Clinical evaluation of immunoglobulin-E radioimmunoassay kit

An IgE RIA kit (Sandwich method; Dainabott), is used to obtain the following results. (1) Standard curve: Since the range of reproduction rate show 3.16-7.07% (C.V.), the curve become steep. (2) Incubations under controlled situation: Both of the incubations are controlled at 15-30 degrees C for 2 h. (3) Reproducibility test: Coefficients of variation (C.V.) of intra-assay and inter-assay variation are 2.32-3.94% and 2.92-3.92% respectively. (4) Recovery test: A result of the recovery test range between 100.1-101.7%. (5) Dilution test: Multiple dilution effects are observed. (6) Average counts of the serum IgE for the controlled and diseased groups: The average counts of the serum IgE for the controlled group, atopic diseased group, allergic rhinitis group and allergic bronchial asthma are 144.9 +/- 183.2 IU/ml, 1,099.0 +/- 2,782.4 IU/ml, 1,150.9 +/- 2,063.3 IU/ml and 600.7 +/- 686.4 IU/ml respectively. The value of the diseased groups have tendency to show higher averages than the controlled group. Since the controlled and diseased groups show wide distributions of the serum IgE level, there is no significant difference of two variations. However the diseased groups have tendency to show higher ratio of the serum IgE level in blood than the controlled groups. These basic researches are quite meaningful, because they are able to apply for a supplemental diagnosis of the atopic and parasitic disease.     

Regio-controlled ring-opening polymerization of perfluoroalkyl-substituted epoxides

Highly fluorinated epoxides were polymerized under mild conditions regioregularly, which gave easy access to isotactic polymers by using optically pure epoxides.     

Asymmetric interaction of optically active polymers with asymmetric small molecules. IV. Effect of hydrophobic groups on asymmetric interaction

In order to investigate the mechanism of the asymmetric interaction between optically active polymers and small molecules, optically active copolymers of N-acrylyl L-amino acids(N-acrylyl-L -phenylalanine, N-acrylyl-L -tryptophan, and N-acrylyl-L -leucine, respectively) and N,N′-hexamethylene diacrylylamide were synthesized, and interaction of these polymers with the optical isomers of phenylalanine and tryptophan was investigated. In the interaction of these acidic polymers with amino acids performed at pH 5.0, significant difference in amount of adsorption between the D and L isomers of amino acids were observed, and the L form of amino acids was adsorbed preferentially. The interaction between optically active small molecules was also investigated: these results showed a similarity to the results for interaction between optically active polymers and amino acids. In some instances of asymmetric interaction the influence of hydrophobic interaction between a polymer and substrate was clearly perceived. The stereoselective effects on the asymmetric interaction are discussed.     

Hydrochlorothiazide Enhances UVA‐Induced DNA Damage

The UVA is currently thought to be carcinogenic because, similar to UVB, it induces the formation of cyclobutane pyrimidine dimers (CPDs). Various drugs have been reported to cause photosensitive drug eruptions as an adverse effect. Although the precise mechanism of photosensitive drug eruption remains to be elucidated, it is generally accepted that free radicals and other reactive molecules generated via UV‐irradiated drugs play important roles in the pathogenesis of photosensitive drug eruptions. The waveband of concern for photo‐reactive drugs is UVA‐visible light, but some extend into the UVB region. We tested whether photosensitive drugs could enhance CPD formation after UVA exposure by using isolated DNA in the presence of several reported photosensitive drugs using high‐performance liquid chromatography. We found that the diuretic agent hydrochlorothiazide (HCT) significantly enhanced the production of TT dimers over a wide range of UVA. Furthermore, we investigated whether UVA plus HCT could enhance CPD production in xeroderma pigmentosum model mice defective in nucleotide excision repair. Immunofluorescence studies showed that CPD formation in the skin significantly increased after 365 nm narrow‐band UVA irradiation in the presence of HCT, compared with that in wild‐type mice. HCT could be used with caution because of its enhancement of UVA‐induced DNA damage.     

Measurement Accuracy in Phase-Shifting Point Diffraction Interferometer with Two Optical Fibers

A phase-shifting point diffraction interferometer (PS/PDI) with point sources of two single mode optical fibers has been developed, which will be appropriate for the surface figure measurement of large aperture optics on a sub-nanometer scale. To reduce the measurement error factors, a fiber optic plate (FOP) is used as a projection plane for interference pattern. Errors caused by imperfection of optical alignment, such as position of point sources and tilt of FOP, are minimized by analyzing the measured phase data with an original method. Measurement accuracy in the PS/ PDI is estimated with the interference pattern produced by the two optical fiber sources. If inhomogeneity of the FOP and a systematic error of the PS/PDI are eliminated, the measurement accuracy of the present system is estimated to be less than 4nm P-V and 0.7nm rms, respectively, at a measurement wavelength of 632.8 nm.     

