Analysis of Biological Samples Using Paper Spray Mass Spectrometry: An Investigation of Impacts by the Substrates, Solvents and Elution Methods

Paper spray has been developed as a fast sampling ionization method for direct analysis of raw biological and chemical samples using mass spectrometry (MS). Quantitation of therapeutic drugs in blood samples at high accuracy has also been achieved using paper spray MS without traditional sample preparation or chromatographic separation. The paper spray ionization is a process integrated with a fast extraction of the analyte from the raw sample by a solvent, the transport of the extracted analytes on the paper, and a spray ionization at the tip of the paper substrate with a high voltage applied. In this study, the influence on the analytical performance by the solvent–substrate systems and the selection of the elution methods was investigated. The protein hemoglobin could be observed from fresh blood samples on silanized paper or from dried blood spots on silica-coated paper. The on-paper separation of the chemicals during the paper spray was characterized through the analysis of a mixture of the methyl violet 2B and methylene blue. The mode of applying the spray solvent was found to have a significant impact on the separation. The results in this study led to a better understanding of the analyte elution, on-paper separation, as well as the ionization processes of the paper spray. This study also helps in establishing a guideline for optimizing the analytical performance of paper spray for direct analysis of target analytes using mass spectrometry.     

Synthesis and characterisation of sterically stabilised polypyrrole particles using a chemically reactive poly(vinyl amine)-based stabiliser

Poly(vinyl amine) (PVAm) was derivatised using 2-thiophenecarboxaldehyde via Michael addition to prepare a statistical copolymer stabiliser for the synthesis of primary amine-functionalised polypyrrole (PPy) particles. A minimum stabiliser concentration of around 20 % (w/v) relative to pyrrole was required for well-defined PPy particles of approximately 100–200 nm, as judged by transmission electron microscopy (TEM) and dynamic light scattering (DLS). FTIR spectroscopy confirmed that stabiliser grafting had occurred, while x-ray photoelectron spectroscopy (XPS) studies indicated a stabiliser surface coverage on the PPy particles of around 53 %. PPy particles prepared at stabiliser concentrations below 20 % (w/v) were not colloidally stable above pH 6. However, higher stabiliser concentrations (e.g., 50 % (w/v) based on pyrrole) led to a significant improvement, with colloidal stability being retained above pH 7. Long-term colloidal stability studies of PPy particles stored at pH 7.5 confirmed that the amine-based stabiliser produced more stable aqueous dispersions than the imine-based stabiliser, since the latter bond is hydrolytically unstable.     

Hydrothermal processing of waste pine wood into industrially useful products

An ongoing major outbreak of mountain pine beetle in Western Canada has provided a clear opportunity to utilize waste pinewood as a source of renewable energy. Therefore hydrothermal processing of waste pinewood as a feedstock for bio-oil and biochar production using subcritical and supercritical water technology was carried out in semi-batch mode to investigate the effect of pressure (200–400 bar) and temperature (300–400 °C) on the yield and composition of bio-oil. The pinewood samples have very high cellulose and hemicellulose content but low ash content and are thus a formidable feedstock for bioenergy production. The optimum conditions for the hydrothermal processing of the pinewood in a tubular reactor were found to be 400 °C and 250 bars with respect to biochar and bio-oil yield based on the highest calorific value analysis. Detailed characterization of bio-oil and biochar was performed using GCMS, NMR, SEM, calorific value, and elemental analysis, respectively. The critical components of bio-oil were found to be phenols, methoxyphenols, hydroxymethyl furfural (HMF), and vanillin, whereas as compared to the raw pine wood, the biochar was considerably lower H:C and O:C ratios than those of the unprocessed pinewood. The analyses of bio-oil by means of GCMS and ¹H NMR showed that it was mainly composed of heterocyclic compounds, phenols, aldehydes and acids.     

CO Oxidation Catalytic Effects of Intrinsic Surface Defects in Rhombohedral LaMnO3

There is an ongoing effort to replace rare and expensive noble-element catalysts with more abundant and less expensive transition metal oxides. With this goal in mind, the intrinsic defects of a rhombohedral perovskite-like structure of LaMnO₃ and their implications on CO catalytic properties were studied. Surface thermodynamic stability as a function of pressure (P) and temperature (T) were calculated to find the most stable surface under reaction conditions (P=0.2 atm, T=323 K to 673 K). Crystallographic planes (100), (111), (110), and (211) were evaluated and it was found that (110) with MnO₂ termination was the most stable under reaction conditions. Adsorption energies of O₂ and CO on (110) as well as the effect of intrinsic defects such as Mn and O vacancies were also calculated. It was found that O vacancies favor the interaction of CO on the surface, whereas Mn vacancies can favor the formation of carbonate species.     

