An unexpected allomer of chlorophyll: 13(S)-hydroxy-10-methoxychlorophyll b

The allomerization of chlorophyll b in methanol produced 13²(S)-hydroxy-10-methoxychlorophyll b in a yield of ca. 8%. The formation of this allomer was totally unexpected, as 10-substituted chlorophylls have never been reported before. The structure of the new chlorophyll b derivative was determined on the basis of UV/Vis, FAB-MS, ¹H NMR and 2D ROESY NMR spectra. This letter focuses on the NMR analysis.     

Nanofibrillated cellulose/carboxymethyl cellulose composite with improved wet strength

In this paper, nanofibrillated cellulose/carboxymethyl cellulose (CMC) composite films were prepared using tape casting. The obtained transparent films showed shear induced partial alignment of fibrils along the casting direction, resulting in birefringence in cross polarized light. The carboxyl groups of CMC could be further utilized to create ionic crosslinking by treatment with glycidyl trimethyl ammonium chloride (GTMA). The GTMA treated composite films had improved mechanical properties both in wet and dry state. The chemical composition and morphologies of composites were analyzed with X-ray photoelectron spectroscopy, elemental analysis, scanning electron microscopy and wide-angle X-ray scattering.     

A comparative study of solvent extraction of total petroleum hydrocarbons in soil

Three non-specific methods for the extraction of total petroleum hydrocarbons (TPH) from soil into organic solvent were compared. The techniques used for sample preparation were Soxhlet extraction, closed-vessel microwave-assisted extraction, and CEN shake extraction. The total concentrations of extracted compounds in the boiling point range of C10–C40 were determined by gas chromatography with flame ionization detection. The best recovery (99%) and repeatability (±3%) from standard oil mixtures were obtained with microwave-assisted extraction. However, the different extraction methods exhibited different behaviour when spiked soil samples were extracted. The best repeatability was obtained with CEN shake extraction (±6%) but the repeatability values for Soxhlet and microwave-assisted methods were quite high (>20%). However, the larger uncertainties of the latter extraction methods does not necessarily limit the applicability of these methods to the determination of petroleum hydrocarbons in soil, as in the assessment of soil contamination the expanded uncertainty of the result is usually not limited by analytical uncertainty, but rather by the uncertainty of the primary sampling stage. However, distinctive variation found in the chromatographic profiles illustrates that discretion should be obeyed when chromatograms obtained after application of different extraction methods on petroleum contaminated samples are to be used in the fingerprinting or age dating studies. Otherwise, misleading conclusions concerning the age of spillage could be drawn.     

Electronic structure of the enolate anion of chlorophyll b

The enolate anion of chlorophyll b (Chl b) has been synthesized under deoxygenated conditions and its electronic structure characterized for the first time by ¹H NMR and electronic absorption spectroscopy. The formation of the enolate anion caused a marked perturbation to the 18 π-electron [18]diazaannulene aromatic pathway of Chl b. This perturbation appeared as noticeable upfield shifts, exceeding 1 ppm, for the meso-CH protons of the Chl b enolate anion. Nevertheless, the enolate anion remained diatropic, maintaining aromaticity in its delocalized macrocycle.     

Structural Changes of Cellulose Crystallites Induced by Mercerisation in Different Solvent Systems; Determined by Powder X-ray Diffraction Method

The completeness of mercerisation can be evaluated by investigating the changes in the crystalline regions of cellulose from cellulose I (C-I) to cellulose II (C-II) by the X-ray powder diffraction method. Mercerisation experiments in four different solution systems: ethanol/water, acetone, DMSO and xylene, are reported. Also the effect of some additives, external pressure, treatment time and alkalisation temperature were studied. In two-phase solvent systems, structural changes of cellulose crystallites depended primarily on the distribution and solubility of sodium hydroxide in the solvent phases. The sodium hydroxide concentration in the hydrophilic phase must exceed 7–8 w/w-% before complete crystal change from C-I to C-II can occur. The precipitation of sodium hydroxide due to high concentration prevents the successful use of one-phase ethanol/water system in slurry process. On the contrary, the 2-propanol/water/sodium hydroxide system separates into two layers; to the water-rich lower layer and the 2-propanol-rich upper layer, where the sodium hydroxide remains mainly in the water-rich lower layer. This prevents the precipitation of sodium hydroxide and promotes the alkalisation of cellulose. Ammonium chloride and ammonium hydroxide clearly had a positive effect by promoting the crystal changes, however, the urea concentration used in this study was obviously too small. In the advantageous two-phase 2-propanol/water systems, the alkalisation time was only 15 min when the treatment temperature was kept between 0 and 10 °C. Reduced external pressure was found to have a small but still detectable positive effect on cellulose alkalisation while over-pressure prevented crystal changes.     

