Distinction between surface hydroxyl and ether groups on boron-doped diamond electrodes using a chemical approach

While it is clearly established that oxidation of as-grown boron-doped diamond (BDD) interfaces results in the introduction of different surface oxygen functions such as ether, carbonyl and hydroxyl groups, there is no reported approach which can clearly distinguish between the different surface functions. For further surface functionalization, it is important to quantify the presence of each group on the diamond surface. In this paper, the presence and amount of surface hydroxyl groups is identified using esterification of the COH groups with trifluoroacetic acid. The presence of CF₃ group in the acid allowed the identification and estimation of the amount of surface hydroxyl groups using X-ray photoelectron spectroscopy (XPS).     

Epoxy-functionalized large-pore SBA-15 and KIT-6 as affinity chromatography supports

Mesoporous silica supports are proposed as an alternative to polymeric stationary phases for fast affinity chromatography due to their better mechanical strength compared to polymers. Ideal supports should combine high surface area and large pore size to allow a high loading capacity of large molecules, such as proteins, and favor their accessibility. Increasing the pore size of large-surface area micelle-templated silicas (SBA-15, KIT-6) has been achieved by swelling the micelles by the addition of organic molecules and increasing synthesis time and temperature. The pore size of hexagonal silica mesostructured SBA-15 has been increased up to 35 nm. These materials could find therefore application as affinity chromatography for immunoextraction.     

Bacteria encapsulation in colloidal inorganic matrices: Is it a general method?

Zirconium oxyhydroxide nanoparticles prepared by an aqueous route were evaluated for Escherichia coli bacteria encapsulation. A low viability rate was measured 24 hours after immobilization that could be attributed to nanoparticle cytotoxicity. Moreover, the presence of glycerol, a long-term cell-preserving molecule, hindered gel formation, probably due to its adsorption on the nanoparticle surface. A comparison with boehmite and ferrihydrite gels previously synthesized following a similar aqueous colloidal route suggests that the generalization of this method will rely on a careful control of the nanoparticle surface reactivity and may require surface chemical modification.     

A bioinformatics approach to the development of immunoassays for specified risk material in canned meat products

A bioinformatics approach to developing antibodies to specific proteins has been evaluated for the production of antibodies to heat-processed specified risk tissues from ruminants (brain and eye tissue). The approach involved the identification of proteins specific to ruminant tissues by interrogation of the annotation fields within the Swissprot database. These protein sequences were then interrogated for peptide sequences that were unique to the protein. Peptides were selected that met these criteria as close as possible and that were also theoretically resistant to either pepsin or trypsin. The selected peptides were synthesised and used as immunogens to raise monoclonal antibodies. Antibodies specific for the synthetic peptides were raised to half of the selected peptides. These antibodies have each been incorporated into a competitive enzyme-linked immunosorbent assay (ELISA) and shown to be able to detect the heat-processed parent protein after digestion with either pepsin or trypsin. One antibody, specific for alpha crystallin peptide (from bovine eye tissue), was able to detect the peptide in canned meat products spiked with 10% eye tissue. These results, although preliminary in nature, show that bioinformatics in conjunction with enzyme digestion can be used to develop ELISA for proteins in high-temperature processed foods and demonstrate that the approach is worth further study.     

Nickel(II) meso‐Hydroxyporphyrin Complexes Revisited: Palladium‐Catalysed Synthesis,Electronic Structures of Derived Oxy Radicals,and Oxidative Coupling to a Dioxoporphodimethene Dyad

We report the synthesis and characterisation of new examples of meso‐hydroxynickel(II) porphyrins with 5,15‐diphenyl and 10‐phenyl‐5,15‐diphenyl/diaryl substitution. The OH group was introduced by using carbonate or hydroxide as nucleophile by using palladium/phosphine catalysis. The NiPor?OHs exist in solution in equilibrium with the corresponding oxy radicals NiPor?O^.. The 15‐phenyl group stabilises the radicals, so that the ¹H NMR spectra of {NiPor?OH} are extremely broad due to chemical exchange with the paramagnetic species. The radical concentration for the diphenylporphyrin analogue is only 1 %, and its NMR line‐broadening was able to be studied by variable‐temperature NMR spectroscopy. The EPR signals of NiPor?O^. are consistent with somewhat delocalised porphyrinyloxy radicals, and the spin distributions calculated by using density functional theory match the EPR and NMR spectroscopic observations. Nickel(II) meso‐hydroxy‐10,20‐diphenylporphyrin was oxidatively coupled to a dioxo‐terminated porphodimethene dyad, the strongly red‐shifted electronic spectrum of which was successfully modelled by using time‐dependent DFT calculations.     

