A finite model property for RMImin

It is proved that the variety of relevant disjunction lattices has the finite embeddability property. It follows that Avron's relevance logic RMI _min has a strong form of the finite model property, so it has a solvable deducibility problem. This strengthens Avron's result that RMI _min is decidable. (© 2006 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

不同入射角度下强流脉冲电子束能量沉积剖面和束流传输系数模拟计算

 强流脉冲电子束在材料中的能量沉积剖面、能量沉积系数和束流传输系数受其入射角的影响很大，理论计算了0.5~2.0MeV的电子束以不同的入射角在Al材料中的能量沉积剖面和能量沉积系数，并且还计算了0.4~1.4MeV电子束以不同入射角穿透不同厚度C靶的束流传输系数。计算结果表明，随着入射角的增大，靶材表面层单位质量中沉积的能量增大，电子在靶材料中穿透深度减小，能量沉积系数减小，相应的束流传输系数也减小；能量为0.5~2.0MeV的电子束当入射角在60°~70°时在材料表面层单位质量中沉积的能量较大。     

Rheological and physical properties of aliphatic hyperbranched polyesters

The effects of the size (pseudo‐generation number) and nature of end groups on physical and rheological properties were investigated for a series of hyperbranched polyesters based on an ethoxylated pentaerythritol core and 2,2‐bis‐(hydroxymethyl)propionic acid repeat units. The observed linear dependence of the melt viscosity on the molar mass in the high pseudo‐generation‐number limit indicated that entanglement effects were substantially absent. Moreover, the marked influence of end capping of the end groups on the physical and rheological properties suggested that intermolecular interactions were dominated by contacts between the outer shells of the molecules, in which the end groups were assumed to be concentrated. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 1218–1225, 2004     

Random oscillations in the Van der Pol system under the action of a broadband random process

We construct the second approximation for random oscillations described by the Van der Pol equation which are under the action of a broadband random process. Translated from Ukrainskii Matematicheskii Zhurnal, Vol. 50, No. 11, pp. 1517–1521, November, 1998.     

Interfacial structure and electrical properties of LaAlO3 gate dielectric films on Si by metalorganic chemical vapor deposition

LaAlO₃ (LAO) gate dielectric films were deposited on Si substrates by low-pressure metalorganic chemical vapor deposition. The interfacial structure and composition distribution were investigated by high-resolution transmission electron microscopy (HRTEM), X-ray photoelectron spectroscopy (XPS), secondary-ion mass spectroscopy (SIMS), and Auger-electron spectroscopy (AES). HRTEM confirms that there exists an interfacial layer between LAO and Si in most samples. AES, SIMS, and XPS analyses indicate that the interfacial layer is compositionally graded La–Al silicate and the Al element is severely deficient close to the Si surface. Electrical properties of LAO films were evaluated. No evident difference in electrical properties between samples with and without native SiO₂ layers was observed. The electrical properties are discussed in terms of LAO growth mechanisms, in relation to the interfacial structure. PACS 73.40.Qv; 81.15.Gh; 77.55.+f; 68.35.-p     

Surface and interfacial properties of PVDF/acrylic copolymer blends before and after UV exposure

Morphological and chemical properties of both the surface and interface of poly(vinylidene fluoride)/poly(methyl methacrylate)-co-poly(ethyl acrylate) (PVDF/PMMA-co-PEA) blend films have been investigated before and after the samples were exposed to ultraviolet (UV) irradiation using a xenon arc lamp at 50 °C and 9% relative humidity (RH) for 7 months. Surface and interfacial morphologies were studied by atomic force microscopy (AFM). Chemical composition information was obtained by confocal Raman microscopy, attenuated total reflection-FTIR spectroscopy (ATR-FTIR), X-ray photoelectron spectroscopy (XPS), and contact angle measurements. Results show an enrichment of the PVDF material at the air surface, while the acrylic copolymer enriches the interface. Blends having greater than 50% mass fraction of PVDF show little change in the surface morphology after UV exposure for 7 months. However, for a lower PVDF content, blends exhibit significant degradation of PMMA-co-PEA copolymer and a much rougher surface after UV exposure. Microstructural changes in the PVDF spherulites are also observed after UV degradation. It is found that the surface and interfacial morphologies are correlated with the chemical properties.     

Direct measurement of fluid velocity gradients at a wall by PIV image processing with stereo reconstruction

Velocity gradient is typically estimated in Particle Image Velocimetry (PIV) by differentiating a measured velocity field, which amplifies noise in the measured velocities. If gradients near a boundary are sought, such noise is usually greater than in bulk fluid, because of small tracer displacement, uncertainty in the effective positions of velocity vectors, intense deformation of tracer patterns, and laser reflection. We consider here a modified form of the Particle Image Distortion (PID) method todirectly calculate velocity gradients at a fixed wall, and refer it as “PIV/IG” (“Interface Gradiometry”). Results from synthetic 2D PIV images suggest our method achieves higher SNR and accuracy than velocity differentiation. Also, we have developed a procedure to reconstruct three-dimensional velocity gradient at a fixed wall the two non-zero components from PIV/IG data obtained in stereo views; these equations simplify considerably thanks to the no-slip condition. Experimental data from the bottom wall of turbulent open channel flow appear to suffer from a form of pixel locking. As with standard PIV, this underlines the importance of adequate tracer diameter in the images, sufficient seeding density, and of dynamic range of the camera sensor.     

Using the gradients of temperature and internal parameters in Continuum ThermodynamicsIntroduction des gradients de température et de paramètres internes en Thermodynamique des Milieux Continus

In this paper, the possibility of using the gradients of the temperature and of the internal parameters as additional state variables in Continuum Thermodynamics is considered. The expressions of the two principles are discussed and Clausius–Duhem inequality is derived under an appropriate statement of the internal entropy production. Several formulations are proposed and compared to existing results in the literature. To cite this article: P. Ireman, Q.S. Nguyen, C. R. Mecanique 332 (2004).