Thermally stimulated current and DSC studies of the broadened glass transition in liquid crystalline polymers

The high sensitivity of the thermally stimulated current, thermal sampling (TS) method is emphasized in a study of the breadth of the glass transition in several liquid-crystalline polymers (LCPs). Differential scanning calorimetry (DSC) was performed on all samples to further quantify the glass transition regions. For “random” copolyester LCPs with widely varying degrees of crystallinity, including highly amorphous samples, very broad glass tran-sition regions were observed. One semicrystalline alternating copolyester and a series of semicrystalline azomethine LCPs were studied as examples of structurally regular polymers. These exhibited relatively sharp glass transitions more comparable to ordinary isotropic amorphous or semicrystalline polymers. The broad glass transitions in the random copolyesters are attributed to structural heterogeneity of the chains. In one example of a moderate-crystallinity random copolyester LCP (Vectra), glass transitions ranging up to ca. 150°C in breadth were determined by the thermal sampling (TS) method and DSC. In other lower crystallinity copolyester LCPs, the main glass transition temperature as determined by DSC was comparable to that determined by TSC although cooperative relaxations of a minor fraction of the overall relaxing species were detected well below the main T_g, by the TS method and not by DSC. Rapid quenches from the isotropic melt to an isotropic glass were possible with one LCP. The anisotropic and isotropic glassy states for this LCP were found to have the same breadth of the glass transition as was determined by the TS method, although TSC and DSC show that T_g is shifted downward by ca. 15°C in the anisotropic glass as compared to the isotropic glass. © 1993 John Wiley & Sons, Inc.     

Counterion and solvent effects on the dilute solution viscosity of polystyrene ionomers

We present an analysis of data on the intrinsic viscosity [η] of sulfo-polystyrene ionomers in several solvents for a variety of sulfonation levels and counterions. For solvents of low dielectric constant, 2 < ε < 18, [η] decreases from the base polymer value [η]₀ with increasing substitution level. This behavior was attributed to intramolecular association of ionic dipoles. The ratio [η]/[η]₀ was found to depend on a single reduced variable α_Aα_Sx, where x is the fractional substitution, α_A depends only on the counterion, and α_S ∝ ε^?1 depends only on the solvent. For solvents of high dielectric constant, 36 < ε < 47, [η] increases approximately as x³, and counterion effects are small. This behavior was attributed to ionic dissociation, giving rise to a polyelectrolyte effect. Implications of the low ε results are discussed in relation to association-induced gelation behavior and possible generalizations of the reduced variables approach.     

Synthesis and cationic photopolymerization of new fluorinated,polyfunctional propenyl ether oligomers

New fluorinated, polyfunctional propenyl ether functionalized resins were synthesized, and their behavior in cationic photopolymerization was investigated. The photopolymerization proceeded efficiently with a high double‐bond conversion (>90%), giving rise to UV‐cured coatings characterized by low glass‐transition temperatures (?33 °C ≤ glass‐transition temperature ≤ ?15 °C) and hydrophobic surface properties. A fluorinated additive was also employed as a reactive additive in the cationic photopolymerization of trimethylolpropane tripropenyl ether, increasing the double‐bond conversion, polymer network flexibility, thermal stability, and surface hydrophobicity. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 6943–6951, 2006     

Gold ultra-microelectrode arrays: application to the steady-state voltammetry of hydroxide ion in aqueous solution.

Gold ultra-microelectrode arrays are used to explore the electrochemical oxidation of hydroxide ions and are shown to be analytical useful. Two types of ultra-microelectrode arrays are used; the first consist of 256 individual electrodes of 5 microm in radius, 170 of which are electrochemically active in a cubic arrangement which are separated from their nearest neighbour by a distance of 100 microm. The second array compromises 2597 electrodes of 2.5 microm in radius and of which 1550 of which are electrochemically active in a hexagonal arrangement separated by the nearest neighbour by 55 microm. Well defined voltammetric waves are found with peak currents proportional to the concentration of hydroxide ions in the range 50 microM to 1 mM. Detection limits of 20 microM using the 170 ultra-microelectrode and 10 microM with the 1550 ultra-microelectrode array are shown to be possible but with a higher sensitivity of 4 mA M(-1) observed using the 1550 ultra-microelectrode array compared to 1.2 mA M(-1) with the 170 ultra-microelectrode array.     

Moisture sorption, transport, and hydrolytic degradation in polylactide

Management of moisture penetration and hydrolytic degradation of polylactide (PLA) is extremely important during the manufacturing, shipping, storage, and end-use of PLA products. Moisture transport, crystallization, and degradation, in PLA have been measured through a variety of experimental techniques including size-exclusion chromatography, differential scanning calorimetry, and X-ray diffraction. Quartz crystal microbalance and dynamic vapor sorption experiments have also been used to measure moisture sorption isotherms in PLA films with varying crystallinity. A surprising result is that, within the accuracy of the experiments, crystalline and amorphous PLA films exhibit identical sorption isotherms.     

The response of microstructure to processing in a series of poly(siloxaneimide) copolymers

Poly(siloxaneimide) (PSI) segmented copolymers exhibit organized microdomains if the blocks are sufficiently incompatible. As with neat diblock and triblock copolymers, the processing route employed to prepare films of PSI materials is expected to influence the dimensions and/or morphology of the resultant microstructure. In this work, small-angle neutron scattering (SANS) is utilized to characterize the disordered microstructure found in films of a series of PSI copolymers which are subjected to solvent casting and various thermal treatments. Microstructural dimensions such as the periodicity and correlation length are deduced from the Teubner-Strey (TS) model for disordered microemulsions. The scattering intensity of each copolymer up to q = 5.0 nm^?1, where q is the scattering vector, is found to scale as q^?2.8+?0.1. Results indicate that processing the materials as cast films or as melt-pressed films allowed to cool slowly has a small, but discernible, effect on microstructural characteristics. SANS profiles of films quenched from elevated temperatures reveal a clear transition in microdomain periodicity, which correlates well with the glass transition temperature of the imide microphase in these and other materials of similar chemical structure. © 1993 John Wiley & Sons, Inc.     

Exponential convergence for one dimensional contact processes

The complete convergence theorem implies that starting from any initial distribution the one dimensional contact process converges to a limit ast. In this paper we give a necessary and sufficient condition on the initial distribution for the convergence to occur with exponential rapidity.This work was discussed while the authors were visiting the Nankai Mathematics Institute in Tianjin.Partially supported by the National Science Foundation, the Army Research Office through the Mathematical Sciences Institute at Cornell University, and a Guggenheim fellowship.Research supported by the National Science Foundation of China.     

Homogeneous equation of thermoacoustics: Low frequency approximation

In this article, homogeneous Parker's equation is solved. Relations for temperature, velocity and pressure are found. The possibility of low frequency approximation is shown and thermoacoustic effect in gas near plane motionless wall is treated.I would like to thank Prof. Zdenk kvor for his interest and encouragement.