Preconcentration and separation of copper(II), cadmium(II) and chromium(III) in a syringe filled with 3-aminopropyltriethoxysilane supported on silica gel

In this study, a syringe was filled with silica gel loaded with 3-aminopropyltriethoxysilane, for the separation and preconcentration of copper, cadmium and chromium prior to their determination by graphite furnace atomic absorption spectrometry (GFAAS) in seawater. For this purpose, a syringe was filled with 0.5 g of modified silica gel and the sample solution was drawn into the syringe and ejected back again. The analyte elements were quantitatively retained at pH 5. Then, the elements sorbed by the silica gel were eluted with 2.0 M of HCl and determined by GFAAS. At optimum conditions, the recovery of Cu, Cd and Cr were 96-98%. Detection limits (3delta) were 6.6, 7.5 and 6.0 micro g L(-1) for Cu, Cd and Cr, respectively. The elements could be concentrated by drawing and discharging several portions of sample successively but eluting only once. Cu, Cd and Cr added to a seawater sample were quantitatively recovered (>95%) in the range of the 95% confidence level. The method proposed in this paper was compared with a column technique. Optimum experimental conditions, reproducibility, precision and recoveries of both techniques are the same, but the syringe technique is much faster, easier and more practical than the column technique. It is a portable system and allows one to make the sorption process in the source of sample. In addition, the risk of contamination is less than in the column technique.     

Borate adsorption at Pt(111) in acidic medium

The adsorption/desorption process of borate was studied at Pt(111) in acidic solution by cyclic voltammetry. A so-called butterfly wave in the cyclic voltammogram of Pt(111) in HClO₄ shifted to negative direction upon the addition of boric acid with the disappearance of its sharp spikes. The shift in potential was found to be −57 mV with a tenfold increase of boric acid concentration. This illustrates that this anomalous wave is due to borate adsorption/desorption by a one-electron transfer process. The borate adsorption/desorption wave was observed to shift by −63 mV/pH. At pH>3, the anomalous wave splits forming two separate waves, depending on the pH and the scan rate. The appearance of two waves is assigned to the change in the adsorption mode of borate or the participation of OH in the adsorption process.     

Coordination of solvent molecules to VO(acac)<Subscript>2</Subscript> complexes in solution studied by hyperfine sublevel correlation spectroscopy and pulsed electron nuclear double resonance

Interactions and binding sites of the solvent molecules chloroform and ethanol to bis(acetylacetonate)oxovanadium(IV) (VO(acac)₂) complexes in (frozen) solutions have been investigated by pulsed electron nuclear double resonance, sum peak electron spin echo envelope modulation and hyperfine sublevel correlation spectroscopy. The experimental proton hyperfine coupling data of coordinating solvent molecules have been interpreted using quantum chemical calculations (density functional theory). Experimental and computed hyperfine couplings indicate that ethanol coordinates to vanadium in the equatorial plane of VO(acac)₂ and chloroform interacts via hydrogen bonding to oxygens of the acac ligands.     

Synthesis and Characterization of Novel Monoazo N‐Ester‐1,8‐Naphthalimide Disperse Dyestuffs

Five novel monoazo disperse dyestuffs based on N‐ester‐1,8‐naphthalimide were synthesized. Acenaphthene was nitrated, then oxidized to 4‐nitro‐1,8‐naphthalic anhydride. 4‐Nitro‐1,8‐naphthalic anhydride was reacted with methyl and ethyl glycinate in alcoholic media, followed with reduction. 4‐Amino‐N‐methyl and ethyl glycinate‐1,8‐naphthalimide were obtained. These products were diazotized and coupled with appropriate aromatic amines to give bluish‐red or violet dyestuffs. All intermediates and dyestuffs were purified and characterized by ¹H‐NMR, FTIR, DSC, UV‐VIS and Elemental Analysis. Dispersion of dyestuffs was prepared in water and applied to polyester fabrics. The dyed fabrics showed that four of the synthesized dyestuffs were suitable for coloring polyester fibers, producing deep bluish red with very good build up properties.     

