Differential pulse anodic stripping voltammetric determination of traces of copper with a tobramycin-Nafion modified electrode.

A Nafion-modified glassy carbon electrode incorporated with tobramycin for the voltammetric stripping determination of Cu2+ has been explored. The electrode was fabricated by tobramycin containing Nafion on the glassy carbon electrode surface. The modified electrode exhibited a significantly increased sensitivity and selectivity for Cu2+ compared with a bare glassy carbon electrode and the Nafion modified electrode. Cu2+ was accumulated in HAc-NaAc buffer (pH 4.6) at a potential of -0.6 V (vs. SCE) for 300 s and then determined by differential pulse anodic stripping voltammetry. The effects of various parameters, such as the mass of Nafion, the concentration of tobramycin, the pH of the medium, the accumulation potential, the accumulation time and the scan rate, were investigated. Under the optimum conditions, a linear calibration graph was obtained in the concentration range of 1.0 x 10(-9) to 5.0 x 10(-7) mol l(-1) with a correlation coefficient of 0.9971. The relative standard deviations for eight successive determinations were 4.3 and 2.9% for 1.0 x 10(-8) and 2.0 x 10(-7) mol l(-1) Cu2+, respectively. The detection limit (three times signal to noise) was 5.0 x 10(-10) mol l(-1). A study of interfering substances was also performed, and the method was applied to the direct determination of copper in water samples, and also in analytical reagent-grade salts with satisfactory results.     

Preparation,thermal properties,and flame retardance of epoxy–silica hybrid resins

A novel epoxy system was developed through the in situ curing of bisphenol A type epoxy and 4,4′‐diaminodiphenylmethane with the sol–gel reaction of a phosphorus‐containing trimethoxysilane (DOPO–GPTMS), which was prepared from the reaction of 9,10‐dihydro‐9‐oxa‐10‐phosphaphenanthrene‐10‐oxide (DOPO) with 3‐glycidoxypropyltrimethoxysilane (GPTMS). The preparation of DOPO–GPTMS was confirmed with Fourier transform infrared, ¹H and ³¹P NMR, and elemental analysis. The resulting organic–inorganic hybrid epoxy resins exhibited a high glass‐transition temperature (167 °C), good thermal stability over 320 °C, and a high limited oxygen index of 28.5. The synergism of phosphorus and silicon on flame retardance was observed. Moreover, the kinetics of the thermal oxidative degradation of the hybrid epoxy resins were studied. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 2354–2367, 2003     

In‐line monitoring of UV photopolymerization with a quartz crystal resonator

An in‐line monitoring device using a quartz crystal resonator for thin film polymerization was proposed, and its performance has been evaluated by implementing in the UV polymerization of 2‐hydroxyethyl methacrylate with a photoinitiator of 1‐chloroanthraquinone. Because the variation of resonant resistance of the resonator is proportional to the square root of viscosity change that is closely related to the polymerization degree, the resistance can be used as a measure of the polymerization degree. The resistance measurements were compared with the outcome of instrumental analyses of polymerization degree using an FTIR spectrometer and a gel permeation chromatograph. The experimental results showed that the resistance measurements were consistent with the experimental outcome of the instrumental analyses, and this indicates the effectiveness of the proposed device. Owing to the simplicity and availability of the resonator system, its wide utilization in the monitoring of a variety of film polymerization processes, including photoresistor application, is expected. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2428–2439, 2006     

Determination of lead by selective chelatometric titration with HEDTA after separation as its sulphate by an improved method of precipitation

A selective titrimetric determination of Pb after separation by a modified method of precipitation as its sulphate is proposed. Pb(II), present as the perchlorate, is precipitated by gentle boiling in 3.6M H(2)SO(4) presaturated with PbSO(4) and free from any extraneous anions. The customary time-consuming evaporation to fumes of sulphuric acid is dispensed with. The precipitate is collected, and dissolved in excess of HEDTA, the surplus of which is back-titrated with Zn(II) at pH 5.0-5.5. Use of Catechol Violet and Xylenol Orange as a mixed indicator gives a sharper end-point. The standard deviation of the proposed method for 60 mg of lead is 0.35 mg. The method has been successfully used to determine Pb in non-ferrous alloys.     

