Dynamics and energetics of the self-assembly of a hydrophobically modified polyelectrolyte: Naphthalene-labeled poly(acrylic acid)

Steady-state and time-resolved fluorescence studies were performed on aqueous solutions of poly(acrylic acid) hydrophobically modified with two very different levels of naphthalene (Np). It is demonstrated that unique information on association phenomena involving hydrophobe-modifed polymers can be obtained from an extended fluorescence study by using data for a less-modified polymer as a reference. For the more highly modified polymer, the presence of excited-state (as well as ground-state) dimers in addition to monomer emission due to locally excited naphthalene gives evidence for hydrophobic association between naphthalene groups. This association becomes, as expected, much less important at higher pH due to the electrostatic repulsion between different chain segments. However, it is noted that even at high pH there is a significant self-association. The coexistence of static and dynamic quenching phenomena of the Np monomer label was also revealed in the time-resolved fluorescence data. The data are compatible with the existence of two types of monomers and one excimer and suggest that the essential contribution to the monomer emission comes from isolated chromophores, whereas excimer formation arises from both a dynamic route (excited Np chromophores able to produce a dynamic excimer) and a static route (excitation of ground-state Np dimers). At room temperature, the dissociative reaction, excimer-to-monomer, can be neglected, and thus the rate constant for excimer formation and decay could be obtained with and without considering the influence of preformed dimers. Temperature has shown to induce different behavior in the polymer photophysics. In the case of the less-labeled polymer, the decays were found to be single-exponential with the fluorescence lifetime decreasing with increasing temperature. From the temperature dependence of the steady-state fluorescence data, the activation energy for excimer formation and the binding energy of the excimer were evaluated at different pH values, through the Stevens-Ban-type plots of the excimer-to-monomer intensity ratio. With the time-resolved data, measured in the temperature range of 5-60 degrees C, it was possible to extract the intrinsic activation energies for excimer formation. The thermodynamic driving force for the intrapolymeric association was found to be dependent on a balance between hydrophobic and electrostatic interactions, which are dependent on the pH, temperature, and hydrophobic content of the polymer.     

Sample preparation improvement in polycyclic aromatic hydrocarbons determination in olive oils by gel permeation chromatography and liquid chromatography with fluorescence detection

The determination of 15 polycyclic aromatic hydrocarbons (PAHs) in olive oil samples has been improved in order to obtain a fast methodology with a low limit of detection through the combination of liquid-liquid extraction with acetonitrile and preparative gel permeation chromatography (GPC) prior to the injection of purified extracts into a C18 column. Acetonitrile-water was used as the mobile phase with a gradient from 50 to 95%, w/w, acetonitrile in 30 min. The oven temperature was maintained at 15 degrees C, and fluorometric detection was made at a fixed excitation wavelength of 264 nm and variable, optimal emission wavelength for each analyte ranging from 352 nm for 11-H-benzo(b)fluorene to 500 nm for indeno(1,2,3-cd)pyrene. Recovery for all the compounds studied varied from 75 to 111%, and limit of detection values from 0.05 ng/g for benzo(k)fluoranthene to 0.48 ng/g for indeno(1,2,3-cd)pyrene, corresponding to 0.09 ng/g benzo(a)pyrene. Results were compared with those obtained by liquid-liquid extraction followed by a cleanup on silica and a direct GPC treatment of oil samples diluted in dichloromethane, 2 other methodologies that are appropriate for quantifying PAHs in olive oils. However, the proposed method improves the determination limits, reduces the time of analysis, and provides a highly stable baseline for sample chromatograms.     

