Co2(CO)8 Catalyzed reaction of oxetanes with trialkylsilanes

Dicobalt octacarbonyl catalyzed silyl-hydroformylation of oxetanes can be controlled by the choice of trialkylsilane. Triethylsilane gives 1,4-$\text{bis}$-silyl ethers while $\text{t}$-butyl-dimethylsilane yields silyl enol ethers.     

Heterogeneous grafting on polymers containing chlorine: Grafting of amide groups in water suspension and the reactivity of the new polymer towards epoxy resins

Heterogeneous grafting on polyvinylchloride suspended in water was carried out using N-butyl-3-mercaptopropionamide as nucleophile. Over 50% graft was obtained by using a small amount of solvent as a swelling agent and tricapryl methyl ammonium chloride as a phase transfer catalyst. Elemental analysis of the grafted polymer shows that the chlorine displaced from the polymers is replaced by the thio-amide group. The above conclusion is supported by NMR and IR analysis. The kinetics of the chlorine displacement from PVC by the thio amide group obeys the Shell progressive mechanism. The rate at which an individual spherical particle reacts depends on the diffusion through the reacted layer. The grafted polymer is soluble in tetrahydrofuran or nitrobenzene. The films obtained from the grafted material are brittle due to excessive internal hydrogen bonding. The electrostatic charge which is a characteristic surface phenomena in PVC is diminished in the grafted polymer which may be due to the existence of the amide group near the surface. The amide groups attached to the side chains on the polymer may participate in various reactions, e.g., with epoxy resins. IR analysis of the cured film indicates the disappearance of the oxiran band at 913 cm^?1 and an increase in the hydroxyl band around 3300 cm^?1. Thus, grafting of amide groups on PVC enables us to further modify PVC by epoxy resins.     

Anionic templating: synthesis,structure, and characterization of novel three-dimensional mixed-metal oxychlorides Te(4)M(3)O(15).Cl (M = Nb(5+) or Ta(5+))

Two new three-dimensional oxychlorides are reported, Te(4)M(3)O(15).Cl (M = Nb(5+) or Ta(5+)). The isostructural materials were synthesized by chemical transport reactions utilizing TeO(2), M(2)O(5), and MCl(5) (M = Nb(5+) or Ta(5+)) as reagents. The compounds exhibit a three-dimensional cationic tunnel framework, with Cl(-) anions occupying the tunnels. Crystal data: monoclinic, space group C2/c, a = 18.9944(7) A, b = 7.8314(3) A, c = 21.1658(8) A, beta = 116.6400(10) degrees, Z = 8 (T = 295 K).     

Synthesis of Novel Benzo-15-Crown-5-Tethered β-Cyclodextrins and Their Enhanced Molecular Binding Abilities by Alkali Metal Cation Coordination

Two novel benzo-15-crown-5 tethered β-cyclodextrins 1 and 2have been synthesized by coupling substituted benzo-15-crown-5 with correspondingβ-cyclodextrin derivatives. Their inclusion complexation behavior withrepresentative guests, such as cyclohexanol, cyclohexane carboxylic acid, cyclohexaneacetic acid, sodium cyclohexane carboxylate, and potassium cyclohexane carboxylate,was investigated in aqueous solution by means of fluorescence spectrometry. As compared with parent β-cyclodextrin, benzo-15-crown-5 tethered β-cyclodextrins 1–2 display significantly enhanced molecular binding abilities and selectivities towards model substrates, especially towards substrates containing alkali-metal cations. These results indicate that, bearing two recognition sites in a single molecule, these supramolecular architectures can strongly enhance the molecular binding ability of parent β-cyclodextrin by the cooperative binding of the β-cyclodextrin cavity and the crown ether moiety. Possessing a shorter linker, crown ether-β-cyclodextrin 2 shows much higher binding affinity with guest molecules than crown ether-β-cyclodextrin 1, which may be attributed to the binding size and molecular multiple recognition behavior between host and guest.     

