Optimization of matrix-assisted laser desorption/ionization time-of-flight collision-induced dissociation using poly(ethylene glycol)

Details of the optimization of the collision-induced dissociation (CID) process, using a collision cell on a matrix-assisted laser desorption/ionization (MALDI) time-of-flight (TOF) mass spectrometer, are described using poly(ethylene glycol) 1000 (PEG 1000) as a model analyte. The effects of collision gas identity (helium, air, and argon), as well as collision gas pressure, on the resulting MS/MS data were investigated. With PEG 1000, helium was found to give the best results with respect to signal-to-noise (S/N) ratio. The optimum pressure for each gas was found to be in the range where the precursor ion signal was attenuated to approximately 30-50% for helium and 40-60% for argon. The effect of cation choice (Li, Na, and K) on the CID of PEG was also studied. CID spectra were produced for each, but PEG cationized with lithium was found to produce the spectra with the highest S/N ratio. The MALDI-TOF CID spectra that were generated for PEG were compared with the high-energy and low-energy MS/MS spectra obtained from a sector mass spectrometer and from a triple quadrupole mass spectrometer, respectively. The results observed for PEG confirm that CID on a MALDI-TOF mass spectrometer is a high-energy MS/MS technique.     

Channel flow cell studies on the evaluation of surface pretreatments using phosphoric acid or polymaleic acid for calcite stone protection

The dissolution kinetics of surface-pretreated and weathered calcite was investigated in dilute acid using a channel flow cell with microdisk detection. Two pretreatments were studied, polymaleic acid and phosphoric acid. Treatment with polymaleic acid was shown to significantly passivate calcite but to a lesser extent than the phosphoric acid and the former coating was found to be less effective for protection of calcite from acid attack. However, treatment of calcite with phosphoric acid resulted in the passivation of calcite from acid attack which strongly inhibited dissolution, an effect that was enhanced even further after exposure to the environment.     

Selective cleavage of P-N bonds and the conversion of rhodium N-pyrrolyl phosphine complexes into diphosphoxane-bridged dimers

Rhodium(I) complexes trans-[RhCl(CO)(PR(2)[NC(4)H(3)C(O)Me-2])(2)] (R = Ph, NC(4)H(4)) react with water to give the diphosphoxane-bridged dimers [Rh(2)Cl(2)(CO)(2)(mu-PR(2)OPR(2))(2)] following cleavage of the P-N bonds to the 2-acetyl-N-pyrrolyl groups. The two dimers have been crystallographically characterized and show a number of structural differences, with the PPh(2)OPPh(2) compound possessing semibridging chloride and carbonyl ligands whereas the P(NC(4)H(4))(2)OP(NC(4)H(4))(2) compound contains only terminal chlorides and carbonyls. No evidence for cleavage of the P-N bonds involving the unfunctionalized N-pyrrolyl groups in trans-[RhCl(CO)(P[NC(4)H(4)](2)[NC(4)H(3)C(O)Me-2])(2)] was observed.     

The reaction of epibromohydrin with hydroxyquinazolin-2-(1H)one derivatives. Novel oxazine formation

Epibromohydrin was found to react with 7-hydroxy-2-methylpyrrolo[1,2-c]quinazolin-5(6H)-one ( 4 ) in the presence of sodium hydroxide to form the novel oxazine 5 . The structure of compound 5 was proven by cmr and pmr analysis.     

Phenylsulfonyl ene-allenes as efficient precursors to bicyclic systems via intramolecular [2 + 2]-cycloaddition reactions

Various phenylsulfonyl allene derivatives were prepared with double bonds tethered either to the alpha-position or the gamma-position of the allene. These substrates underwent a highly regio- and stereospecific thermal [2 + 2]-cycloaddition across the nonactivated cumulene double bond, forming distal cycloadducts (i.e., 57) in the case of alpha-tethered allenes and proximal adducts (i.e., 25) in the case of gamma-tethered allenes. The mechanistic rationale for the observed stereospecificity involves initial diradical formation, followed by a rapid ring closure to the more stable cis-fused ring system. The tether may be equipped with heteroatoms, allowing for the formation of fused heterocycles (e.g., 61), and the cycloaddition can be facilitated by the introduction of sterically bulky groups and/or by conformational rigidity to the tether. Other modes of cyclization were observed in the presence of sodium benzenesulfinate or Lewis acids, in which cases polar mechanisms prevail. The chemoselectivity is reversed for [4 + 2]-cycloadditions, which prefer instead to engage the vinyl sulfone moiety, independent of whether the tether is attached to the alpha- or gamma-position of the allene.     

