The Cu- and Zn-complex-catalyzed methanolysis of the chemical warfare nerve agents soman,sarin, and VX

The catalytic methanolysis of the chemical warfare nerve agents soman, sarin, and VX was investigated by using Cu or Zn complexes. Although VX withstood decontamination, the decomposition yield being around 96%, the soman and sarin deposited on different surfaces were almost fully destroyed under ambient conditions. The catalytic tests performed on a wide range of contaminated surfaces confirm the activity of the investigated catalytic systems, these complexes being suitable, from an economical point of view, for use in the formulation of a possible decomposition kit with military or civilian applicability.     

On the correlation between thermal analysis results and corrosion behaviour of some metallic religious artefacts

The aim of this study was to investigate the effects of immersion time on the electrochemical corrosion behaviour of three brass alloys (CuZn) coming from religious artefacts in simulated acid rain at 25 °C, utilising the electrochemical impedance spectroscopy (EIS). The main parameters of the corrosion process were established. On the other hand, the alloys were also analysed by means DSC and TG/DTA before and after immersion in the corrosive environment. Finally, the obtained results were compared in order to correlate them with each other and with the corrosion process.     

“Surface water” and “strong-bonded water” in cyclodextrins: a Karl Fischer titration approach

Cyclodextrins are some of the most used carriers for bioactive compounds (as host–guest complex) and many factors influence the association–dissociation of this complex, some of them being related to hydrophobicity. In the solid state, cyclodextrins contain two types of water molecules: “surface” water molecules (especially close to the crystal surface) and “strong-bonded” water molecules (especially from the cyclodextrin cavity), but the classification is hard to do, and the concentration of these water molecules are relatively difficult to estimate by simple methods. In the present study we used the volumetric Karl Fischer titration to estimate these types of water molecules in cyclodextrins by means of the rate of water reaction (related to diffusion from cyclodextrin crystals). “Surface” water molecules are titrated with rates between 1.8–2.8 mM/s for α-cyclodextrin, while for β-cyclodextrin these rates are little bit higher (2.9–3.4 mM/s). The rates corresponding to “strong-bonded” water molecules are approximately tens fold lower (0.05–0.3 mM/s for α-cyclodextrin and 0.15–0.33 mM/s for β-cyclodextrin). The approximate ratio between “surface” and “strong-bonded” water molecules could also be estimated by this simple and rapid method.     

Investigation of thermal stability, spectral, magnetic, and antimicrobial behavior for new complexes of Ni(II), Cu(II), and Zn(II) with a bismacrocyclic ligand

Novel complexes of type M₂LCl₄·nH₂O (M: Ni, n = 4; M: Cu, n = 2.5 and M: Zn, n = 1.5; L: ligand resulted from 1,3-phenylenediamine, 3,6-diazaoctane-1,8-diamine, and formaldehyde one-pot condensation) were synthesized and characterized. The ligand was also isolated and characterized. The complexes features have been assigned from microanalytical, electrospray ionization tandem mass spectrometry, IR, UV–vis, ¹H NMR, and EPR spectra as well as magnetic data at room temperature. Simultaneous thermogravimetric/dynamic scanning calorimetry/evolved gas analysis measurements were performed to evidence the nature of the gaseous products formed in each step. Processes as water elimination, fragmentation, and oxidative degradation of the organic ligand as well as chloride elimination were observed during the thermal decomposition. The final product of decomposition was metal(II) oxide except for copper complex where CuCl remained also in the oxide network. The complexes exhibited an improved antibacterial activity in comparison with the ligand concerning both planktonic as well as biofilm-embedded cells.     

Performance of Pleurotus ostreatus Mushrooms and Spent Substrate for the Biosorption of Cd(II) From Aqueous Solution

The capacities of Pleurotus ostreatus mushroom and spent substrate were evaluated for the biosorption of cadmium (II) from aqueous solution in order to select the most efficient material for bioremediation. The optimum sorption conditions were optimized, including the pH of the aqueous solution, contact time, biomass dosage, initial metal concentration, and temperature. The sorption of cadmium on both biosorbents was also evaluated by several kinetic, equilibrium, and thermodynamic models. The possible heavy metal biosorption mechanisms were evaluated through point of zero charge (pH_pzc), Fourier-transform infrared (FTIR) spectroscopy and scanning electron microscopy coupled with energy dispersive X-ray microanalysis (SEM-EDX). Based on the results of column studies, the effectiveness of the P. ostreatus spent substrate was confirmed as a biosorbent for Cd(II) removal from aqueous solutions.     

