Simple Method for Simultaneous Determination of Selenium and Arsenic in Human Hair by Means of Atomic Fluorescence Spectrometry with Hydride Generation Technique

This study describes a simple, rapid and reliable method for simultaneous determination of selenium and arsenic in human hair by means of atomic fluorescence spectrometry combined with a hydride generation technique (HG-AFS). The procedure developed encompasses microwave digestion of a sample in the nitric acid environment only. The interferences caused by nitrous oxides are eliminated by removing a gas from above the digested solution with a stream of argon. The sample is then chemically treated in a flow-through hydride generation system and exposed to measurements in a double-channel atomic fluorescence spectrometer. The method permits determining both analytes in the linear range of 0.5–100µgL^–1 with a detection limit equal to 0.2µgL^–1, as well as with very good repeatability not exceeding 1% for Se and 2% for As. No mutual interferences from either of the analytes in the concentrations ranges matching the hair composition were found. The method was verified in terms of accuracy with the use of a reference material and then applied to the analysis of the natural samples of human hair.     

Mutual Solubilities of Water and Alkanes

Summary.  The evaluation of mutual solubility data for systems water with n-alkanes, isoalkanes, and cycloalkanes along the three phase line is reported and a formula for the prediction of solubility of alkanes in water is developed. Then a cubic equation of state with an added term, which accounts for hydrogen bonding is used for correlation of liquid–liquid equilibrium data and for prediction of solubility of water in hydrocarbons using alkane in water solubility data. Comparison of the predicted and experimental solubilities is performed using all accessible experimental data. With this approach it is possible to predict the solubilities of water in alkanes with good accuracy over the temperature range up to about 20 K below critical temperature. Solubility of alkanes in water can also be calculated using experimental data for solubility of water in alkanes but results of these calculations are more sensitive to experimental errors of the data. Corresponding author: E-mail: macz@ichf.edu.pl Received August 5, 2002; accepted (revised) September 13, 2002 Published online March 13, 2003 RID="a" ID="a" Dedicated to Prof. Dr. H. Gamsj?ger on the occasion of his 70^th birthday anniversary     

Magnon spectrum and curie temperature of doped ferromagnetic semiconductors

The influence of a partially filled conduction band on the magnetic properties of ferromagnetic semiconductors is studied within the framework of thes-f model. Allowing for magnon scattering to arbitrary order in the form of virtual electron- holecreation the magnon spectral density is derived, from which one gets magnon energies which are substantially renormalized by the presence of conduction electrons. In particular it is shown how the quasiparticle structure of the electronic excitation energies [4, 5] leads to scattering corrections in the magnon spectrum. These corrections are always negative and reduce the positive mean field part, which is proportional to the electron densityn. The calculated magnon spectrum is then used to determine the strikingn-dependence of the Curie-temperatureT _c of Gd-doped EuO and EuS.     

Application of kinetic investigations for interpretation ofn-hexane and benzene adsorption on active carbon

Differencies between the mechanism ofn-hexane and benzene adsorption on active carbon were investigated on the ground of kinetic measurements. As it has been stated, the kinetic measurements show fundamental differencies between the mechanism of adsorption in spite of analogy existing in the state of adsorption equilibrium. Within the range investigated, only the adsorption ofn-hexane follows the model of volume filling of micropores. Existence of those differencies is also confirmed by measurements of effective diffusion coefficient values as well as changes of activation energy of the diffusion—adsorption process.

---

Anwendung kinetischer Untersuchungen zur Interpretation des Adsorptionsverhaltens vonn-Hexan und Benzol an Aktivkohle

Zusammenfassung Mittels kinetischer Messungen untersuchte man die Unterschiede im Mechanismus des Adsorptionsverlaufes vonn-Hexan und Benzol an Aktivkohle. Man stellte fest, daß trotz der Analogie im Adsorptionsgleichgewichtszustand die kinetischen Messungen auf prinzipielle Unterschiede im Adsorptionsmechanismus hinweisen. Im untersuchten Bereich verläuft nur die Adsorption vonn-Hexane nach dem Modell der Mikroporenvolumenausfüllung. Die auftretenden Unterschiede wurden auch durch die Berechnungen der Werte der effektiven Diffusionskoeffizienten sowie Änderungen der Aktivierungsenergie des Diffusions-Adsorptionsprozesses bestätigt.

