车前子中多糖含量的测定

采用蒽酮-硫酸法比色测定，用精制车前子多糖测得车前子多糖对葡萄糖的换算因子，对我国同属不同品种的车前子不同采集时间及炮制前后其多糖含量进行了比较研究。结果表明：此测定方法简便可行。供试液在8h内显色稳定，重现性较好，平均回收率为97．8％，RSD=1．41％(n=5)。江西吉安产大粒车前子生品多糖含量在9．15％～9．83％之间，炮制后其多糖含量在6．29％～6.81％之间；南昌新祺周车前GAP标准基地的大粒车前子生品多糖含量为7.85％～8．38％，炮制后其多糖含量为6．01％～6．64％；东北产的小粒车前子生品多糖含量为6．61％，炮制后其多糖含量为6．45％。     

基于MATLAB的异步电动机线性化控制系统的仿真

从异步电动机在同步旋转坐标系下的状态方程出发，在一定的条件下，对其系数矩阵简化．推出异步电动机的线性化控制模型．并基于该模型得出异步电动机的线性化控制系统．以给定电机为例，对该模型的有效性、响应用MATLAB进行仿真分析．验证的结果说明上述模型具有实用价值．     

二元液态金属Cu-Ni和Ag-Cu凝固过程的分子动力学模拟研究

用Quantum Sutton-Chen多体势对Ag6Cu4和CuNi液态金属凝固过程进行了分子动力学模拟研究.在冷却速率2×1012到2×1014K/s范围内,CuNi总是形成fcc晶体结构,而Ag6Cu4总是形成非晶态结构.考虑到CuNi及AgCu中原子半径之比分别为1.025和1.13,那么模拟结果证实了原子的尺寸差别是非晶态合金形成的一个主要影响因素.此外采用键对及原子多面体类型指数法对凝固过程中微观结构组态变化的分析,不但能说明二十面体结构在非晶态合金形成和稳定性中所起的关键作用,又有助于对液态金属的凝固过程、非晶态结构特征的深入理解.     

环境对MgB_2氧化过程中MgO晶须生长形状的影响

用扫描电镜研究了在 Mg B2 氧化过程中环境对 Mg O晶须生长形状的影响。仅有 Mg B2 时 ,在 80 0℃左右空气气氛中 ,可生长出纳米尺寸的 Mg O晶须。若把 Mg B2 添加到氧化铝陶瓷基体中 ,则生长成竹节状晶须。Mg O晶须生长形状的差别可能是由于氧浓度以及位错等因素造成的。     

Sulfonated poly(aryl ether ketone)s containing naphthalene moieties obtained by direct copolymerization as novel polymers for proton exchange membranes

A series of sulfonated poly(aryl ether ketone)s (SPAEKs) were prepared by aromatic nucleophilic polycondensation of 2,6‐dihydroxynaphthalene with 5,5′‐carbonyl‐bis(2‐fluorobenzenesulfonate) and 4,4′‐difluorobenzophenone. The structure and degree of sulfonation (DS) of the SPAEKs were characterized using ¹H NMR spectroscopy. The experimentally observed DS values were close to the expected values derived from the starting material ratios. The thermal stabilities of the SPAEKs were characterized by thermogravimetric analysis, which showed that in acid and sodium salt forms they were thermally stable in air up to about 240 and 380 °C, respectively. Transparent membranes cast from the directly polymerized SPAEKs exhibited good mechanical properties in both dry and hydrated states. The dependence of water uptake and of membrane swelling on the DS at different temperatures was studied. SPAEK membranes with a DS from 0.72 to 1.60 maintained adequate mechanical properties after immersion in water at 80 °C for 24 h. The proton conductivity of SPAEK membranes with different degrees of sulfonation was measured as a function of temperature. The proton conductivity of the SPAEK films increased with increased DS, and the highest room temperature conductivity (4.2 × 10^?2 S/cm) was recorded for a SPAEK membrane with a DS of 1.60, which further increased to 1.1 × 10^?1 S/cm at 80 °C. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2866–2876, 2004     

Exploitation of introducing of catalytic centers into layer galleries of layered silicates and related epoxy nanocomposites. I. Epoxy nanocomposites derived from montmorillonite modified with catalytic surfactant‐bearing carboxyl groups