The use of stable isotopes ratios for authentication of fruit juices

The determination of the content of stable isotopes, ¹⁸O and ²H, respectively, in juice water facilitates the distinction between authentic juices and juices made from concentrates by redilution with tap water. At the same time, the detection of C₄ cane or corn-derived sugar syrups in fruit juices which are produced from C₃ fruit types is thus facilitated by the characteristic differences in ¹³C/¹²C, expressed as δ ¹³C (‰) values due to photosynthetic CO₂ assimilation via the C₃₋, C₄₋, and crassulacean acid metabolism pathways. In this study, the quantitative determination of water added to an authentic juice, on the basis of δ ¹⁸O, and δ ²H values, respectively, was successfully performed. Also, the δ ¹⁸O, and δ ²H of juice water and δ ¹³C of the whole juice in 18 samples were also determined. The results obtained provided us with the possibility of distinguishing between authentic fruit juices and those obtained by redilution of concentrated fruit juices and the detection of C⁴ type added sugar.     

Involvement of cyan and ester groups in surface interactions of aerosil–cyanophenyl alkyl benzoate systems with high silica density: Infrared investigations

Composites prepared from aerosil A380 and liquid crystals (LCs) of 4-n-alkyl-4′-cyanophenyl benzoate type, with four to six carbon atoms in the alkyl chain were investigated by infrared spectroscopy. Their high silica content (of 2–7 g aerosil/1 g of LC) was given by thermogravimetric investigations and allows the observation of a rather thin LC layer on the silica particles. Several surface species onto the external surface of the grains were demonstrated. Arguments are given that monomer and dimer species are present in the bulk cyanophenyl benzoate materials while bulk-like species along with hydrogen-bonded ones coexist in the so-called surface layer of the composites. The main interaction of LC molecules with the aerosil surface is by hydrogen bonding taking place with the involvement of the cyan group. There is a contribution of ester carbonyl group to these surface interactions but this cannot be well quantified.     

Birefringence dispersion of N-(4-methoxybenzylidene)-4-butylaniline (MBBA) determined from channeled spectra

The birefringence of MBBA, determined from the channeled spectra, decreases when the wavelength increases, showing a normal dispersion. The changes induced by an external electrostatic field acting perpendicular on the nematic director in the birefringence values were evidenced. The birefringence increases with the electrostatic field intensity which enhances the preferential alignment by the big values of the electric dipole moments induced parallel to the long MBBA molecule. The main refractive indices were interferometrically measured for three visible monochromatic radiations and the birefringence values were concordant with those estimated from the channeled spectra. The main molecular polarizabilities were estimated.     

Electronic structures of tris(dioxolene)chromium and tris(dithiolene)chromium complexes of the electron-transfer series [Cr(dioxolene)(3)](z) and [Cr(dithiolene)(3)](z) (z = 0, 1-, 2-, 3-). A combined experimental and density functional theoretical study

From the reaction mixture of 3,6-di-tert-butylcatechol, H2[3,6L(cat)], [CrCl3(thf)3], and NEt3 in CH3CN in the presence of air, the neutral complex [CrIII(3,6L*(sq))3] (S = 0) (1) was isolated. Reduction of 1 with [Co(Cp)2] in CH2Cl2 yielded microcrystals of [Co(Cp)2][CrIII(3,6L*(sq))2(3,6L(cat))] (S = 1/2) (2) where (3,6L*(sq)(1-) is the pi-radical monoanionic o-semiquinonate of the catecholate dianion (3,6Lcat)(2-). Electrochemistry demonstrated that both species are members of the electron-transfer series [Cr(3,6LO,O)]z (z = 0, 1-, 2-, 3-). The corresponding tris(benzo-1,2-dithiolato)chromium complex [N(n-Bu)4][CrIII(3,5L*S,S)2(3,5LS,S)] (S = 1/2) (3) has also been isolated; (3,5LS,S)(2-) represents the closed-shell dianion 3,5-di-tert-butylbenzene-1,2-dithiolate(2-), and (3,5L*S,S)(1-) is its monoanionic pi radical. Complex 3 is a member of the electron-transfer series [Cr(3,5L(S,S))3]z (z = 0, 1-, 2-, 3-). It is shown by Cr K-edge and S K-edge X-ray absorption, UV-vis, and EPR spectroscopies, as well as X-ray crystallography, of 1 and 3 that the oxidation state of the central Cr ion in each member of both electron-transfer series remains the same (+III) and that all redox processes are ligand-based. These experimental results have been corroborated by broken symmetry density functional theoretical calculations by using the B3LYP functional.