HPLC and GC Methods for Determination of Lubricants and Their Evaluation in Analysis of Real Samples of Polyethylene

High performance liquid chromatography (HPLC) and gas chromatography (GC) are introduced for analysis of polymer lubricants (stearamide, oleamide and erucamide). In the HPLC method, a reverse phase octadecylsilane (ODS) column along with acetonitrile/methanol (60:40) as a mobile phase were used. Detection of analytes was performed by a UV detector at 202 nm. The analysis time was less than 8 min. In the GC method, polar capillary column and flame ionization detector (FID) were used for separations and detection, respectively. The analysis time by GC was longer than HPLC and was about 30 min. Limits of detection, linear range and repeatability of both methods are similar, but determination of oleamide in real samples by HPLC method is difficult due to complexity of the initial part of HPLC chromatogram in polyethylene samples. That problem is not observed in the GC method. Detection limits in both methods for all analytes are lower than 0.003% which are much lower than the amount of lubricants in commercial polymers (0.05–0.2%).     

Normal subgroup based power graph of finite groups

Ricerche di Matematica - Let G be a finite group and $$N \unlhd G$$ . The normal subgroup based power graph of G, $$\Gamma _N(G)$$ , is an undirected graph with vertex set $$(G{\setminus }N) \cup...     

Vieta–Fibonacci wavelets: Application in solving fractional pantograph equations

In this paper, the Vieta–Fibonacci wavelets as a new family of orthonormal wavelets are generated. An operational matrix concerning fractional integration of these wavelets is extracted. A numerical scheme is established based on these wavelets and their fractional integral matrix together with the collocation technique to solve fractional pantograph equations. The presented method reduces solving the problem under study into solving a system of algebraic equations. Several examples are provided to show the accuracy of the method.     

Orientation control of perovskite thin films on glass substrates by the application of a seed layer prepared from oxide nanosheets

Orientation control of perovskite compounds was investigated by the application of a seed layer prepared from oxide nanosheets. An aqueous suspension of oxide nanosheets was prepared by the exfoliation of a layered compound of KCa₂Nb₃O₁₀ oxide grains. A seed layer composed of (TBA)Ca₂Nb₃O₁₀ nanosheets (TBA = tetrabutylammonium) was formed on a glass substrate by simply dip coating it in the suspension. Two kinds of perovskite compounds, LaNiO₃ (LNO) and Pb(Zr,Ti)O₃ (PZT) with a preferred orientation of (00l) were successfully grown on this seeded glass substrate. In this study, the relation between lattice mismatch and electrical properties is investigated. A large, oriented PZT film with a size of 5 ×4 cm shows an improved P-E hysteresis behavior by use of this orientation control.     

New Developments on Operator Reverse AM-GM Inequality for Positive Linear Maps

Acta Mathematica Sinica, English Series - In this research article, we shall give some reverse Arithmetic-Geometric mean inequalities for unital positive linear maps on Hilbert space operators...     

Reactions of [(Cp)2Ti(NCS)2] as a potential metalloligand; synthesis and physico-chemical investigations of novel heterobimetallic complexes

Summary Bis(cyclopentadienyl)titanium(IV) diisothiocyanate [(Cp)₂-Ti(NCS)₂] reacts with MCl₂ (M = Cu, Pd or Pt), [CuCl(PPh₃)₃], [RuCl₂(PPh₃)₃] and [RuCl₂(DMSO)₄] (DMSO = dimethylsulphoxide) giving solid compounds of stochiometry [(Cp)₂Ti(-NCS)₂MCl₂] (M = Cu, Pd or Pt), [(Cp)₂Ti(-NCS)₂CuCl(PPh₃)], [(Cp)₂Ti(-NCS)₂-RuCl(PPh₃)₂]Cl and [(Cp)₂Ti(-NCS)₂RuCl₂(DMSO)2]. These products have been characterized by physicochemical and spectroscopic methods.