Thermal and spectroscopic investigation of europium and samarium sulphates hydrates by TG-FTIR and ICP-MS techniques

The investigation of europium(III) sulphate hydrate and samarium(III) sulphate hydrate was performed by thermal analysis (TG-DTG) and simultaneous infrared evolved gas analysis-Fourier transformed infrared (EGA-FTIR) spectroscopy. The TG, DTG and DTA curves were recorded at the 25–1400 °C in the dynamic air atmosphere by TG/DTA analyser. The infrared evolved gas analysis was obtained on the FTIR spectrometer. Eu₂(SO₄)₃·nH₂O (n = 3.97) and Sm₂(SO₄)₃·nH₂O (n = 8.11) were analysed, the dehydration and decomposition steps were investigated and the water content was calculated. The formation of different oxysulphates was studied.

The trace rare earth elements in Eu and Sm sulphates were determined by ICP-MS. The concentration of trace Eu, Sm, La, Gd, Y and Ce ranged from 3.9 × 10⁻⁶ to 1.5 × 10⁻⁴% (m/m).     

Determination of Na(2)O from sodium aluminate NaAlO(2)

The aim of the work was to find a suitable method and conditions for determining Na(2)O wt.% from NaAlO(2). Problems were encountered while titrating NaAlO(2) with hydrochloric acid. The problematic area was the pH range 4-10 where aluminum precipitates as hydroxides. The different species of the aluminate solution were determined using potentiometric and complexometric titrations. The equivalent point of the potentiometric titration was detected using Gran's plotting method. Precipitation of aluminum hydroxides did not interfere with titrations, because in potentiometric titrations the pH value was over 10 and in complexometric titrations the pH was 4. The results were accurate and determinations were easy to carry out. Sodium was also determined by DCP-AES.     

Observation of topical catalysis by sphingomyelinase coupled to microspheres

Sphingomyelinase, SMase (EC 3.1.4.12), was coupled onto amino-derivatized acrylate microspheres and was shown to retain its catalytic activity. The immobilized enzyme allows one to carry out topical enzymatic reaction in a controlled manner. Accordingly, these spheres were held with a micropipet and using micromanipulator brought into contact with a giant liposome membrane composed of phosphatidylcholine and sphingomyelin (SOPC/C16:0-SM, 0.75:0.25, molar ratio), representing the substrate for the immobilized enzyme. The macroscopic consequences of the enzyme reaction were visualized using fluorescence microscopy as well as differential interference contrast microscopy. The surface contact of the giant vesicle and immobilized enzyme causes membrane microdomain formation and domain clustering (capping) in the membrane and subsequent shedding of small vesicles from the membrane into the interior of the giant liposome. The method described represents a novel approach to study enzymatic reactions and allows manipulating giant vesicles as well as cultured cells in a spatially controlled manner.     

A Storage Process with Local Time Input

In this paper we introduce a storage process with singular continuous input. The input process is defined as the local time of a stationary reflecting Brownian motion with drift. Many basic charateristics of the process are computed explicitly, e.g., stationary distribution, distributions of the starting and ending time of on-going busy and idle periods. We also consider the multifractal spectrum of the input process and observe that it is independent of system parameters.     

On multiplicative excessive functions of a branching Brownian motion

Summary In this note stochastic calculus is used to characterise multiplicative excessive functions of a binary branching Brownian motion with a constant creation rate. Some properties of the martingales given by invariant functions are studied. In particular, it is seen that these positive and unbounded martingales tend a.s. to 0 and are not square integrable. Informally speaking, they exhibit a clustering phenomenon in the underlying supercritical branching Brownian motion.This work was done while the author was visiting the University of British Columbia, Mathematical Department, and was partly supported by a NSERC grant. AMS 1980 subject classifications: primary 60J80, 60J65 secondary 60J60