Analysis of the Effect of Potential Cycles on the Reflective Infrared Signals of Nitro Groups in Nanofilms: Application of the Fractional Moments Statistics

The effect of the potential cycles on the reflective IR signals of nitro‐groups in nanofilms was studied for the statistical characterization of nitrobenzene (NB) and nitroazobenzene (NAB)‐modified glassy carbon (GC) surfaces. Both NB and NAB nanofilms were obtained by the electrochemical reduction of the diazonium tetrafluoroborate salts in acetonitrile using cyclic voltammetry (CV). The modified surfaces were denoted as GC‐(NB)_n and GC‐(NAB)_n, respectively, where n indicates the number of CV cycles performed during modification. Reflective IR signals of the normalized NB and NAB nanofilms and GC were used for the quantitative evaluation of the effect of the potential cycles on the reflective IR signals of nitro‐groups in nanofilms. The detection and quantitative ‘reading’ of the influence of number of CV cycles were realized in the frame of a new error controllable approach that was applied for analysis of all available set of data. This approach includes in itself the following basic steps: (a) the procedure of the division (normalization) on the GC spectra, (b) the comparison of the smoothed spectra for their statistical proximity in the frame of the statistics of the fractional moments, (c) extraction of possible calibration parameters for possible calibration of the normalized spectra with respect to the number of CV cycles. These three basic steps are becoming effective for detection of the influence of some external factors. In our case it is important to detect the influence of the factor n characterizing CV cycles.     

Design,fabrication and characterization of a Schottky diode on an AlGaAs/GaAs HEMT structure for on-chip RF power detection

A Schottky diode was designed and fabricated on an n-AlGaAs/GaAs high electron mobility transistor (HEMT) structure for RF power detection. The processing steps used in the fabrication were the conventional steps used in standard GaAs processing. Current–voltage measurements showed that the devices had rectifying properties with a barrier height of 0.5289–0.5468 eV. The fabricated Schottky diodes detected RF signals well and their cut-off frequencies up to 20 GHz were estimated in direct injection experiments. To achieve a high cut-off frequency, a smaller Schottky contact area is required. The feasibility of direct integration with the planar dipole antenna via a coplanar waveguide transmission line without insertion of matching circuits was discussed. A higher cut-off frequency can also be achieved by reducing the length of the coplanar waveguide transmission line. These preliminary results represent a breakthrough as regards direct on-chip integration technology, towards the realization of a ubiquitous network society.     

A comparative study of lithium and sodium salts in PAN-based ion conducting polymer electrolytes

The conducting polymer electrolyte films consisting of polyacrylonitrile (PAN) as the host polymer, lithium triflate (LiCF₃SO₃) and sodium triflate (NaCF₃SO₃) as inorganic salts were prepared by the solution-cast technique. The pure PAN film was prepared as a reference. The ionic conductivity for the films is characterized using impedance spectroscopy. The room temperature conductivity for the PAN + 26 wt.% LiCF₃SO₃ film and the PAN + 24 wt.% NaCF₃SO₃ film is 3.04 × 10⁻⁴ S cm⁻¹ and 7.13 × 10⁻⁴ S cm⁻¹, respectively. XRD studies show that the complexation that has occurred in the PAN containing salt films and complexes formed are amorphous. The FTIR spectra results confirmed the complexation has taken place between the salt and the polymer. These results correspond with surface morphology images obtained from SEM analysis. The conductivity–temperature dependence of the highest conducting film from PAN + LiCF₃SO₃ and PAN + NaCF₃SO₃ systems follows Arrhenius equation in the temperature range of 303 to 353 K. The PAN containing 24 wt.% LiCF₃SO₃ film has a higher ionic conductivity and lower activation energy compared to the PAN containing 26 wt.%LiCF₃SO₃ film. These results can be explained based on the Lewis acidity of the alkali ions, i.e., the interaction between Li⁺ ion and the nitrogen atom of PAN is stronger than that of Na⁺ ion.     

Preparation and characterization of Yb-doped Ba(Ce,Zr)O<Subscript>3</Subscript> nanopowders with high sinterability

The Ba(Ce_0.8Zr_0.2)_0.95Yb_0.05O_2.975 ceramics electrolyte was prepared via a Pechini method using metal nitrate salts as starting materials. An optimum annealing temperature of 1,400 °C was needed to obtain a pure perovskite-like phase with orthorhombic structure. Particle size distribution showed a bimodal distribution that corresponds to the loose powders and agglomerates size. Scanning electron micrograph revealed that the loose powders were in the nanosize range (70–200 nm). These ultrafine loose powders enhanced the densification of a pellet with relative density ∼95% obtained at 1,400 °C. The sample formed clear and compact grains with submicron sizes. Impedance results showed that the impedance semicircle of the grain was observed only at T ≤ 250 °C. The introduction of 20 mol% Zr improved the chemical stability of BaCe_0.95Yb_0.05O_2.975 sample in atmosphere containing carbon dioxide at 600 °C. The sample also exhibited high proton conductivity in wet hydrogen.     

