Solid solubility of Ge,Si, and Mg in Fe2O3 and photoelectric behavior

Solid solutions of GeO₂ in Fe₂O₃ were prepared by mechanically mixing the solids and firing at 1000°C in air, and from a gel obtained by the addition of an alcohol solution of germanium ethoxide to iron dissolved in HNO₃. The dried gel was then heated at 1000°C. The solubility limit is 5 mole% GeO₂, Fe_1.95Ge_0.05O₃. Similar procedures were used to prepare solid solutions with Si and the solubility limit is greater than 4 mole% SiO₂. Firing of mixtures or gels of Fe₂O₃ containing Mg produces a spinel phase even at the lowest detectable concentrations. The resistivity of pressed pellets of Fe_2?xGe_xO₃ varies from about 10⁶ ohm-cm for x = 0 to about 10^?1 ohm-cm for x = 0.05. The photoassisted electrolysis of water at Ge-doped Fe₂O₃ electrodes is demonstrated. The $\text{Fe}{}_2\text{O}{}_3\text{(Ge)}\text{0.7 M}\text{Fe(CN)}{}^{\mathrm{4?}}{}_6\text{,}\text{0.05 M}\text{Fe(CN)}{}^{\mathrm{3?}}{}_6\text{Pt}$ photoelectrochemical cell showed a 0.29-V open-circuit voltage, 1.2-mA/cm² short-circuit current, 0.31 fill factor, and 0.06% power efficiency.     

The role of complexing ligands in the formation of non-aggregated nanoparticles of zirconia

The hydrolysis and condensation of zirconium n-propoxide in n-propanol have been chemically controlled via the complexation of the zirconium precursor with acetylacetone. The size of the zirconium oxide-based particles is mainly controlled by the complexation ratio x=[acac]/[Zr]. the mean size increases from nanometric to submicronic range when x decreases from 1 to 0.1. Amorphous colloidal particles are obtained at room temperature. They result from a competitive growth/termination mechanism of zirconium-oxo species in the presence of acac surface capping agents. However non-aggregated nanocrystalline particles of tetragonal zirconia, about 2 nm in diameter are formed upon aging at 60°C when hydrolysis is performed in the presence of paratoluene sulfonic acid (PTSA).     

Automated multiresidue analysis of pesticides in olive oil by on-line reversed-phase liquid chromatography-gas chromatography using the through oven transfer adsorption-desorption interface

A multiresidue, automated and rapid method for the determination of pesticide residues in olive oil is presented. The method employs the through oven transfer adsorption-desorption interface for the on-line coupling of reversed-phase liquid chromatography and gas chromatography. In this fully automated system, olive oil is directly injected with no sample pre-treatment step other than filtration. Methanol-water is used as eluent in the liquid chromatography pre-separation step. The selected liquid chromatography fraction containing the pesticides is automatically transferred to the gas chromatography. The liquid chromatography column flow during elution is different from the flow during the transfer. Using a flame ionisation detector, pesticide detection limits varied from 0.1 to 0.3 mg/l.     

Nucleophilic substitution of hydrogen in meso-nitroaryl-substituted porphyrins—unprotected at the NH-centers in the core ring

Unprotected 5-(4-nitrophenyl)-10,15,20-triphenylporphyrin and 5,10-bis(4-nitrophenyl)-15,20-diphenylporphyrin react in the presence of a base at low temperature with carbanions (which bear a leaving group X at the carbanionic center) affording vicarious nucleophilic substitution of hydrogen (VNS) products in good yields (50-89%). The reactivity is explained in terms of the predominance of the porphyrin N-anion resonance forms at this temperature.     

An efficient synthesis of 6-formyl-1,2-dihydro-2-oxo-3-pyridinecarboxylic acid and some carbonyl derivatives of it and its 6-acetyl homologue

Starting with 1,1-dimethoxy-2-propanone ( 1 ), 6-formyl-1,2-dihydro-2-oxo-3-pyridinecarboxylic acid ( 5a ) has been prepared in large quantities by a highly efficient, 4-step synthesis. This compound, along with its one carbon homologue, 6-acetyl-1,2-dihydro-2-oxo-3-pyridinecarboxylic acid ( 5b ) has been reacted with several carbonyl derivative forming reagents to provide a series of side chains for β-lactams. Among these carbonyl derivatives are styrylamides which were prepared from Wittig and Horner-Emmons reagents. The preparation of the phosphonium salts and phosphonate esters is also described.     