     

Determination of total carbon and total organic carbon from volatile air pollutants

Summary The method developed based on the determination of TC and TOC in the form of the total amount of CO₂ requires application of the proper techniques for the final determination of CO₂. The possibility of using a stream of carrier gas at a convenient flow-rate for desorbing quantitatively CO₂ concentrated on a molecular sieve permits use of a wide variety of known analytical techniques for the final determination of CO₂. Various methods were compared on the basis of both absolute and calibration measurements. The absolute methods chosen were gravimetric (classical or an automated version based on application of a gravimetric automat and automatic recording balance), thermogravimetric analysis and coulometry. The calibration methods included thermal conductivity, the flame-ionization detector (after conversion of CO₂ into methane) and infrared absorption. Usefulness of the methods was evaluated on the basis of comparative statistical analysis of experimental data with respect to precision (Snedecor'sF-test and Bartlett'sU ²-test) and accuracy (Student'st-test).

---

Zusammenfassung Das entwickelte Verfahren zur Bestimmung des TC- und TOC-Gehaltes in Form der gesamten Menge CO₂ erfordert die Anwendung geeigneter Analysentechniken zur Endbestimmung dieser Verbindung. Die Möglichkeit einer Desorption des am Molekularsieb angereicherten CO₂ in einem Gasstrom mit geeignetem Durchfluß erlaubt zur Endbestimmung von CO₂ die Anwendung einer Reihe verschiedener Analysenverfahren. Die Anwendbarkeit verschiedener, auf Absolutverfahren und auch auf relativen Messungen beruhender Methoden wurde vergleichend untersucht. Die folgenden Methoden zur CO₂-Bestimmung wurden gewählt: die Gravimetrie (klassische oder automatisierte unter Einsatz eines Wägeautomaten und einer registrierenden Waage), die Thermogravimetrie und die Coulometrie. Von den relativen Methoden wurden die Thermokonduktometrie, der Flammenionisationsdetektor (nach Umsetzung von CO₂ zu Methan) und das IR-Absorptionsmeßverfahren geprüft. Die Anwendbarkeit der Methoden wurde mit Hilfe statistischer Prüfverfahren beurteilt, wobei die Präzision (SnedecorsF-Test und BartlettsU ²-Test) und die Genauigkeit (Studentst-Test) der erhaltenen Analysenwerte verglichen wurden.

     

The potential of inductively coupled plasma-mass spectrometric detection for capillary electrophoretic analysis of pesticides

In this work, the potential of inductively coupled plasma-mass spectrometry (ICP-MS) coupled to capillary electrophoresis (CE) to determine organophosphorus pesticides (OPPs) is demonstrated. Element specific detection of (31)P with ICP-MS is performed for the detection of OPPs. Three common OPPs, including glyphosate, glufosinate, and aminomethylphosphonic acid (AMPA), were analyzed by CE-ICP-MS to demonstrate its applicability for the analysis of OPPs. The advantages of using ICP-MS with respect to other common detectors, such as flame photometric detection (FPD), for CE analysis of OPPs are shown. Additionally, different CE separation conditions were studied to achieve complete baseline separation of the pesticide compounds in short migration times. Two CE buffer systems were evaluated for the separation of OPPs using ICP-MS detection. A buffer solution containing 40 mmol.L(-1) ammonium acetate at pH 9.0 and an applied voltage of +20 kV were finally selected leading to a separation time of 10.0 min. Both migration time and area relative standard deviations (%RSD) were evaluated and their respective values were in the intervals of 1.1-3.3% and 2.7-5.3%. Detection limits obtained with the CE-ICP-MS system were in the range of 0.11-0.19 mg.L(-1) (as compound) yielding an enhancement of 130- to 230-fold with respect to FPD. The proposed methodology was finally applied for the determination of the OPPs mentioned above in natural river water samples.     

Low-valent cobalt complexes with three different pi acceptor ligands: experimental and DFT studies of the reduced and the low-lying excited states of (R-DAB)Co(NO)(CO), R-DAB = substituted 1,4-diaza-1,4-butadiene

The complexes (RN=CH-CH=NR)Co(NO)(CO) with R = isopropyl, 2,6-diisopropylphenyl, or p-tolyl are chemically and electrochemically reducible to radical anions at potentials which strongly depend on R. The DFT calculated structure for the neutral compound with R = iPr agrees with the experiment, and the computed structure of the anion radical reveals changes according to a reduction of the R-DAB ligand. EPR results confirm an (R-DAB)-based singly occupied molecular orbital in [(RNCHCHNR)Co(NO)(CO)](.-), with minor but detectable contributions from NO as supported by IR spectroelectrochemistry and as quantified by DFT spin density calculations. The calculations indicate increasingly stabilized CO, NO, and RNCHCHNR pi* acceptor orbitals, in that order. On the basis of TD-DFT (time-dependent density functional theory) calculations, the lowest-lying excited states are assigned to metal-to-(R-DAB) charge transfer transitions while bands due to the metal-to-nitrosyl charge transfer occur at higher energies but still in the visible region. Resonance Raman studies were used to probe these assignments.     