A Two-Dimensional Computational Droplet Contact Model

The interaction between capillary fluid films and micro-structural rough surfaces is one of the main challenges in studying self-cleaning mechanisms. The surface behavior of the deformable fluid film is governed by the Young-Laplace equation, which is highly non-linear. Therefore, a numerical solution is introduced using the finite element method, based on a continuum mechanical formulation. Surface and line contact at the fluid-structure interface are modeled by enforcing a contact constraint, and a contact angle, respectively. The numerical solution is validated against the analytical solution of a test case. (© 2011 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim)     

C.I. Reactive Orange 16-dodecylpyridinium chloride interactions in electrolytic solutions

The effect of electrolytes on the interaction between an anionic dye and a cationic surfactant was investigated spectrophotometrically in submicellar concentration range at certain temperature. The spectral change of the azo dye C.I. Reactive Orange 16 (RO16) exhibits a high sensitivity to the polarity of dye's environment. Dodecylpyridinium chloride (DPC) affects the electronic absorption spectra of dye solution that is dye-surfactant interaction results formation of complex and therefore a decrease in maximum absorption spectra (1.577 at 494 nm). The electrolyte cations cause an increase of the absorbance of DPC-RO16 ion-pair complex in the following order: Ca(2+)>Na(+)>NH(4)(+)>K(+)>Mg(2+), also for electrolyte anions Br(-)>Cl(-)>SO(4)(2-). Furthermore, this order can be changeable with increasing electrolyte concentration. The increase on absorbance value with increasing electrolyte concentration is explained as charge screening. The increase or decrease on absorption spectra of RO16-DPC solution depends on concentration range of the electrolyte added. As an increase on absorbance value with increasing electrolyte concentration is explained as charge screening, a decrease in this value for higher concentration of electrolyte is attributed as the charge of micelle shape.     

Mechanical Modeling of Particle-Droplet Interaction Motivated by the Study of Self-Cleaning Mechanisms

Motivated by the study of self-cleaning surfaces, the interaction between a spherical solid particle and a water droplet is studied on the microsale level, in terms of the balance forces and the surface properties. To define the forces acting on the solid-liquid interface, the meniscus depression is computed from the Young-Laplace equation, using a non-linear finite element formulation. The equilibrium force is derived in terms of the contact angle, particle size, and the penetration. (© 2010 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim)     

含吖啶基的新型二氧代氮杂茂并[3',4'-d]异噁唑衍生物的合成及其生物活性研究

在三乙胺的作用下,N-芳基-马来酰亚胺分别与α-氯代9-吖啶甲醛肟和N-(N,N-对二甲氨基苯基)-C-(9-吖啶基)取代硝酮发生1,3-偶极环加成反应,合成了13个未见文献报道的新型3-(9-吖啶基)-5-芳基-3a,6a-二氢-4,6-二氧代氮杂茂并[3',4'-d]异噁唑啉衍生物3a～3f和2-(N,N-对二甲氨基苯基)-3-(9-吖啶基)-5-芳基-3a,6a-二氢-4,6-二氧代氮杂茂并[3',4'-d]异噁唑烷衍生物4a～4g,其结构经1HNMR,IR和元素分析确证.并对化合物3和4进行了初步药物活性筛选,其对HL-60人白血病细胞生长具有不同程度的抑制作用,但当样品浓度为10μmol/L时,抑制率为0～35%(IC5050%).化合物3f和4g对细胞分裂周期磷酸酯酶Cdc25A具有抑制作用:当样品浓度为20μg/mL时,其抑制率分别为50.90%和51.22%.     

Devolatilization non-isothermal kinetic analysis of agricultural stalks and application of TG-FT/IR analysis

Devolatilization behavior of several types of agricultural stalks (sunflower, rice, corn, and wheat) was studied using thermogravimetric system (TG) under nitrogen atmosphere at different heating rates (10, 15, and 20 °C min^-1). Coats&Redfern, Horowitz&Metzger, and Arrhenius non-isothermal kinetic models were applied to calculate the devolatilization kinetic parameters and the devolatilization rate equations have been established. In addition, the kinetic compensation effect (KCE) has also been used to correlate pre-exponential factor (k _o) with activation energy (E _a) and an existence of the KCE is accepted. TG-FT/IR analyses were applied of the different stalks and FT/IR stack plot used to analyze the devolatilization gas products (CO₂, CH₄, HCOOH, CH₃OH). Infrared vibrational frequencies, micro structure and crystallinity of stalks were investigated by Fourier transform infrared spectroscopy (FT/IR), scanning electron microscope (SEM), and X-ray diffraction analysis (XRD), respectively.