二次乳化法(W/O)/W制备蛋白质流通色谱固定相的研究

以甲基丙烯酸缩水甘油酯为单体,二甲基丙烯酸乙二醇酯为交联剂,甲苯与正庚烷为有机致孔剂,20%的甘油水溶液为内水相(超孔致孔剂),利用二次乳化法制备了(W/O)/W乳液,通过紫外光引发悬浮聚合生成两类孔型高分子微球(BiPB).BiPB孔径为双峰分布,范围分别在10~100nm和1000~7300nm之间;而其体积平均粒径、比表面积、湿密度、静态吸附容量与不含超孔的微孔介质(MiPB)接近.修饰相同二乙胺密度的BiPB和MiPB介质虽在较低流速(5cm/min)下有相近的动态吸附容量,但在高流速(40cm/min)下BiPB的动态吸附容量约为MiPB的动态吸附容量的3倍,表明BiPB介质的超孔结构对孔内传质的强化作用,因而其更适合于高速的蛋白质色谱分离.     

表面增强拉曼光谱研究以4,4''''-联吡啶为标记分子的免疫检测

通过表面增强拉曼光谱(SERS)研究了标记分子4,4'-联吡啶在金溶胶上的吸附行为,并将其与山羊抗小鼠IgG结合,获得SERS标记免疫金溶胶.在固相基底上组装抗体,两者组装得到固相抗体-抗原-标记抗体“三明治”结构.在单组分和双组分体系中借助抗体上标记金纳米粒子所带的SERS信号达到免疫检测的目的.     

Two New Triterpene Lactones from the Stems of Kadsura polysperma

Two new triterpene lactones, polysperlactones A ( 2 ) and B ( 3 ), were isolated from the stems of Kadsura polysperma, together with the known compounds heteroclitalactone D ( 1 ) and schisanlactone E ( 4 ). Their structures were elucidated by spectroscopic methods, including 2D‐NMR and HR‐MS techniques. The configuration of 1 was confirmed by X‐ray analysis. Compounds 2 and 3 are members of a rare class of 3,4‐secolanostane metabolites with ring‐expanded or cyclized structures, respectively.     

Understanding effect of wall structure on the hydrothermal stability of mesostructured silica SBA-15

Mesostructured silica SBA-15 materials with different structural parameters, such as pore size, pore volume, and wall thickness, etc., were prepared by varying the postsynthesis hydrothermal treatment temperature and adding inorganic salts. The hydrothermal stabilities of these materials in steam (100% water vapor) were systematically investigated using a variety of techniques including powder X-ray diffraction, transmission electron microscopy, nitrogen sorption, and (29)Si solid-state NMR. The effect of the pore size, microporosity or mesoporosity, and wall thickness on the stability was discussed. The results show that all of the SBA-15 materials have a good hydrothermal stability under steam of 600 degrees C for at least 24 h. N(2) sorption measurements show that the Brumauer-Emmett-Teller surface area of SBA-15 materials is decreased by about 62% after treatment under steam at 600 degrees C for 24 h. The materials with thicker walls and more micropores show relatively better hydrothermal stability in steam of 600 degrees C. Interestingly, we found that the microporosity of the mesostructured silica SBA-15 is a very important factor for the hydrothermal stability. To the materials with more micropores, the recombination of Si-O-Si bonds during the high-temperature steam treatment may not cause direct destruction to the wall structure. As a result, SBA-15 materials with more micropores show better stability in pure steam of 600 degrees C. Nevertheless, these materials are easily destroyed in steam of 800 degrees C for 6 h. Two methods to effectively improve the hydrothermal stability are introduced here: one is a high-temperature treatment, and another is a carbon-propping thermal treatment. Thermal treatment at 900 degrees C can enhance the polymerization degree of Si-O-Si bonds and effectively improve the hydrothermal stability of these SBA-15 materials in 800 degrees C steam for 12 h. But, this approach will cause very serious shrinkage of the mesopores, resulting in smaller pore diameter and low surface area. A carbon-propping thermal treating method was employed to enhance the polymerization of Si-O-Si bonds and minimize the serious shrinkage of mesopores at the same time. It was demonstrated to be an effective method that can greatly improve the hydrothermal stability of SBA-15 materials in 800 degrees C steam for 12 h. Furthermore, the SBA-15 materials obtained by using the carbon-propping method possess larger pores and higher surface area after the steam treatment at 800 degrees C compared to the materials from the direct thermal treatment method after the steam treatment.     