Hypertension in Prenatally Undernourished Young-Adult Rats Is Maintained by Tonic Reciprocal Paraventricular–Coerulear Excitatory Interactions

Prenatally malnourished rats develop hypertension in adulthood, in part through increased α₁-adrenoceptor-mediated outflow from the paraventricular nucleus (PVN) to the sympathetic system. We studied whether both α₁-adrenoceptor-mediated noradrenergic excitatory pathways from the locus coeruleus (LC) to the PVN and their reciprocal excitatory CRFergic connections contribute to prenatal undernutrition-induced hypertension. For that purpose, we microinjected either α₁-adrenoceptor or CRH receptor agonists and/or antagonists in the PVN or the LC, respectively. We also determined the α₁-adrenoceptor density in whole hypothalamus and the expression levels of α_1A-adrenoceptor mRNA in the PVN. The results showed that: (i) agonists microinjection increased systolic blood pressure and heart rate in normotensive eutrophic rats, but not in prenatally malnourished subjects; (ii) antagonists microinjection reduced hypertension and tachycardia in undernourished rats, but not in eutrophic controls; (iii) in undernourished animals, antagonist administration to one nuclei allowed the agonists recover full efficacy in the complementary nucleus, inducing hypertension and tachycardia; (iv) early undernutrition did not modify the number of α₁-adrenoceptor binding sites in hypothalamus, but reduced the number of cells expressing α_1A-adrenoceptor mRNA in the PVN. These results support the hypothesis that systolic pressure and heart rate are increased by tonic reciprocal paraventricular–coerulear excitatory interactions in prenatally undernourished young-adult rats.     

Observation of B-->eta'K* and evidence for B+-->eta'rho+

We present an observation of B-->eta'K*. The data sample corresponds to 232x10(6) BB[over ] pairs collected with the BABAR detector at the PEP-II asymmetric-energy B factory at the Stanford Linear Accelerator Center. We measure the branching fractions (in units of 10(-6)) B(B(0)-->eta'K*0)=3.8+/-1.1+/-0.5 and B(B+-->eta'K*+)=4.9(1.7)(+1.9)+/-0.8, where the first error is statistical and the second systematic. A simultaneous fit results in the observation of B-->eta'K* with B(B-->eta'K*)=4.1(-0.9)(+1.0)+/-0.5. We also search for B-->eta'rho and eta'f(0)(980)(f(0)-->pi+pi-) with results and 90% confidence level upper limits B(B+-->eta'rho+)=8.7(-2.8-1.3)(+3.1+2.3) (<14), B(B(0)-->eta'rho0)<3.7, and B(B(0)-->eta'f(0)(980)(f(0)-->pi+pi-))<1.5. Charge asymmetries in the channels with significant yields are consistent with zero.     

Spin‐State Ordering on One Sub‐lattice of a Mononuclear Iron(III) Spin Crossover Complex Exhibiting LIESST and TIESST

The two‐step spin crossover in mononuclear iron(III) complex [Fe(salpm)₂]ClO₄ ? 0.5 EtOH ( 1 ) is shown to be accompanied by a structural phase transition as concluded from ⁵⁷Fe Mössbauer spectroscopy and single crystal X‐ray diffraction, with spin‐state ordering on just one of two sub‐lattices in the intermediate magnetic and structural phase. The complex also exhibits thermal‐ and light‐induced spin‐state trapping (TIESST and LIESST), and relaxation from the LIESST and TIESST excited states occurs via the broken symmetry intermediate phase. Two relaxation events are evident in both experiments, that is, two T(LIESST) and two T(TIESST) values are recorded. The change in symmetry which accompanies the TIESST effect was followed in real time using single crystal diffraction. After flash freezing at 15 K the crystal was warmed to 40 K at which temperature superstructure reflections were observed to appear and disappear within a 10 000 s time range. In the frame of the international year of crystallography, these results illustrate how X‐ray diffraction makes it possible to understand complex ordering phenomena.     

Stress-Induced Domain Wall Motion in a Ferroelastic Mn3+ Spin Crossover Complex

Domain wall motion is detected for the first time during the transition to a ferroelastic and spin state ordered phase of a spin crossover complex. Single-crystal X-ray diffraction and resonant ultrasound spectroscopy (RUS) revealed two distinct symmetry-breaking phase transitions in the mononuclear Mn³⁺ compound [Mn(3,5-diBr-sal₂(323))]BPh₄, 1. The first at 250 K, involves the space group change Cc→Pc and is thermodynamically continuous, while the second, Pc→P1 at 85 K, is discontinuous and related to spin crossover and spin state ordering. Stress-induced domain wall mobility was interpreted on the basis of a steep increase in acoustic loss immediately below the the Pc-P1 transition     

A High Performing Zn‐Ion Battery Cathode Enabled by In Situ Transformation of V2O5 Atomic Layers

Developing high capacity and stable cathodes is a key to successful commercialization of aqueous Zn‐ion batteries (ZIBs). Pure layered V₂O₅ has a high theoretical capacity (585 mAh g^?1), but it suffers severe capacity decay. Pre‐inserting cations into V₂O₅ can substantially stabilize the performance, but at an expense of lowered capacity. Here we show that an atomic layer deposition derived V₂O₅ can be an excellent ZIB cathode with high capacity and exceptional cycle stability at once. We report a rapid in situ on‐site transformation of V₂O₅ atomic layers into Zn₃V₂O₇(OH)₂?2 H₂O (ZVO) nanoflake clusters, also a known Zn‐ion and proton intercalatable material. High concentration of reactive sites, strong bonding to the conductive substrate, nanosized thickness and binder‐free composition facilitate ionic transport and promote the best utilization of the active material. We also provide new insights into the V₂O₅‐dissolution mechanisms for different Zn‐salt aqueous electrolytes and their implications to the cycle stability.     

Explicit solutions and Darboux transformations of a generalized D-Kaup–Newell hierarchy

Nonlinear Dynamics - Darboux and Bäcklund transformations on integrable couplings are formulated and generalized. The generalization of the theory pertains to spectral problems where the...