Determination of hydroxycinnamic acids and volatile phenols in wort and beer by isocratic high-performance liquid chromatography using electrochemical detection

The suitability of a simple and rapid isocratic RP-HPLC method with amperometric electrochemical detection for the simultaneous detection and quantification of hydroxycinnamic acids and their corresponding aroma-active volatile phenols in wort and beer is reported. The technique gives good specificity and sensitivity, and can therefore be used for routine monitoring of hydroxycinnamic acids in wort and the development of volatile phenolic flavour compounds during the beer production process and subsequent conservation.     

Screening approach for chiral separation of pharmaceuticals IV. Polar organic solvent chromatography

The aim of this work is to determine generic screening conditions and an initial simple separation strategy allowing the rapid separation of drug enantiomers in polar organic solvent chromatography (POSC). Four cellulose/amylose-based stationary phases were investigated in detail using two mobile phase basis solvents commonly applied in this mode, i.e. acetonitrile and methanol. Polar mode is interesting for use in purification of enantiomers. In a first step, the parameters potentially influencing the separation, such as addition of an alcohol to the polar organic solvent or the type of mobile phase additive(s), were examined by means of experimental designs. Afterwards, the factors found most important are investigated in more detail. Results showed that the cellulose- and amylose-based stationary phases have very broad and complementary enantiorecognition abilities in the POSC mode. The type of organic solvent for the mobile phase appeared to have a dramatic influence on the quality of the separation. Based on the results, a screening strategy was proposed. Enantioseparation was observed in more than 85% of the tested compounds and analysis times of last eluted peak were usually below 10 min.     

Fire retardancy of polymer clay nanocomposites: Is there an influence of the nanomorphology?

The obvious aspect of nanodispersion and its role when investigating fire retardancy is not often clearly commented upon in the literature. Polymer clay nanocomposites can exhibit different morphologies and these might have consequences for their fire behaviour. Using solid state NMR to quantify the nanodispersion of organoclay in polyamide-6 (PA-6), we have prepared by melt blending PA-6/clay nanocomposite exhibiting different nanomorphologies. NMR results are consistent with transmission electron microscopy (TEM) images but the advantage of NMR is that it is representative of the whole sample and provides a precise quantification. PA-6 nanocomposites exhibit significant reduction of PHRR but the nanomorphology (exfoliation, intercalation and presence of tactoids) does not play any significant role. In other words, we have clearly shown that if nanodispersion is achieved, polymer/clay nanocomposite should exhibit fire retardant properties.     

Quantitative analysis of delta9-tetrahydrocannabinol in preserved oral fluid by liquid chromatography-tandem mass spectrometry

A rapid and sensitive method for the analysis of delta9-tetrahydrocannabinol (THC) in preserved oral fluid was developed and fully validated. Oral fluid was collected with the Intercept, a Food and Drug Administration (FDA) approved sampling device that is used on a large scale in the U.S. for workplace drug testing. The method comprised a simple liquid-liquid extraction with hexane, followed by liquid chromatography-tandem mass spectrometry (LC-MS-MS) analysis. Chromatographic separation was achieved using a XTerra MS C18 column, eluted isocratically with 1 mM ammonium formate-methanol (10:90, v/v). Selectivity of the method was achieved by a combination of retention time, and two precursor-product ion transitions. The use of the liquid-liquid extraction was demonstrated to be highly effective and led to significant decreases in the interferences present in the matrix. Validation of the method was performed using both 100 and 500 MicroL of oral fluid. The method was linear over the range investigated (0.5-100 ng/mL and 0. 1-10 ng/mL when 100 and 500 microL, respectively, of oral fluid were used) with an excellent intra-assay and inter-assay precision (relative standard deviations, RSD <6%) for quality control samples spiked at a concentration of 2.5 and 25 ng/mL and 0.5 and 2.5 ng/mL, respectively. Limits of quantification were 0.5 and 0.1 ng/mL when using 100 and 500 microL, respectively. In contrast to existing GC-MS methods, no extensive sample clean-up and time-consuming derivatisation steps were needed. The method was subsequently applied to Intercept samples collected at the roadside and collected during a controlled study with cannabis.     

