An optically resolved crystal of thiomalate: (S)‐1‐phenylethanaminium (R)‐thiomalate

The asymmetric unit of the optically resolved title salt, C₈H₁₂N⁺·C₄H₅O₄S⁻, contains a 1‐phenylethanaminium monocation and a thiomalate (3‐carboxy‐2‐sulfanylpropanoate) monoanion. The absolute configurations of the cation and the anion are determined to be S and R, respectively. In the crystal, cation–anion N—H...O hydrogen bonds, together with anion–anion O—H...O and S—H...O hydrogen bonds, construct a two‐dimensional supramolecular sheet parallel to the ab plane. The two‐dimensional sheet is linked with the upper and lower sheets through C—H...π interactions to stack along the c axis.     

Formation of nanotubes TiO2 from layered titanate particles by a soft chemical process

Nanotubes TiO₂ were synthesized from layered titanate Na₂Ti₃O₇ particles by a soft chemical process. These nanotubes have a hollow structure with an opening end. The wall of nanotubes is very well crystallized multi-wall structure. The inner diameters of nanotubes are ca. 30-40 nm and the length up to several hundreds nanometers. XRD results show that TiO₂ phase was formed during the procedure of exfoliating Na₂Ti₃O₇ particles into nanosheets. Based on our experimental results, an exfoliating-rolling model was proposed for formation of nanotube structure.     

Pulsed laser deposited iron fluoride thin films for lithium-ion batteries

Iron fluoride thin films were successfully grown by Pulsed Laser Deposition (PLD), and their physico-chemical properties and electrochemical behaviours were examined by adjusting the deposition conditions, such as the target nature (FeF₂ or FeF₃), the substrate temperature (T_s ≤ 600 °C), the gas pressure (under vacuum or in oxygen atmosphere) and the repetition rates (2 and 10 Hz). Irrespective of the FeF₂ or FeF₃ target nature, iron fluoride thin films, deposited at 600 °C under vacuum, showed X-ray diffraction (XRD) patterns corresponding to the FeF₂ phase. On the other hand, iron fluoride thin films deposited at room temperature (RT) from FeF₂ target were amorphous, whereas the thin films deposited from FeF₃ target consisted of a two-phase mixture of FeF₃ and FeF₂ showing sharp and broad diffraction peaks by XRD, respectively. Their electrochemical behaviour in rechargeable lithium cells was investigated in the 0.05-3.60 V voltage window. Despite a large irreversible capacity on the first discharge, good cycling life was observed up to 30 cycles. Finally, their electrochemical properties were compared to the ones of iron oxide thin films.     

Cobalt and tantalum additions for enhanced electrochromic performances of nickel-based oxide thin films grown by pulsed laser deposition

Aiming at improving the durability of anodic electrochromic nickel oxide thin films, Ni-M-O (M = Co, Ta) thin films were grown by pulsed laser deposition (PLD), using optimized conditions, namely room temperature and 10⁻¹ mbar oxygen pressure. For low Co and Ta contents (<5%), both additions lead to a loss of the [1 1 1] preferred orientation of the NiO rock-salt structure followed by a film amorphization with increasing Ta amount. Among the two series of metal additions (M ≤ 20%), the Ni-Co-O (5% Co) and Ni-Ta-O (10% Ta) thin films show the highest electrochemical performances especially in respect of improved durability. If the enhanced properties are associated with a limited dissolution of the oxidized phase for the Ni-Ta-O system, the opposite trend is observed for the Ni-Co-O system as compared to pure NiO.     

A charge-separation-type ionic solid composed of hexanuclear complexes with a macrocyclic tetragold(I) metalloligand

The reaction of Na[Co^III(d -ebp)] (d -H₄ebp = N,N′-ethylenebis[d -penicillamine]) with [(Au^ICl)₂(dppe)] (dppe = 1,2-bis[diphenylphosphino]ethane) gave a cationic Au^I₄Co^III₂ hexanuclear complex, [Co^III₂(L^Au4)]²⁺ ([ 1 ]²⁺), where [L^Au4]⁴⁻ is a cyclic tetragold(I) metalloligand with a 32-membered ring, [Au^I₄(dppe)₂(d -ebp)₂]⁴⁻. Complex [ 1 ]²⁺ crystallized with NO₃⁻ to produce a charge-separation (CS)-type ionic solid of [ 1 ](NO₃)₂. In [ 1 ](NO₃)₂, the complex cations are assembled to form cationic supramolecular hexamers of {[ 1 ]²⁺}₆, which are closely packed in a face-centered cubic (fcc) lattice structure. The nitrate anions of [ 1 ](NO₃)₂ were accommodated in hydrophilic and hydrophobic tetrahedral interstices of the fcc structure to form tetrameric and hexameric nitrate clusters of {NO₃⁻}₄ and {NO₃⁻}₆, respectively. An analogous CS-type ionic solid formulated as [Ni^IICo^III(L^Au4)](NO₃) ([ 2 ](NO₃)) was obtained when a 1:1 mixture of Na[Co^III(d -ebp)] and [Ni^II(d -H₂ebp)] was reacted with [(Au^ICl)₂(dppe)], accompanied by the conversion of the diamagnetic, square-planar [Ni^II(d -H₂ebp)] to the paramagnetic, octahedral [Ni^II(d -ebp)]²⁻. While the overall fcc structure in [ 2 ](NO₃) was similar to that of [ 1 ](NO₃)₂, none of the nitrate anions were accommodated in any hydrophobic tetrahedral interstice, reflecting the difference in the complex charges between [ 1 ]²⁺ and [ 2 ]⁺.     

