Novel 1,2,4‐triazole isonucleosides (1 and 2) were efficiently synthesized starting from D‐ribose and D‐xylose, respectively. The key steps were condensation of cyclic sulfate 8 with methyl‐1,2,4‐triazole‐3‐carboxylate and nucleophilic displacement of the tosylate 15 with methyl‐1,2,4‐triazole‐3‐carboxylate, respectively. 相似文献
Samarium(II) iodide promoted reductive deacetoxylation of 7-aminocephalosporanic acid derivatives to synthesize 3-alkylidenecepham-4-carboxylates, which could be valuable intermediates for the synthesis of new cephalosporin antibiotics, was investigated. 相似文献
We have studied cell gap-dependent driving voltage characteristics in a homogeneously aligned nematic liquid crystal (LC) cell driven by a fringe electric field, termed the fringe field switching (FFS) mode. The results show that for the FFS mode using a LC with positive dielectric anisotropy, the operating voltage decreases as the cell gap decreases, whereas it increases with a decreasing cell gap when using a LC with negative dielectric anisotropy. The difference between LCs is explained by simulation and experiment. 相似文献
Although cellulose nanomaterials have promising properties and performance in a wide application space, one hinderance to their wide scale industrial application has been associated with their economics of dewatering and drying and the ability to redisperse them back into suspension without introducing agglomerates or lose of yield. The present work investigates the dewatering of aqueous suspensions of cellulose nanofibrils (CNFs) using ultrasound as a potentially low-cost, non-thermal, and scalable alternative to traditional heat-based drying methods such as spray drying. Specifically, we use vibrating mesh transducers to develop a direct-contact mode ultrasonic dewatering platform to remove water from CNF suspensions in a continuous manner. We demonstrate that the degree of dewatering is modulated by the number of transducers, their spatial configuration, and the flow rate of the CNF suspension. Water removal of up to 72 wt.% is achieved, corresponding to a final CNF concentration of 11 wt.% in 30 min using a two-transducer configuration. To evaluate the redispersibility of the dewatered CNF material, we use a microscopic analysis to quantify the morphology of the redispersed CNF suspension. By developing a custom software pipeline to automate image analysis, we compare the histograms of the dimensions of the redispersed dewatered fibrils with the original CNF samples and observe no significant difference, suggesting that no agglomeration is induced due to ultrasonic dewatering. We also perform SEM analysis to evaluate the nanoscale morphology of these fibrils showing a width range of 20 nm–4 um. We estimate that this ultrasound dewatering technique is also energy-efficient, consuming up to 36% less energy than the enthalpy of evaporation per kilogram of water. Together with the inexpensive cost of transducers (<?$1), the potential for scaling up in parallel flow configurations, and excellent redispersion of the dewatered CNFs, our work offers a proof-of-concept of a sustainable CNF dewatering system, that addresses the shortcomings of existing techniques.
We have fabricated a solution-processed ZnO thin-film transistor without vacuum deposition. ZnO nanoparticles were prepared by the polyol method from zinc acetate, polyvinyl pyrrolidone, and diethyleneglycol. The solution-processable semiconductor ink was prepared by dispersing the synthesized ZnO in a solvent. Inverted stagger type thin-film transistors were fabricated by spin casting the ZnO ink on the heavily doped Si wafer with 200 nm thick SiO2, followed by evaporation of Cr/Au source and drain electrodes. After the drying and heat treatment at 600 C, a relatively dense ZnO film was obtained. The film characteristics were investigated by scanning electron microscopy (SEM) and X-ray diffraction (XRD). In order to obtain the electrical properties of the solution-derived transistor, the on–off ratio, threshold voltage, and mobility were measured. 相似文献
Crown ethers are small, cyclic polyethers that have found wide‐spread use in phase‐transfer catalysis and, to a certain degree, in protein chemistry. Crown ethers readily bind metallic and organic cations, including positively charged amino acid side chains. We elucidated the crystal structures of several protein‐crown ether co‐crystals grown in the presence of 18‐crown‐6. We then employed biophysical methods and molecular dynamics simulations to compare these complexes with the corresponding apoproteins and with similar complexes with ring‐shaped low‐molecular‐weight polyethylene glycols. Our studies show that crown ethers can modify protein surface behavior dramatically by stabilizing either intra‐ or intermolecular interactions. Consequently, we propose that crown ethers can be used to modulate a wide variety of protein surface behaviors, such as oligomerization, domain–domain interactions, stabilization in organic solvents, and crystallization. 相似文献
Simultaneously improving energy efficiency (EE) and material stability in electrochemical CO2 conversion remains an unsolved challenge. Among a series of ternary Sn-Ti-O electrocatalysts, 3D ordered mesoporous (3DOM) Sn0.3Ti0.7O2 achieves a trade-off between active-site exposure and structural stability, demonstrating up to 71.5 % half-cell EE over 200 hours, and a 94.5 % Faradaic efficiency for CO at an overpotential as low as 430 mV. DFT and X-ray absorption fine structure analyses reveal an electron density reconfiguration in the Sn-Ti-O system. A downshift of the orbital band center of Sn and a charge depletion of Ti collectively facilitate the dissociative adsorption of the desired intermediate COOH* for CO formation. It is also beneficial in maintaining a local alkaline environment to suppress H2 and formate formation, and in stabilizing oxygen atoms to prolong durability. These findings provide a new strategy in materials design for efficient CO2 conversion and beyond. 相似文献