Liquid-liquid equilibria for mixtures of (ethylene carbonate + aromatic hydrocarbon + cyclohexane)

Liquid-liquid equilibrium data for mixtures of (ethylene carbonate + benzene + cyclohexane) at temperatures 303.15 and 313.15 K and (ethylene carbonate + BTX + cyclohexane) at temperature 313.15 K are reported, where the BTX is benzene, toluene and m-xylene. The compositions of liquid phases at equilibrium were determined by gas liquid chromatography. The selectivity factors and partition coefficients of ethylene carbonate for the extraction of benzene, toluene and m-xylene from (ethylene carbonate + BTX + cyclohexane) are calculated and presented. The obtained results are compared with the selectivity factors and partition coefficients of ethylene carbonate for the extraction of benzene from (ethylene carbonate + benzene + cyclohexane). The liquid-liquid equilibrium data were correlated with the UNIQUAC and NRTL activity coefficient models. The phase diagrams for the studied mixtures are presented and the correlated tie line results have been compared with the experimental data. The comparisons indicate the applicability of the UNIQUAC and NRTL activity coefficients model for liquid-liquid equilibrium calculations of the studied mixtures. The tie line data of the studied mixtures also were correlated using the Hand method.     

Synthesis, Characterization, and Biological Activity of n-Tributyltin Derivatives of Pharmaceutically Active Carboxylates

Summary.  Tributyltin(IV) derivatives of six different pharmaceutically active carboxylates were synthesized. The complexes were characterized by different analytical techniques (elemental analysis; infrared, NMR, and mass spectroscopy). ¹¹⁹Sn NMR data were also recorded in six different coordinating and non-coordinating solvents. The antibacterial activities of the compounds were tested using ten different bacteria relative to the reference drugs ampicillin and cephalexin. Received September 20, 2001. Accepted (revised) December 6, 2001     

Low molecular weight organogels based on long-chain carbamates

Thermoreversible organogels were prepared from carbamates with alkyl side chains of different lengths. Gelation was possible only up to an alkyl side chain length of 12 carbons, beyond which crystallization occurs, due to the dominant van der Waals interaction between the alkyl chains. This is in contrast to other alkane-based organogels, in which gelating efficiency increased with the length of the alkane chain (see Abdallah, D. J.; Weiss, R. G. Adv. Mater. 2000, 12, 1237). The critical concentration for gelation decreases drastically with an increase in the side chain length. Xerogels of these show birefringent fibers with uniform cross section and unlimited growth in one direction. The extent of this unlimited growth is affected by the length of the alkyl side chain in the carbamate, which finally ceases the gel formation ability of the carbamate. Cryogenic scanning electron microscopy images of the gels are similar to those of xerogels. From X-ray diffraction of the fibers, we propose that the growth direction is along the plane of hydrogen bonds between the carbamate molecules. The thickness of the fibers depends on the length of the alkyl side chain. Morphological differences are seen between gels prepared by slow cooling and quenching of the solution. Thus, the morphology of the fibrous xerogels of the carbamates can be tailored for specific applications, by the choice of the alkyl side chain length and the rate of cooling the solution.     

Joule-Thomson inversion curve prediction by using equation of state

In this paper five equations of state are tested for checking their ability to predict the Joule-Thomson inversion curve.These five equations of state are:Mohsennia-Modarres-Mansoori(MMM),Ji-Lemp(JL),modified Soave-Redlich-Kwang(SRK)equation of state by Graboski(MSRK1),modified SRK equation of state by Peneloux and Rauzy(MSRK2),and modified Peng-Robinson (PR)equation of state by Rauzy(PRmr).The investigated equations of state give good prediction of the low-temperature branch of the inversion curve,except for MMM equation of state.The high-temperature branch and the peak of the inversion curve have been observed,in general,to be sensitive to the applied equation of state.The values of the maximum inversion temperature and maximum inversion pressure are calculated for each component used in this work.     