Formation,Expansion, and Interconversion of Metallarings in a Sulfur‐Bridged AuICoIII Coordination System

A novel Au^ICo^III coordination system that is derived from the newly prepared [Co(D ‐nmp)₂]^? ( 1 ^?; D ‐nmp=N‐methyl‐D ‐penicillaminate) and a gold(I) precursor Au^I is reported. Complex 1 ^? acts as a sulfur‐donating metallaligand and reacts with the gold(I) precursor to give [Au₂Co₂(D ‐nmp)₄] ( 2 ), which has an eight‐membered Au^I₂Co^III₂ metallaring. Treatment of 2 with [Au₂(dppe)₂]²⁺ (dppe=1,2‐bis(diphenylphosphino)ethane) leads to the formation of [Au₄Co₂(dppe)₂(D ‐nmp)₄]²⁺ ( 3 ²⁺), which consists of an 18‐membered Au^I₄Co^III₂ metallaring that accommodates a tetrahedral anion (BF₄^?, ClO₄^?, ReO₄^?). In solution, the metallaring structure of 3 ²⁺ is readily interconvertible with the nine‐membered Au^I₂Co^III metallaring structure of [Au₂Co(dppe)(D ‐nmp)₂]⁺ ( 4 ⁺); this process depends on external factors, such as solvent, concentration, and nature of the counteranion. These results reveal the lability of the Au? S and Au? P bonds, which is essential for metallaring expansion and contraction.     

Single‐Crystal‐to‐Single‐Crystal Installation of Ln4(OH)4 Cubanes in an Anionic Metallosupramolecular Framework

Postsynthetic installation of lanthanide cubanes into a metallosupramolecular framework via a single‐crystal‐to‐single‐crystal (SCSC) transformation is presented. Soaking single crystals of K₆[Rh₄Zn₄O(l ‐cys)₁₂] (K₆[ 1 ]; l ‐H₂cys=l ‐cysteine) in a water/ethanol solution containing Ln(OAc)₃ (Ln³⁺=lanthanide ion) results in the exchange of K⁺ by Ln³⁺ with retention of the single crystallinity, producing Ln₂[ 1 ] ( 2_Ln ) and Ln_0.33[Ln₄(OH)₄(OAc)₃(H₂O)₇][ 1 ] ( 3_Ln ) for early and late lanthanides, respectively. While the Ln³⁺ ions in 2_Ln exist as disordered aqua species, those in 3_Ln form ordered hydroxide‐bridged cubane clusters that connect [ 1 ]^6? anions in a 3D metal‐organic framework through coordination bonds with carboxylate groups. This study shows the utility of an anionic metallosupramolecular framework with carboxylate groups for the creation of a series of metal cubanes that have great potential for various applications, such as magnetic materials and heterogeneous catalysts.     

A simple method to detect audible echoes in room acoustical design

A simple method to detect audible echoes is proposed as an objective criterion for room acoustics. This method evaluates the perceptibility of sound reflections that are generated by an impulsive sound source and identifies from reflectograms harmful reflections perceived as echoes. Particularly with this method, the masking effect of reverberation is taken into consideration, which cannot be treated sufficiently by the existing objective criteria. The applicability to room acoustical design is verified by evaluating the impulse responses measured in real halls where audible echoes occurred. It is shown that the proposed method detects audible echoes at an accuracy of more than 90% and would be suitable for practical use.     

Synthesis of novel perfluorosulfonamide monomers and their application

The novel perfluorosulfonamide monomers and their preparation methods have been developed. The ternary-copolymer membranes, utilizing the perfluorosulfonamide monomers as the cross-linking site, can be efficiently converted to the cross-linked membranes with the strictly controlled structure. The novel cross-linking method has proved to be effective for the improvement of the mechanical properties at high temperature, while keeping its high proton conductivity.     

Controlled Formation of Thiol‐Thiolate Hydrogen versus Disulfide Bonds between Two Iridium(III) Centers

Here, we report an iridium(III) coordination system with 2‐aminoethanethiolate (aet), which shows the formation of S?H???S hydrogen and S?S disulfide bonds in a controlled manner. Treatment of fac‐[Ir(aet)₃] with aqueous HBF₄ under aerobic conditions gave dinuclear [Ir₂(aet)₄(cysta)]²⁺ ([ 1 ]²⁺; cysta=cystamine) with a single S?S disulfide bond, while dimeric [Ir₂(aet)₃(Haet)₃](BF₄)₃ ([ 2 ](BF₄)₃) with a triple S?H???S hydrogen bond was formed by similar treatment under anaerobic conditions. Upon exposure to air, [ 2 ]³⁺ was converted to dinuclear [Ir₂(aet)₂(Haet)₂(cysta)]⁴⁺ ([ 3 ]⁴⁺), in which two Ir^III centers are spanned by a double S?H???S hydrogen bond and a single S?S disulfide bond. Complex [ 3 ]⁴⁺ was interconvertible with [ 1 ]²⁺ via the removal/addition of protons on S donors, accompanied by the intermolecular exchange of the fac‐[Ir(aet)₃] units. Complexes [ 1 ]²⁺, [ 2 ]³⁺, and [ 3 ]⁴⁺, isolated as BF₄^? salts, were fully characterized by single‐crystal X‐ray crystallography.