Determination of molybdenum by atomic-absorption spectrometry after separation by 5,5'-methylenedisalicylohydroxamic acid extraction and further reaction with thiocyanate and tin (II)

A method is described for the determination of molybdenum down to the microgram level, in samples of soil, steels, fertilizers and pharmaceuticals. After attack with acids, this element is separated from matrix elements by extraction of its 5,5'-methylenedisalicylohydroxamic acid (MEDSHA) complex from 4M hydrochloric acid, into methyl isobutyl ketone. Molybdenum is determined by atomic-absorption spectrometry (AAS), after conversion of the Mo-MEDSHA complex into the MoSCN(-) complex in the organic phase. The detection limit is 0.03 microg/ml, with a relative standard deviation not exceeding 1.5% at a level of 2 microg/ml. The method is highly selective and suffers only from interference by tungsten.     

Molecular dynamics simulations of the dinuclear zinc-beta-lactamase from Bacteroides fragilis complexed with imipenem

Herein, we present results from MD simulations of the Michaelis complex formed between the dizinc beta-lactamase from B. fragilis and imipenem. We considered two catalytically important configurations, which differ in the presence or absence of a hydroxide bridge connecting the two zinc ions in the active site. The structural and dynamical effects induced by substrate binding, the specific roles of the conserved residues and the zinc-bound water molecules, the near attack conformers of the Michaelis complex, and so forth, are discussed in detail. The relative stability of the two configurations was estimated from QM linear scaling calculations on the enzyme-substrate complex combined with Poisson-Boltzmann electrostatic calculations and normal mode calculations. Importantly, we find that the two configurations have similar energies, indicating that these two structures could readily be interchanged, thereby facilitating catalysis. The configuration with the hydroxide bound to the two zinc ions is predicted to be the resting form of the enzyme, while the configuration without the bridge is the reactive form that was found to place the hydroxide in position to attack the carbonyl of the beta-lactam ring. Thus, we propose that the enzyme initiates catalysis by converting from the hydroxide bridge form into the configuration that lacks the hydroxide bridge. This interconversion increases the nucleophilicity of the hydroxide ion and exposes it to the beta-lactam carbonyl, which ultimately facilitates nucleophilic attack. The implications of the observed modes of binding, the possible influence of mutating the Lys184 and Asn193 residues on substrate binding, and the reaction mechanism are also discussed in detail.     

Spontaneously formed trans-anethol/water/alcohol emulsions: mechanism of formation and stability

We studied the spontaneous emulsification and droplet growth mechanism in trans-anethol/water/ethanol solutions, also known as the beverage ouzo, using dynamic light scattering spectroscopy. This simple ternary mixture is a generic example of a system that forms microemulsions spontaneously when brought into the two-phase region. The volume fraction of the dispersed phase was found to profoundly affect the growth rates of the droplets, which is a new finding that has not been predicted by the Lifshitz-Slyozov-Wagner theory. Time-dependent measurements show that the droplet growth is governed by Ostwald ripening (OR), and no coalescence was observed. Furthermore, the OR rates increase with increasing oil concentration at low alcohol content. We attribute this behavior to enhanced droplet-droplet interactions. At high ethanol concentrations, we found that the measured rates decreased as the oil concentration increased. The OR growth mechanism completely correlates with changes in droplet size. The kinetics of droplet growth shows that the ripening has a saturation limit at a droplet radius of about 1.5 mum. Thus, formed emulsions remain stable for months.     

Insights into the phosphoryl-transfer mechanism of cAMP-dependent protein kinase from quantum chemical calculations and molecular dynamics simulations

To investigate the molecular details of the phosphoryl-transfer mechanism catalyzed by cAMP-dependent protein kinase, we performed quantum mechanical (QM) calculations on a cluster model of the active site and molecular dynamics (MD) simulations of a ternary complex of the protein with Mg(2)ATP and a 20-residue peptide substrate. Overall, our theoretical results confirm the participation of the conserved aspartic acid, Asp(166), as an acid/base catalyst in the reaction mechanism catalyzed by protein kinases. The MD simulation shows that the contact between the nucleophilic serine side chain and the carboxylate group of Asp(166) is short and dynamically stable, whereas the QM study indicates that an Asp(166)-assisted pathway is structurally and energetically feasible and is in agreement with previous experimental results.