Novel Rearrangements of 2,3-Dimercapto-1-propanol Derivatives: Formation of Dialkyl Sulfide, Dialkyl Disulfide, and 1,2,3-Tris(alkylthio)propane

The base alkylation of 2,3-dimercapto-1-propanol with alkyl halides leads in good yield to 2,3-bis(alkylthio)-1-propanol and dialkyl sulfide. The reaction of 2,3-bis(alkylthio)-1-propanol with catalytic concentrated sulfuric acid proceeds with rearrangement to give 1,2,3-tris(alkylthio)propane and dialkyl disulfide. The rearrangement reaction takes place through a common intermediate thiaranium intermediate 8.     

First total synthesis of leucamide A

The first total synthesis of marine bioactive cyclic heptapeptide Leucamide A has been accomplished, including a simple method for construction of the 4,2-bisheterocycle tandem pair substructure that employs a DAST-mediated cyclization of beta-hydroxy amide and final HBTU-promoted ring closing.     

Synthesis and stereochemical assignment of 7-arylidene and 7-heteroarylidene morphinan-6-ones

A number of (E)-7-arylidenenaltrexones were synthesized by azeotropic distillation of water from a benzene solution of naltrexone and an aromatic aldehyde (benzaldehyde, 4-chloro- and 4-fluorobenzaldehyde, 3-and 4-pyridinecarboxaldehyde and 1-methyl-2-imidazolecarboxaldehyde) using piperidine as a catalyst. In addition, (E)-7-benzylidenenaloxone was prepared by the previously published Claisen-Schmidt condensation using sodium hydroxide in methanol. The stereochemistry of these arylidene derivatives 3–9 was determined to be (E) by means of nuclear Overhauser enhancement experiments. The ¹³C nmr spectra of (E)- 3–9 are recorded in deuteriochloroform and those of the hydrochlorides in deuteriodimethyl sulfoxide.     

Theoretical Study of Weakly Bound Dimers between Hydrogen Fluoride and Some Polar Molecules

Weakly bound linear and bent dimers, FH—X (where X = CO, OC, CNH, NCH, N₂O and ON₂), are investigated using the DFT B3LYP and ab initio MP2 methods with the same basis sets (6–311++G(3df,2pd)). The strengths of the H—C or H—N H‐bonds in dimers FH—CO, FH—CNH, and FH—N₂O are compared with those of the H—O or H—N H‐bonds in dimers FH—OC, FH—NCH, and FH—ON₂. The results obtained for the H‐bond distances, the elongation effect of the HF bond, the red shift of the HF stretching frequency, and the energy difference between the dimer and the charge transfer reveal that the H‐bonds of the first group of dimers are stronger than those of the second. The Gibbs energies calculated for the six dimer formations indicate that the weakly bound dimers are unstable at room temperature (T = 298 K) (FH—X's → FH + X's, ΔG < 0).     

Quantitative volatilization of tin as mixed halides and its application in metal analysis

Proposed in this paper is an improved method for removal of tin as the matrix element by volatilization in an anhydrous medium as mixed halides of different composition. Any one of them boils at a lower temperature than SnBr₄. This ternary system enhances the eventual recombination of temporarily dissociated species to volatile ones, thus making the process quicker and more efficient. The presence of 2 mg of Pb(II) suffices to prevent Bi(III) from loss due to volatilization.     

Copper(II)-catalyzed aerobic oxidation of primary alcohols to aldehydes in ionic liquid [bmpy]PF6

A room-temperature aerobic oxidation of primary alcohols to aldehydes catalyzed by the three-component system acetamido-TEMPO/Cu(ClO(4))(2)/DMAP in the ionic liquid [bmpy]PF(6) has been developed, and the catalysts can be recycled and reused for five runs without any significant loss of catalytic activity. [reaction: see text]