Toward a microchip-based solid-phase extraction method for isolation of nucleic acids

A silica-based solid-phase extraction system suitable for incorporation into a microchip platform (nu-total analytical system; nu-TAS) would find utility in a variety of genetic analysis protocols, including DNA sequencing. The extraction procedure utilized is based on adsorption of the DNA onto bare silica. The procedure involves three steps: (i) DNA adsorption in the presence of a chaotropic salt, (ii) removal of contaminants with an alcohol/water solution, and (iii) elution of the adsorbed DNA in a small volume of buffer suitable for polymerase chain reaction (PCR) amplification. Multiple approaches for incorporation of this protocol into a microchip were examined with regard to extraction efficiency, reproducibility, stability, and the potential to provide PCR-amplifiable DNA. These included packing microchannels with silica beads only, generating a continuous silica network via sol-gel chemistry, and combinations of these. The optimal approach was found to involve immobilizing silica beads packed into the channel using a sol-gel network. This method allowed for successful extraction and elution of nanogram quantities of DNA in less than 25 min, with the DNA obtained in the elution buffer fraction. Evaluation of the eluted DNA indicated that it was of suitable quality for subsequent amplification by PCR.     

Some structural systematics in metal carbonyl cluster chemistry

The recently developed electron-counting rules for condensed polyhedral metal carbonyl clusters have been utilised to develop a systematic approach for enumerating the structural alternatives for metal cluster compounds which are isoelectronic. The more usual cluster degradation and aggregation processes are represented in a matrix form which relates the change in electron count to the number of new bonds formed (or broken). The matrices for cluster degradation and aggregation are represented in a complementary fashion so that the search for isoelectronic clusters greatly simplified. The utility of the approach is illustrated by reference to some recent examples from metal carbonyl cluster chemistry.     

Rhodium(II)-Catalyzed CH Insertions with {[(4-Nitrophenyl)sulfonyl]imino}phenyl-λ3-iodane

The [Rh₂(OAc)₄]-catalyzed decomposition of {[(4-nitrophenyl)sulfonyl]imino}phenyl-λ³-iodane (NsN?IPh) resulted in formal insertions into CH bonds, activated by phenyl or vinyl groups, or by O-substituents. Scope and limitations of the reaction were investigated. Yields of up to 84% were achieved in the most favorable cases. Yields were enhanced by electron-releasing substituents and decreased by steric hindrance. Aziridination competed with allylic insertion with olefinic substrates. The insertion reaction proceeded with retention of configuration. With chiral Rh^II catalysts, a modest asymmetric induction was observed. A mechanism involving direct insertion by a Rh-complexed nitrene into the CH bond is proposed.     

A one-pot synthesis to [(Me3Si)3SiSb]4; a potential precursor for Sb42-

The reaction of (Me(3)Si)(3)SiK[middle dot]18-crown-6 with SbCl(3)(3 : 1 equiv.) provides a simple route to the title complex [(Me(3)Si)(3)SiSb](4). The potassium base initially acts as a nucleophile and then as a coupling agent, forming Sb-Sb bonds.     

Adiabatic potentials for a bridged three-site electron-transfer system

Born—Oppenheimer potential surfaces for a bridged three-site electron-transfer system are calculated. The adiabatic potentials depend upon both the vibrational sum and difference coordinates. Along the vibrational difference coordinate, the ground-state surface has single-minimun form when the through-bridge electronic coupling is strong, and double-minimum form for weak through-bridge coupling. The results are compared to those previously reported for two-site models.