Nutritional parameters of commercially available milk samples by FTIR and chemometric techniques

A chemometric study on the prediction of the main nutritional aspects of milk has been carried out by using fourier transform infrared spectroscopy (FTIR) attenuated total reflectance (ATR) measurements of commercially available milk samples of different types. Whole, semi and skimmed milks, enriched or not with calcium, vitamins or modified by alteration of lipid or sugar composition were considered. After evaluating different strategies for data acquisition and ATR cleaning between samples, hierarchical cluster analysis (HCA) was carried out for classification of samples in order to choose the calibration set. The prediction capabilities of partial least squares (PLS) data treatment were evaluated in order to obtain information about total fat, total protein, total carbohydrates (CH), calories and calcium. On using the mean square error of cross-validation and prediction as control variables, a critical evaluation were made about the calibration set to be used, the spectral range to be considered and the data treatment (PLS-1 or PLS-2) to be performed. By selecting a calibration set of 33 samples the properties of 48 samples were predicted with relative precision of triplicates of 0.062, 0.040 and 0.039% w/v for total fat, protein and carbohydrates, and 0.66 kcal/100 ml for calories, and 2.1 mg of Ca/100 ml. The mean difference (d_x−y) between predicted and actual values and standard deviation of mean differences (s_x−y), were of 0.06 (0.38), 0.03 (0.18) and −0.15 (0.41), being s_x−y values between brackets, for total fat, proteins and carbohydrates, 0.06 (3.8) kcal/100 ml for calories and −4.5 (9) mg/100 ml for calcium.The sensitivity and selectivity of the methodology developed were evaluated on terms of the net analyte signal. Selectivity factors ranging from 2 to 7.6% have been calculated for the five parameters considered.     

New [Mo(eta3-allyl)(CO)2L3]+ complexes with monodentate or tridentate nitrogen-donor ligands

Cationic complexes [Mo(eta(3)-allyl)(CO)2L3]+ (L3 = either nitrogen-donor tridentate ligand or three monodentate ligands) were prepared in high yield and under mild conditions using as precursors either the triflato complex [Mo(eta(3)-allyl)(OTf)(CO)2(NCMe)2] or the combination of the chloro complex [Mo(eta(3)-allyl)Cl(CO)2(NCMe)2] and the salt NaBAr'(4)(Ar'= 3,5-bis(trifluoromethyl)phenyl). The tridentate ligands employed were 2,2':6',2'-terpyridine (terpy) and cis,cis-1,3,5-cyclohexanetriamine (CHTA), whereas the monodentate ligands imidazole (im) and 3,5-dimethylpyrazole (dmpz) were chosen. In order to stabilize the labile intermediates, an excess of acetonitrile was used in most of the syntheses. However, the pyrazole complex was prepared through a nitrile-free route to avoid reactions at the coordinated nitrile. The solid state structures of [Mo(eta(3)-methallyl)(CO)2(terpy)]OTf (2), [Mo(eta(3)-methallyl)(CO)2(CHTA)]BAr'4 (3), [Mo(eta(3)-methallyl)(CO)2(NCMe)3]BAr'4 (4), [Mo(eta(3)-allyl)(CO)2(im)3]OTf (5) and [Mo(eta(3)-allyl)(CO)2(dmpz)3]BAr'4 (6) were determined by means of single-crystal X-ray diffraction.     

Simple and rapid micellar electrokinetic capillary chromatographic method for simultaneous determination of four antiepileptics in human serum

A very rapid and simple MEKC method was developed for the simultaneous determination of four antiepileptic drugs, ethosuximide (Etho), primidone (Pri), phenytoin (Pht) and carbamazepine (Cbz) in human serum. Sample analysis required only 100 microL of human serum which only needed to be centrifuged, decanted and combined with the running buffer [5.3 mM Na(2)HPO(4)/3.2 mM borax buffer (pH 9.5) containing 55 mM SDS and 3.5% (v/v) acetone]. The analysis was performed in only 10 min into fused-silica capillaries (57 cm total length with 50 microm i.d. and 50 cm to the detector) using the MEKC methodology with diode-array detection at 220 nm. The calibration graphs were established for ethoximide, primidone, phenytoin and carbamazepine between 0 and 20 mg/L. Recoveries were between 85 and 87%. The simplicity of the proposed methodology makes it suitable for routine clinical use, especially for epileptic patients on polytherapy.     