Characterization of PVA and Chitosan/PVA Blends Prepared from Aqueous Solutions of Various Na2SO4 Concentrations

Uniplaner orientation of a particular crystal plane along the surface of a film was investigated for poly (vinyl alcohol) (PVA) film prepared by a coagulation bath with concentrated aqueous solution containing 100 ∼ 300g of Na₂SO₄ against 1 ℓ of water. The orientation distribution functions of the three crystallographic principal axes of the dried films were obtained by the X-ray diffraction technique. The same treatment was carried out for the films prepared by stretching biaxially of the fresh gel and then by drying the resultant fresh gel. The very high preferential orientation of the crystal chain axes and amorphous chain segments could be realized by the biaxially elongation. Accordingly, the techniques were applied to the biaxially stretching of chitosan and PVA blend films with high Young's modulus. The planer orientation of the chain axes of chitosan and PVA crystallites could be confirmed. The morphology of the film surface was estimated by measurements of contact angle and electron spectroscopy for chemical analysis. The results suggested that the admixture of chitosan decreases wet ability of the specimen and this tendency was slightly enhanced by the biaxially elongation.     

Novel method for preparation of photocrosslinkable poly(vinyl alcohol)

A convenient procedure to prepare photosensitive poly(vinyl alcohol) by acetalization with 1-methyl-4-(p-formylstyryl)pyridinium methosulfate in heterogeneous condition is described. The reaction of fully saponified poly(vinyl alcohol) was carried out in suspension in acidic aqueous solution, while partially saponified poly(vinyl alcohol) was acetalized in acidic aqueous organic solvent. The photosensitive poly(vinyl alcohol) thus prepared was purified by filtration and successive washing out with methanol. The effect of the preparative condition on the electronic absorption spectra of the styrylpyridinium group attached to poly(vinyl alcohol) is discussed.     

Coexistence of Two Thermally Induced Intramolecular Electron Transfer Processes in a Series of Metal Complexes [M(Cat‐N‐BQ)(Cat‐N‐SQ)]/[M(Cat‐N‐BQ)2] (M=Co,Fe, and Ni) bearing Non‐Innocent Catechol‐Based Ligands: A Combined Experimental and Theoretical Study

The different thermally induced intermolecular electron transfer (IET) processes that can take place in the series of complexes [M(Cat‐N‐BQ)(Cat‐N‐SQ)]/[M(Cat‐N‐BQ)₂], for which M=Co ( 2 ), Fe ( 3 ) and Ni( 4 ), and Cat‐N‐BQ and Cat‐N‐SQ denote the mononegative (Cat‐N‐BQ^?) or dinegative (Cat‐N‐SQ^2?) radical forms of the tridentate Schiff‐base ligand 3,5‐di‐tert‐butyl‐1,2‐quinone‐1‐(2‐hydroxy‐3,5‐di‐tert‐butylphenyl)imine, have been studied by variable‐temperature UV/Vis and NMR spectroscopies. Depending on the metal ion, rather different behaviors are observed. Complex 2 has been found to be one of the few examples so far reported to exhibit the coexistence of two thermally induced electron transfer processes, ligand‐to‐metal (IET^LM) and ligand‐to‐ligand (IET^LL). IET^LL was only found to take place in complex 3 , and no IET was observed for complex 4 . Such experimental studies have been combined with ab initio wavefunction‐based CASSCF/CASPT2 calculations. Such a strategy allows one to solicit selectively the speculated orbitals and to access the ground states and excited‐spin states, as well as charge‐transfer states giving additional information on the different IET processes.     

Sequential injection chemiluminescence immunoassay for nonionic surfactants by using magnetic microbeads

A rapid and sensitive immunoassay based on a sequential injection analysis (SIA) using magnetic microbeads for the determination of alkylphenol polyethoxylates (APnEOs) is described. An SIA system was constructed from a syringe pump, a switching valve, a flow-through type immunoreaction cell equipped with a photon counting unit and a neodymium magnet. Magnetic beads, to which an anti-APnEOs monoclonal antibody was immobilized, were used as a solid support in an immunoassay. The introduction, trapping and release of the magnetic beads in and from the immunoreaction cell were controlled by means of a neodymium magnet and adjusting the flow of a carrier solution. The immunoassay was based on an indirect competitive immunoreaction of an anti-APnEOs monoclonal antibody immobilized on the magnetic beads with a sample APnEOs and a horseradish peroxidase (HRP)-labeled APnEOs in the same sample solution, and was based on the subsequent chemiluminscence reaction of HRP on the magnetic microbeads with a luminol solution containing hydrogen peroxide and p-iodophenol. The anti-APnEOs antibody was immobilized on the magnetic microbeads by coupling the antibody with the magnetic beads after activation of a carboxylate moiety on the surface of the magnetic beads that had been coated with a polylactic acid film. The antibody immobilized magnetic beads were introduced in the immunoreaction cell and trapped in it by the neodymium magnet, which was equipped beneath the immunoreaction cell. An APnEOs sample solution containing the HRP-labeled APnEOs at a constant concentration, and a luminol solution containing hydrogen peroxide and p-iodophenol were sequentially introduced into the immunoreaction cell, according to an SIA programmed sequence. Chemiluminescence emission was monitored by means of a photon counting unit located at the upper side of the immunoreaction cell by collecting the emitted light with a lens. A typical sigmoidal calibration curve was obtained, when the logarithm of the concentration of APnEOs was plotted against the chemiluminescence intensity as the number of photons in 100 ms using standard APnEOs sample solutions at various concentrations (0–1000 ppb) under optimum conditions. The lower detection limit defined as IC₈₀ is ca 10 ppb. The time required for analysis is less than 15 min per a sample. The present method was successfully applied to the determination of APnEOs in river water.