Unraveling σ and π Effects on Magnetic Anisotropy in cis‐NiA4B2 Complexes: Magnetization,HF‐HFEPR Studies,First‐Principles Calculations,and Orbital Modeling

By using complementary experimental techniques and first‐principles theoretical calculations, magnetic anisotropy in a series of five hexacoordinated nickel(II) complexes possessing a symmetry close to C_2v, has been investigated. Four complexes have the general formula [Ni(bpy)X₂]ⁿ⁺ (bpy=2,2′‐bipyridine; X₂=bpy ( 1 ), (NCS^?)₂ ( 2 ), C₂O₄^2? ( 3 ), NO₃^? ( 4 )). In the fifth complex, [Ni(HIM₂‐py)₂(NO₃)]⁺ ( 5 ; HIM₂‐py=2‐(2‐pyridyl)‐4,4,5,5‐tetramethyl‐4,5‐dihydro‐1H‐imidazolyl‐1‐hydroxy), which was reported previously, the two bpy bidentate ligands were replaced by HIM₂‐py. Analysis of the high‐field, high‐frequency electronic paramagnetic resonance (HF‐HFEPR) spectra and magnetization data leads to the determination of the spin Hamiltonian parameters. The D parameter, corresponding to the axial magnetic anisotropy, was negative (Ising type) for the five compounds and ranged from ?1 to ?10 cm^?1. First‐principles SO‐CASPT2 calculations have been performed to estimate these parameters and rationalize the experimental values. From calculations, the easy axis of magnetization is in two different directions for complexes 2 and 3 , on one hand, and 4 and 5 , on the other hand. A new method is proposed to calculate the g tensor for systems with S=1. The spin Hamiltonian parameters (D (axial), E (rhombic), and g_i) are rationalized in terms of ordering of the 3 d orbitals. According to this orbital model, it can be shown that 1) the large magnetic anisotropy of 4 and 5 arises from splitting of the e_g‐like orbitals and is due to the difference in the σ‐donor strength of NO₃^? and bpy or HIM₂‐py, whereas the difference in anisotropy between the two compounds is due to splitting of the t_2g‐like orbitals; and 2) the anisotropy of complexes 1 – 3 arises from the small splitting of the t_2g‐like orbitals. The direction of the anisotropy axis can be rationalized by the proposed orbital model.     

Reversible Silylene Insertion Reactions into Si−H and P−H σ‐Bonds at Room Temperature

Phosphine‐stabilized silylenes react with silanes and a phosphine by silylene insertion into E?H σ‐bonds (E=Si,P) at room temperature to give the corresponding silanes. Of special interest, the process occurs reversibly at room temperature. These results demonstrate that both the oxidative addition (typical reaction for transient silylenes) and the reductive elimination processes can proceed at the silicon center under mild reaction conditions. DFT calculations provide insight into the importance of the coordination of the silicon center to achieve the reductive elimination step.     

A stepwise approach to the formation of heterometallic discrete complexes and infinite architectures

A strategy for the controlled construction of heterobimetallic discrete complexes and 1-D coordination networks is presented. The organic ligand based on the methanedithiolate group and the 4,5-diazafluorene moiety behaving as primary and secondary coordination poles respectively leads to the formation of a series of discrete metal complexes with various geometries via binding through the dithiolate site. The observed coordination geometries range from square-planar for Ni(ii) and Pd(ii) to distorted tetrahedral for Zn(ii) and Hg(ii). The square-planar Pd(ii) complex affords a discrete bimetallic trinuclear complex when treated with a capped Ni(ii) center. All three Ni(ii), Pd(ii) and Hg(ii) discrete complexes have been also shown to behave as metallatectons leading to the generation of infinite networks in the presence of bridging cations such as sodium.     

Determination of polydimethylsiloxane-air partition coefficients using headspace sorptive extraction

Polydimethylsiloxane-air partition coefficients (K(PDMS-A)) were determined using direct headspace analysis and headspace sorptive extraction (HSSE) with polydimethylsiloxane-coated (PDMS) stir bars. The partition coefficients were investigated for three compounds, p-dichlorobenzene (PDCB), naphthalene and camphor, all of which sublimate at room temperature and find use as moth repellents. In order to determine the K(PDMS-A) values of these compounds, the air concentration and the concentration present on PDMS, both at equilibrium, were measured. The results indicate that PDMS-air partition coefficients are proportional to octanol-air partition coefficients. Thus, the latter could be used to estimate the extraction efficiency of PDMS for these compounds in air. Alternatively, octanol-air partition coefficients for organic compounds could be estimated from the PDMS-air partition coefficient values. As expected, the PDMS-air (or octanol-air) partition coefficient increased with decreasing temperature. Importantly, the partition coefficients determined at saturated vapor pressures were lower than the values determined at lower analyte concentrations, with the differences being greater for compounds with larger partition coefficients. Consequently, caution should be exercised when applying K(PDMS-A) values determined at high analyte concentrations to measurements at lower concentrations, especially when the partition coefficients are large.