Multicommutation as an environmentally friendly analytical tool in the hydride generation atomic fluorescence determination of tellurium in milk

The aim of this study is to show the advantages of the emerging multicommutation methodology based on the use of solenoid valves for Te determination in milk by hydride generation atomic fluorescence spectrometry (HG-AFS). The delivery of a series of alternating sequential insertions of small volumes of samples and reagents gives rise to new hydrodynamic processes and exciting analytical potentials by controlling the time of flow through the on/off-switched solenoid valves. This drastically reduces the reagent consumption by a factor of 4 and the generation of effluents (590 mL h^–1 instead of 750 mL h^–1 generated by the continuous-mode measurement) and also provides an improvement in the laboratory productivity by an increase of the sample throughput (85 h^–1 compared to 20 h^–1 found in the continuous mode). So, multicommutation is an environmentally and economically sustainable alternative to the methodology based on continuous measurements. The multicommutation-based method developed was applied to tellurium determination in commercially available milk samples; a calibration range of 0.0–0.5 ng mL^–1 and a detection limit of 0.20 ng L^–1 with average relative standard deviation of 2.1% were found. Comparable results were obtained for a series of samples using both continuous and multicommutation HG-AFS modes.     

Electronic structure and properties of isoreticular metal-organic frameworks: the case of M-IRMOF1 (M = Zn, Cd, Be, Mg, and Ca)

We investigate the possibility of tailoring the electronic properties of isoreticular metal-organic materials by replacing the metal atom in the metal-organic cluster and by doping. The electronic structure of M-IRMOF1, where IRMOF1 stands for isoreticular metal-organic framework 1 and M = Be, Mg, Ca, Zn, and Cd, was examined using density-functional theory. The results show that these materials have similar band gaps (ca. 3.5 eV) and a conduction band that is split into two bands, the lower of which has a width that varies with metal substitution. This variation prompted us to investigate whether doping with Al or Li could be used to tailor the electronic properties of the Zn-IRMOF1 and Be-IRMOF1 materials. It is shown that replacing one metal atom with Al can effectively be used to create IRMOFs with different metallic properties. On the other hand, adding Li produces structural changes that render this approach less suitable.     

Human serum albumin-mediated stereodifferentiation in the triplet state behavior of (S)- and (R)-carprofen

A remarkable stereodifferentiation has been observed in the interaction between the excited triplet state of carprofen (CP) and human serum albumin (HSA). Time-resolved measurements using laser flash photolysis reveal the presence of two components with different lifetimes in triplet decay. This is explained by complexation of CP to the two possible HSA binding sites. The shorter-lived components are ascribed to the CP/HSA complexes in site I, where stereodifferentiation is more important (tauR/tauS ca. 4). This is correlated with formation of a dehalogenated photoproduct upon steady-state photolysis.     

A fluorimetric study of pindolol and its complexes with cyclodextrins

Spectrofluorimetric characteristics of pindolol have been investigated with the aim of using this technique for analytical determinations. Other monosubstituted indole derivatives, 4-methoxy and 5-methoxyindole, have been also studied for comparative purposes. Corrected excitation and emission wavelengths in different solvents are reported and the effect of solvent on the Stokes shifts of these compounds has been analysed using the Lippert equation. In addition, the Stokes shift of pindolol has been determined in dioxan-water solvent mixtures and the presence of specific solvent effects is discussed. The fluorescence of pindolol is pH dependent, the quantum yields determined in water are lower than those in other solvents. With respect to the sensitivity, it has been found that the detection limits in aqueous solutions are improved in the presence of beta and methyl-beta-cyclodextrin. Finally, a fluorimetric analysis of the interaction between pindolol and different cyclodextrins has been carried out in order to determine the apparent stability constants of the complexes and the thermodynamic parameters associated to complexation.     

Fluorimetric determination of aflatoxins by flow-injection analysis

Summary A fast and inexpensive fluorimetric method for the determination of total aflatoxins (B₁, B₂, G₁, and G₂) in food of use in screening numerous samples suspectedly containing these substances is proposed. The sensitivity of the method (determination range between 0.5 and 200.0 ng ml^–1) allows these analytes to be detected at concentrations well below legal limits; hence, separation-detection techniques such as HPLC need only be used with samples in which these compounds are found to occur. The method has been applied to maize, peanut and tapioca samples, obtaining average recoveries of 100.9 with deviations of ±5% with respect to 100% recovery.

---

Fluorometrische Bestimmung von Aflatoxinen durch Fließinjektionsanalyse