A molecular mechanics study of the effect of substitution in position 1 on the conformational space of the oxytocin/vasopressin ring

Summary The effect of the substitution in position 1 on the low-energy conformations of the oxytocin/vasopressin 20-membered ring was investigated by means of molecular mechanics. Three representative substitutions were considered: -mercapto-,-dimethyl)propionic acid (Dmp), (-mercapto-,-cyclopentamethylene)propionic acid (Cpp), both forming strong antagonists, and (,-dimethyl--mercapto)propionic acid (-Dmp), forming analogs of strongly reduced biological activity, with the -mercaptopropionic (Mpa) residue taken as reference. Both ECEPP/2 (rigid valence geometry) and AMBER (flexible valence geometry) force fields were employed in the calculations. Three basic types of backbone conformations were taken into account which are distinguished by the type of -turn at residues 3 and 4: 1/III, II, and I/III, all types containing one or two intra-annular hydrogen bonds. The allowed (ring-closed) disulfide-bridge conformations were searched by an algorithm formulated in terms of scanning the disulfide-bridge torsional angle C-S-S-C. The ECEPP/2 and AMBER energies of the obtained conformations were found to be in reasonable agreement. Two of the low-energy conformers of the [Mpa¹]-compound agreed very well with the cyclic part of the two conformers found in the crystal structure of [Mpa¹]-oxytocin. An analysis of the effect of -substitution on relative energies showed that the conformations with the N-C-CH₂-CH₂ (₁) and C-CH₂-CH₂-S (₁) angles of the first residue around (–100°, 60°) and (100°, –60°) are not affected; this in most cases implies a left-handed disulfide bridge. In the case of -substitution the allowed values of ₁ are close to ± 60°. This requirement, being in contradiction to the one concerning -substitution, could explain the very low biological activity of the -substituted analogs. The conformational preferences of substituted compounds can largely be explained by the analysis of local interactions within the first residue. Based on the selection of the conformations which are low in energy for both the reference and -substituted compounds, two distinct types of possible binding conformations were proposed, the first one being similar to the crystal conformer with a left-handed disulfide bridge, the second one having a right-handed bridge, but a geometry different from that of the crystal conformer with the right-handed bridge. The first type of disulfide-bridge arrangement is equally favorable for both I/III and II types of backbone structure, while the second one is allowed only for the II type of backbone. No conformation of the I/III type has a low enough energy to be considered as a possible binding conformation for all of the active compounds studied in this work.     

Ring-chain-transformations : Synthesis of ω-functionalized alkylthio-1,2,4-triazoles by reaction of cyclic S-analogous N-cyano or N-aroylcarbonimidoesters with hydrazines

Cyclic N-cyanocarbonimidodithioesters 4 or N-aroylcarbonimidothioic acid esters 10 react regioselectively with arylhydrazines and methylhydrazine by a ring chain transformation reaction forming ω-functionalized 3-alkylthio-1,2,4-triazoles 8 and 11 or 5-alkylthio-1,2,4-triazoles 9 .     

Working conditions of a Clark-type sensor with a polyethylene membrane in the presence of vapours of chlorine derivatives of methane

The indications of a Clark-type electrochemical sensor with a polyethylene foil used as a membrane are noticeably changed if vapours of chlorine derivatives of methane (CCl₄, CHCl₃, CH₂Cl₂) are present in the atmosphere examined and the sensor has been calibrated in an atmosphere from which those vapours were absent. The sensitivity of the sensor increases and tends to deviate from linearity. The increase is more profound, when the number of chlorine atoms within a molecule of the vapour increases, the partial pressure of the vapour increases and the temperature of the atmosphere examined decreases. If the vapours affect the membrane for a long time, the response time decreases. If the membrane is freshly subjected to the influence of the vapours, a longer period of time is needed to reach a stable indication corresponding to the partial pressure of oxygen actually observed.