Montmorillonite (MMT) was modified with the acidified cocamidopropyl betaine (CAB) and the resulting organo‐montmorillonite (O‐MMT) was dispersed in an epoxy/methyl tetrahydrophthalic anhydride system to form epoxy nanocomposites. The intercalation and exfoliation behavior of the epoxy nanocomposites were examined by X‐ray diffraction and transmission electron microscopy. The curing behavior and thermal property were investigated by in situ Fourier transform infrared spectroscopy and DSC, respectively. The results showed that MMT could be highly intercalated by acidified CAB, and O‐MMT could be easily dispersed in epoxy resin to form intercalated/exfoliated epoxy nanocomposites. When the O‐MMT loading was lower than 8 phr (relative to 100 phr resin), exfoliated nanocomposites were achieved. The glass‐transition temperatures (T_g's) of the exfoliated nanocomposite were 20 °C higher than that of the neat resin. At higher O‐MMT loading, partial exfoliation was achieved, and those samples possessed moderately higher T_g's as compared with the neat resin. O‐MMT showed an obviously catalytic nature toward the curing of epoxy resin. The curing rate of the epoxy compound increased with O‐MMT loading. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 1192–1198, 2004     

新型二硫纶·菲咯啉-5，6-二酮合铜(Ⅱ)配合物的磁性研究

报道了新合成的二氰基二硫纶·菲咯啉-5，6-二酮合铜(Ⅱ)配合物CuLL′(L=mnt^2-, 1,2-dicyano-1,2-ethylenedithiolate; L′=phen-5，6-dione, 1,10-phenanthroline-5,6-dione)的变温磁化率和电子顺磁共振波谱表征结果. 发现微晶粉体型的标题配合物CuLL′具有一定的顺磁性，形成四配位的近似于方形的结构. 探讨了这种配合物磁学特性与结构的关系.     

Synthesis and Photochemical Properties of a New Substituted Phenol Covalently Linked to Ruthenium （Ⅱ） Tris-bipyridine Containing Four Ester Groups as Sensitizer

As photosensitizer for solar cell, a new ruthenium (Ⅱ) complex with four ester groups had been synthesized, in which a phenol substituted by {[(2-hydroxy-5-tert-butylbenzyl)(pyridyl-2-methyl)amino]methyl} is covalently linked to ruthenium (Ⅱ) tris-bipyridine. The structures of the new compounds were confirmed by NMR and ESI-MS spectra. The electrochemical and photochemical properties were also studied.     

Studies on the Adsorption of Asymmetrical Triblock Copolymers by Scheutjens-Fleer Theory and Monte Carlo Simulation

The adsorption of asymmetrical triblock copolymers from a non-selective solvent on solid surface has been studied by using Scheutjens-Fleer mean-field theory and Monte Carlo simulation method on lattice model. The main aim of this paper is to provide detailed computer simulation data, taking A8-kB20Ak as a key example, to study the influence of the structure of copolymer on adsorption behavior and make a comparison between MC and SF results. The simulated results show that the size distribution of various configurations and density-profile are dependent on molecular structure and adsorption energy. The molecular structure will lead to diversity of adsorption behavior. This discrepancy between different structures would be enlarged for the surface coverage and adsorption amount with increasing of the adsorption energy. The surface coverage and the adsorption amount as well as the bound fraction will become larger as symmetry of the molecular structure becomes gradually worse. The adsorption layer becomes thicker with increasing of symmetry of the molecule when adsorption energy is smaller but it becomes thinner when adsorption energy is higher. It is shown that SF theory can reproduce the adsorption behavior of asymmetrical triblock copolymers. However, systematic discrepancy between the theory and simulation still exists.The approximations inherited in the mean-filed theory such as random mixing and the allowance of direct back folding may be responsible for those deviations.     

Crystal Structures of Two Potential Tumor Imaging Agents and Therapeutic Agents Copper（Ⅱ） Ternary Complexes with Salicylidene-tyrosinato Schiff Base and Nitrogen-donor Chelating Lewis Base

The crystal structures of two potential tumor imaging agents and therapeutic agents -copper(Ⅱ) complexes with salicylidene-tyrosinato Schiff base and nitrogen-donor chelating Lewis base, [Cu(sal-tyr)(bipy)] 1 and [Cu(sal-tyr)(phen)]2CH3OH 2 are presented. Our work is helpful to get deep understanding of novel 64Cu tumor imaging agents and therapeutic agents.