Potentiodynamic and cyclic voltammetric behaviour of a lead electrode in NaOH solution

Summary The electrochemical behaviour of lead in NaOH solution was studied by potentiodynamic and cyclic voltammetric techniques in combination with X-ray diffraction analysis. The active dissolution of lead involves a small shoulderA1 followed by a peakA1 prior to a passive region. The shoulderA1 is assigned to the electroformation of a Pb(OH)₂ film, whereas peakA1 is due to the formation of PbO. Beyond the passive region, the current density increases again, forming a small shoulderA2 and a peakA2 prior to the oxygen evolution potential. The shoulderA2 and the peakA2 are correlated to the electrooxidation of PbO to Pb₃O₄ and PbO₂, respectively. The intensity of the anodic peaks increases with increasing alkali concentration, temperature and scan rate. In cyclic voltammetry, the reverse scan shows two cathodic peaksC1 andC2 which are correlated to the electroreduction of PbO and PbO₂ respectively, to Pb.

---

Potentiodynamisches und cyclovoltammetrisches Verhalten einer Bleielektrode in NaOH-Lösung

Zusammenfassung Das elektrochemische Verhalten von Blei in NaOH wurde mittels potentiodynamischer und cyclovoltammetrischer Techniken unter Zuhilfenahme der Röntgenbeugungsanalyse untersucht. Die aktive Auflösung von Blei verläuft über eine SchulterA1, die von einem einer passiven Region vorgelagerten PeakA1 gefolgt wird. Die SchulterA1 wird der elektrochemischen Bildung eines Pb(OH)₂-Films, der PeakA1 der Bildung von PbO zugeschrieben. Jenseits der passiven Region steigt die Stromdichte wieder an, und vor Erreichen des Sauerstoffpotentials treten eine kleine SchulterA2 und ein PeakA2 auf, die mit der Elektrooxidation von PbO zu Pb₃O₄ und PbO₂ korrelieren. Analog dazu beobachtet man in der cyclischen Voltammetrie zwei kathodische PeaksC1 undC2, die der Elektroreduktion von PbO und PbO₂ zu Pb entsprechen. Die Intensität der anodischen Peaks steigt mit steigender Alkalikonzentration, Temperatur und Scangeschwindigkeit.

     

Use of a Water-in-Oil Microemulsion as Mobile Phase in Complexation TLC of Amino Acids on Silica Layers Impregnated with Metal Cations

JPC – Journal of Planar Chromatography – Modern TLC - A water-in-oil microemulsion has been used for the first time as a mobile phase in thin-layer chromatography of amino acids. A new...     

Immobilized enzyme electrode for the determination of salicylate in blood serum

This determination of salicylate in blood serum is based on application of an immobilized enzyme electrode. Salicylate hydroxylase (E.C.1.14.13.1) is chemically immobilized onto a pig intestine mounted on an oxygen electrode. The signals are monitored amperometrically and the resulting output voltage is read using a simple adapter. The experimental parameters and possible interferences are discussed. Samples containing 1.0 × 10^?5?1.87 × 10^?3 M (1.6–300 μg ml^?1) salicylate were assayed with relative standard deviations between 1.3% and 6% and recoveries between 98.7 and 103%. Results obtained by the proposed method and by the established clinical method for randomly spiked pooled serum samples correlated well (r = 0.99).     

Selected valence electron split-shell molecular orbital calculations on the diatomic interhalogen molecules

Selected valence electron split-shell molecular orbital calculations have been performed on the diatomic interhalogen molecules in order to obtain their binding energies, equilibrium internuclear distances, vibrational force constants, dipole moments and nuclear quadrupole coupling constants. The results are compared with the corresponding closedshell values and with those of some previous semiempirical and nonempirical all valence electron calculations. It is observed that the selected valence electron split-shell molecular orbital method which involves the least amount of computations yields results in better agreement with experiment than other methods.