Synthesis and Structures of Titanosiloxane Cage Compounds

Reaction of (triphenylmethyl)silanetriol (1) with cyclopentadienyltitanium trichloride (CpTiCl₃) in the presence of triethylamine as a HCl scavenger gave both compounds of a partial open-cage type {[Ph₃CSiO(OH)]₃(Ph₃CSiO_3/2)(CpTiO_3/2)₄} (2) and cube type (Ph₃CSiO_3/2CpTiO_3/2)₄ (3). The 1:1 reaction of 1 and CpTiCl₃ in toluene solvent at reflux temperature for 3 d afforded compounds 2 (22%) and 3 (36%). When 1 is reacted with a 1.5 fold excess of CpTiCl₃ under the same conditions, compound 3 was obtained in high yield (81%) along with 2 in trace quantities. Compounds 2 and 3 were fully characterized by the analyses of ¹H, ¹³C, ²⁹Si NMR, IR, and FAB MS data. The solid-state structure of 3 was determined by a single crystal X-ray diffraction study. Compound 3 had shown to have catalytic activity for the oxidation of alkenes such as 1-octene, cyclooctene, and norbornene with t-butyl hydrogen peroxide. The effect of solvent was observed in this epoxidation reaction. The order of reactivity were decreased as follows: CHCl₃ > hexane THF.     

银络合物在催化核上的还原反应

研究了尿嘧啶银络合物在胶态金属及其硫化物核上被对苯二酚还原的反应，并以Ａｇ和Ｐｔ电极代替催化核与对苯二酚显影剂和银络合物组成原电池作为电化学模型，分别测定该络合物阴极反应和对苯二酚阳极反应的电流。结果表明，原电池的电流大小与反应速度成正比关系，从而为物理显影电极理论提供实验依据。     

Study on the anodic reaction of Ni in an alkaline solution by transient pH detection based on scanning electrochemical microscopy (SECM)

The anodic reaction of Ni in an alkaline solution was studied by the tip–substrate voltammetry mode of scanning electrochemical microscopy (SECM) and cyclic voltammetry (CV). A platinum microdisc electrode was selected as the tip electrode, which functioned as a pH sensor with transient response capability. The pH value of the solution near the Ni electrode surface varied while the Ni substrate oxidation reaction occurred, and the pH variation could be detected by the tip faradic current. The cyclic voltammogram results showed that two types of hydroxides: i.e. α‐Ni(OH)₂ and β‐Ni(OH)₂ were formed during Ni oxidation in the lower potential region. In the proceedings of α‐Ni(OH)₂ → γ‐NiOOH and β‐Ni(OH)₂ → β‐NiOOH, the process of OH^? concentration decrease in the solution was ahead and behind of electron transfer in the solid phase, respectively. These results indicate that the OH^? adsorption process occurs as an elementary step in the former reaction and the H⁺ diffusion process from the inner to the outer layer of the solid phase occurs as a subsequent step in the latter reaction. The results also revealed that the oxide film on the Ni surface has a two‐layer structure. The real potential of the oxygen evolution reaction (OER) on the Ni surface with different cycles is also analyzed in the paper. Copyright © 2007 John Wiley & Sons, Ltd.     

Independent exponential feeding of glycerol and methanol for fed-batch culture of recombinant Hansenula polymorpha DL-1

As a novel feeding strategy for aptomizing human epidermal growth factor (hEGF) production with a recombinant Hansenula polymorpha DL-1 using the methanol oxidase (MOX) promoter in H. polymorpha DL-1, independent exponential feeding of two substrates was used. A simple kinetic model considering the cell growth on two substrates was established and used to calculate the respective feeding rates of glycerol and methanol. In the fedbatch culture with methanol-only feeding, the optimal set point of specific growth rate on methanol was found to be 0.10 h⁻¹. When the fed-batch cultures were conducted by the independent feeding of glycerol and methanol, the actual specific growth rate on glycerol and methanol was slightly lower than the set point of specific growth rate. By the uncoupled feeding of glycerol and methanol the volumetric productivity of hEGF increased from 6.4 to 8.0 mg/(L·h), compared with methanol-only feeding.     

Swelling kinetics and release characteristic of crosslinked chitosan: Polyether polymer network (semi-IPN) hydrogels

The aqueous swelling kinetics of a series of crosslinked chitosan (cr-CS) with glutaraldehyde (GA) interpenetrating polyether hydrogels have been studied as functions of pH, the N-deacetylation degree of chitosan, the amount of crosslinking agent, the electrolyte composition in solution, temperature, and gel composition. Based on these results, the swelling mechanism of the hydrogels was discussed. The release profiles of chlorhexidini acetas from the semi-IPN were also investigated. © 1994 John Wiley & Sons, Inc.     

Stereochemistry of cytidine: conformational analysis and hydrogen bonding

The energy calculations using the INDO molecular orbital method and classical potential function show that the syn conformation of pyrimidine nucleosides having the C_(2')-endo or C_(2')-endo-C_(3')-endo sugar ring puckering is as stable as the corresponding anti form.The O_(2')-O_(2') base-ribose hydrogen bonding significantly alters the Φ_CN conformation by confining the allowed Φ_CN ranges to about 150–210°.