How thermal curing of an organic paper coating changes topography, chemistry, and wettability

Celluloses are preferred renewable substrates, but hydrophilicity and porosity disfavor their water resistance. We present here an ecofriendly application of imidized nanoparticles and a method to flexibly tune the surface wettability of papers. The soft nanostructured coating is sensitive to thermal curing, which affects both the surface chemistry and morphology. The thermal stability of the coating is first investigated with conventional and modulated differential scanning calorimetry, revealing influences of the imide content and an endotherm reaction below the glass transition temperature at 120-150 °C. The latter is studied in detail for an appropriate selection of the copolymer precursors. According to diffuse reflection infrared spectroscopy, Raman spectroscopy, and UV/vis spectroscopy, the endotherm corresponds to an imidization reaction. The morphology of the coatings is followed at various scale levels by contactless roughness measurements and atomic force microscopy. Finally, the experimental values are fitted to the parameters of the Wenzel wetting model, and so-called calibration curves for the relation between contact angles, surface roughness, and surface chemistry are presented. They allow the prediction of the water contact angle of coated papers from the hydrophilic to the hydrophobic range, with a maximum in hydrophobicity after increasing the imide content at 120-150 °C curing.     

Bioanalytical procedures for determination of drugs of abuse in oral fluid

Recent advances in analytical techniques have enabled the detection of drugs and drug metabolites in oral fluid specimens. Although GC–MS is still commonly used in practice, many laboratories have developed and successfully validated methods for LC–MS(–MS) that can detect a large number of compounds in the limited sample volume available. In addition, several enzyme immunoassays have been commercialized for the detection of drugs of abuse in oral fluid samples, enabling the fast screening and selection of presumably positive samples. A number of concerns are discussed, such as the variability in the volume of sample collected and its implications in terms of quantitative measurements, and the drug recoveries of the many different specimen collection systems on the market. Additional considerations that also receive attention are the importance of providing complete validation data with respect to analyte stability, matrix effect, and the choice of collection method.     

Second‐order non‐linear optical polymers

In this article we discuss the state of the art in the field of second‐order non‐linear optical polymers. More specifically, we highlight those results that we think made an important contribution to the field, combined with some of our own results. We start with a general overview of all the aspects involved in characterizing second‐order non‐linear optical polymers, from thin film formation and poling to second‐harmonic generation and electro‐optic measurements on such systems. Next, we review the second‐order non‐linear optical properties of selected polymer systems such as poly(vinyl ether)s, polystyrenes, polymethacrylates, main‐chain polymers and high T_g polymers like polyimides and polymaleimides. Finally, we discuss some new polymer systems that might become important in the field of non‐linear optics in the near future.     

Evolution of Molecular Weight and Long Chain Branch Distributions in Olefin–Diene Copolymerization

A model for olefin–diene copolymerization and long chain branch formation was developed. The model shows that the number‐average molecular weight and branching density increases linearly with time in a semi‐batch polymerization, while the polydispersity depends on the diene content in the polymer and on the polymerization time. For low diene fractions or low polymerization times, the polydispersity increases linearly with time. For higher diene contents, the polydispersity increases exponentially with polymerization time after a critical polymer concentration is reached. The calculated distributions of branched species indicate that diene content influences the amount of highly branched chains produced in the polymerization, markedly broadening the distribution of molecular weight and leading to gel formation.

Weight distribution of branched species after 30 min of polymerization.     

The Generalized Clifford-Gegenbauer Polynomials Revisited

By applying a method introduced by De Bie and Sommen in Clifford superanalysis, the orthogonality relations of the generalized Clifford–Gegenbauer polynomials of wavelet analysis are extended. Moreover, this new approach allows for proving new important properties of these polynomials, such as an annihilation equation, a differential equation and an expression in terms of the Jacobi polynomials on the real line. This paper is dedicated to the memory of our friend and colleague Jarolim Bureš