CH₄/air) at high pressure (20 bar) with excitation wavelengths at 239.34 nm and 242.14 nm. Excitation wavelengths are chosen to minimize the contribution of nitric oxide and molecular oxygen LIF signals. Spectrally resolved single point measurements are used for correction of the remaining oxygen LIF interference. The continuum LIF signal from electronically excited CO₂ is detected in a broad (280–400 nm) emission region. The UV PLIF of hot CO₂ has the potential for application to a wide variety of diagnostic needs in high-pressure flames, combustors, and engines. PACS 42.62.Fi; 42.30.Va; 07.25+k; 39.30+w     

Plasma jets driven by ultraintense-laser interaction with thin foils

Experimental evidence of plasma jets ejected from the rear side of thin solid targets irradiated by ultraintense (>10(19) W cm(-2)) laser pulses is presented. The jets, detected by transverse interferometric measurements with high spatial and temporal resolutions, show collimated expansion lasting for several hundreds of picoseconds and have substantially steep density gradients at their periphery. The role played by radiation pressure of the laser in the jet formation process is highlighted analytically and by extensive two-dimensional particle-in-cell simulations.     

Determination of the strong phase in D0-->K+pi- using quantum-correlated measurements

We exploit the quantum coherence between pair-produced D0 and D[over]0 in psi(3770) decays to study charm mixing, which is characterized by the parameters x and y, and to make a first determination of the relative strong phase delta between D0-->K+pi- and D[over]0-->K+pi-. Using 281 pb(-1) of e+e- collision data collected with the CLEO-c detector at Ecm=3.77 GeV, as well as branching fraction input and time-integrated measurements of RM identical with (x2 + y2)/2 and RWS identical with Gamma(D0-->K+pi-)/Gamma(D[over]0-->K+pi-) from other experiments, we find cosdelta=1.03(-0.17)(+0.31)+/-0.06, where the uncertainties are statistical and systematic, respectively. By further including other mixing parameter measurements, we obtain an alternate measurement of cosdelta=1.10+/-0.35+/-0.07, as well as x sindelta=(4.4(-1.8)(+2.7)+/-2.9)x10(-3) and delta=(22(-12-11)(+11+9)) degrees .     

Binding energy effects in the decay properties of charmonia

The di-gamma and di-gluon decay widths of P-wave cc mesons are computed in nonrelativistic phenomenological quark-antiquark potential of the type V (r) =-4 3 α s r+ Ar ν with different choices of ν using spectroscopic parameters.The numerically obtained radial solutions are employed to obtain the di-gamma and di-gluon decay widths.The computed decay widths are consistent with other model predictions as well as with the known experimental values in the range of potential index 0.7 ≤ν≤ 1.1.     

Pressure dependence electrical resistivity in DVT grown molybdenum dichalcogenides

Abstract

Single crystals of MoS _x Se_2?x (x=0, 1, 2) have been grown by direct vapour transport method. Pressure-dependent d.c. electrical resistivity measurements have been carried out on the grown crystals to check the possibility of phase transition up to 8 GPa. However, no such transition is observed in the present case but a decrease in resistivity is found with increase in pressure. The observed results have been analysed and discussed on the basis of band structure.