Determination of tributyltin oxide in coastal marine sediments and mussels by electrothermal atomic absorption spectrometry

We have devised a new method for bis(tributyltin)oxide (TBTO) determination in marine sediments and mussels. This technique involves an n-hexane/methylene chloride mixture extraction and extract purification with a sodium hydroxide wash in order to eliminate interfering compounds. TBTO is then extracted again by nitric acid and converted into an inorganic tin species; the analysis has been effected using Zeeman graphite furnace-atomic absorption spectrophotometry. The method detection limit for the matrices examined is 0.004 μg TBTO g^?1 (wet weight) and is sufficient for the analysis in real samples. The percentage recovery of TBTO from sediments and mussels samples is higher than 85% and 95% respectively. This method has been applied to TBTO level determination in sediments and mussels (Mytilus galloprovincialis) sampled in the harbour area in Taranto, where mussel culture activities are much developed; the TBTO levels obtained in sediments and mussels were in the range 15-47 ng g^?1 (wet weight) and 11-30 ng g^?1 (wet weight) respectively. Such values are comparable with those found in other harbour areas in the Mediterranean Sea.     

Calculation in five loops of a multiloop diagram of special form

Scientific-Research Institute of Nuclear Physics at the Moscow State University. Translated from Teoreticheskaya i Matematicheskaya Fizika, Vol. 88, No. 1, pp. 14–16, July, 1991.     

A symmetry-adapted force-constant lattice-dynamical model for single-walled carbon nanotubes

We develop a lattice-dynamical model based on the screw symmetry of single-walled carbon nanotubes that allows for reducing the size of the dynamical matrix to six, for all tube chiralities. The model uses force constants derived from fitting to the phonon dispersion of 2D graphite. We present the calculation procedure in a clear and transparent way, making the model easier to follow. We calculate the phonon dispersions of a number of nanotubes of different chiralities. The splitting of two highest Raman active modes and the radial breathing mode frequency are studied by changing the tube diameter and chirality.     

Moving and oscillating transversely one-dimensional laser solitons

Transversely one-dimensional moving and oscillating solitons in a wide-aperture laser with saturable absorber with fast (inertialess) nonlinearity are found by numerical simulation. The regions of existence of such solitons and of their complexes are presented.     

Areal objects and the problem of the λ term in the theory of gravitation

The following areal objects are considered: an ether thread contracting two material points and a multidimensional ether fibre in the pseudo-Euclidean world of events. An ether space-time model with an arbitrarily determined Riemannian metric is constructed and the problem of the λ term in Einstein equations is discussed in this regard.     

Variation of the temperature factor of models on a ballistic range

A technique for variation of the temperature factor of free-flight models by varying their initial temperature is described. An experiment on a ballistic range is carried out with a free-flying supersonic blunt cone with a half-angle of 15° at a Mach number of 2.3. The flow at the cone base is studied in the transition range (from the laminar to turbulent flow) of Reynolds numbers. The base flow pattern is determined from the shadowgraphs of the flow about the models. The drag coefficient of the blunt cone at a zero angle of attack is found by processing trajectory data. It is found that the near wake geometries and the drag coefficients of the models tested at the laboratory temperature and a temperature of 120 K differ. Explanations of this effect are given.     

Diffuse x-ray scattering study of the formation of microdefects in heat-treated dislocation-free large-diameter silicon wafers

Diffuse x-ray scattering (DXS) is used to study the formation of microdefects (MDs) in heat-treated dislocation-free large-diameter silicon wafers with vacancies. The DXS method is shown to be efficient for investigating MDs in silicon single crystals. Specific defects, such as impurity clouds, are found to form in the silicon wafers during low-temperature annealing at 450°C. These defects are oxygen-rich regions in the solid solution with diffuse coherent interfaces. In the following stages of decomposition of the supersaturated solid solution, oxide precipitates form inside these regions and the impurity clouds disappear. As a result of the decomposition of the supersaturated solid solution of oxygen, interstitial MDs form in the silicon wafers during multistep heat treatment. These MDs lie in the {110} planes and have nonspherical displacement fields. The volume density and size of MDs forming in the silicon wafers at various stages of the decomposition are determined.     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007