Synthesis and structural identification of a highly ordered mesoporous organosilica with large cagelike pores

Using 1,2-bis(trimethoxysilyl)ethane as organosiloxane precursor and a triblock copolymer surfactant, Pluronic F127, as template, a highly ordered mesoporous organosilica with large cagelike pores has been successfully synthesized. Its structure was resolved to be 3-D cubic Fmm by high-resolution transmission electron microscopy. The intergrowth of hexagonal close-packed and cubic close-packed phases was observed in this material. The effect of different siliceous precursors on the mesostructure was also investigated.     

Solution-phase parallel synthesis of a pharmacophore library of HUN-7293 analogues: a general chemical mutagenesis approach to defining structure-function properties of naturally occurring cyclic (depsi)peptides

HUN-7293 (1), a naturally occurring cyclic heptadepsipeptide, is a potent inhibitor of cell adhesion molecule expression (VCAM-1, ICAM-1, E-selectin), the overexpression of which is characteristic of chronic inflammatory diseases. Representative of a general approach to defining structure-function relationships of such cyclic (depsi)peptides, the parallel synthesis and evaluation of a complete library of key HUN-7293 analogues are detailed enlisting solution-phase techniques and simple acid-base liquid-liquid extractions for isolation and purification of intermediates and final products. Significant to the design of the studies and unique to solution-phase techniques, the library was assembled superimposing a divergent synthetic strategy onto a convergent total synthesis. An alanine scan and N-methyl deletion of each residue of the cyclic heptadepsipeptide identified key sites responsible for or contributing to the biological properties. The simultaneous preparation of a complete set of individual residue analogues further simplifying the structure allowed an assessment of each structural feature of 1, providing a detailed account of the structure-function relationships in a single study. Within this pharmacophore library prepared by systematic chemical mutagenesis of the natural product structure, simplified analogues possessing comparable potency and, in some instances, improved selectivity were identified. One potent member of this library proved to be an additional natural product in its own right, which we have come to refer to as HUN-7293B (8), being isolated from the microbial strain F/94-499709.     

戊烯自由基阳离子的密度泛函理论研究

使用密度泛函理论B3LYP方法和6-31G(d,p)、6-31＋G(d,p)、6-311G(d,p)及6-311＋G(d,p)基组，分别对2-C5H10＋和1-C5H10＋的各种构象进行了几何构型优化，并用B3LYP/6-311G(d,p)进行了频率分析计算.计算预言1-C5H10＋具有非平面构型，与以往报导的从头算计算结论相反.在两个自由基阳离子的各种构象的B3LYP几何构型上，进行了B3LYP和UMP2(full)方法的超精细偶合常数计算，得到了比以往更好的结果.     

Oligomerization and Polymerization of Ethylene Initiated by a Novel Ni(Ⅱ)-Based Acetyliminopyridine Complexes as Single-Site Catalysts

Novel Ni(Ⅱ)-based acetyliminopyridine complexes 1b, 2b, 3b (1-3b), which are synthesized from ligands 1a, 2a, 3a (1-3a) and [NiCl2(DME)], are suitable precursors for the catalysts that are necessary for ethylene oligomerization and polymerization reactions, activated by methylaluminoxane (MAO). The MAO-treated 1-3b presents an active catalytic center, which may oligomerize and polymerize ethylene to produce linearα-olefins and polyethylene, respectively. The molecular weight distributions of oligomers that are obtained are in good agreement with the Schulz-Flory rules for oligomers>C4. The activity of 3b-MAO complex is 6.3×107 g/(molNi·h) at 50℃. The activities and molecular weight distributions of oligomers show significant reliance on the structures of catalyst precursors.     

Characterization and separation of Al_(13) species using gel-filtration chromatography

Polyaluminum chloride (PAC) coagulant has been developed and widely used in water and wastewater treatment industry since the 1980s[1]. PAC is normally made by partial hydrolysis of acid aluminum chloride solution using slow alkaline titration method. However, this method would result in many different Al species. Among these Al species, it seems that tridecamer (Al13O4(OH) 724 , often denoted by Al13) is the most effective and stable polymeric Al species for water and wastewater treatme…     

Quantitative Determination of Oxalic Acid Using Victoria Blue B Based on a Catalytic Kinetic Spectrophotometric Method

A sensitive catalytic method is developed for the spectrophotometric determination of oxalic acid. The procedure is based on the effect of oxalate on the oxidation of Victoria blue B by dichromate in dilute sulfuric acid medium. The reaction is quantitatively estimated by measuring the decrease in absorbance of Victoria blue B at the maximum wavelength of 610nm after quenching the reaction with tap water. The factors effecting the sensitivity and reproducibility of the reaction were studied. The method is not interfered with by foreign species generally associated with oxalate and oxalic acid. The described method is simple, specific, inexpensive and suitable for oxalic acid concentrations of between 0.06 and 9.0µgmL^–1. It was validated with satisfactory results by determining oxalic acid content in water extracts from plant materials such as spinach and Lathyrus sativus.