Novel silylphenol antioxidants by density functional theory

We have scrutinized five novel silylphenol antioxidants, including 2-silylphenol ( 1 ), 4-silylphenol ( 2 ), 2,6-disilylphenol ( 3 ), 2,4-disilylphenol ( 4 ), and 2,4,6-trisilylphenol ( 5 ), at M06/6–311++G** level of theory. To evaluate the antioxidant efficiency, the electronic effects on O─H bond dissociation energy (BDE) and vertical ionization potential (IP_v) of 1 – 5 are investigated, which are mainly governed by electronic effects. The conductor-like polarized continuum model (CPCM) is applied to measure the antioxidant capacity in the solution phase. The results show that antioxidants with the lowest BDE and IP_v values can efficiently act via hydrogen atom transfer (HAT) and single electron transfer (SET) mechanisms, respectively. The stability of resulting radicals is measured by nucleus independent chemical shift (NICS) index, natural bond orbital (NBO) analysis, and nucleophilicity (N) index. The BDE shows lower values in the gas phase with respect to water, while water exhibits lower IP_v values than gas. Structure 5 turns out as the most efficient antioxidant. The overall order of antioxidant efficiency in both gas and water phases is 5 > 2 > 3 > 4 > 1 .     

Hopping rates and concentrations of mobile fluoride ions in Pb(1-x)Sn(x)F(2) solid solutions

In the present paper, the ion dynamics and relaxation of fluoride ions in Pb(1-x)Sn(x)F(2) (with x=0.2-0.6) solid solutions, prepared by mechanochemical milling, are studied in the conductivity formalism over wide ranges of frequencies and temperatures. The conductivity spectra of the investigated materials are analyzed by the Almond-West (AW) power-law model. The estimated values of the hopping rates and the dc conductivity of different compositions are thermally activated with almost the same activation energy. The calculated values of the concentration of mobile ions, n(c), are almost independent of temperature and composition for x=0.2-0.4. The maximum value of n(c) is obtained for the x=0.6 sample, although it does not show the maximum conductivity. Therefore, the composition dependence of the ionic conductivity of these solid solutions could be explained based on the extracted parameters. The results presented in the current work indicate that the AW model represents a reasonable approximation of the overall frequency-dependent conductivity behavior of the investigated materials. The conductivity spectra at different temperatures for each composition are successfully scaled to a single master curve, indicating a temperature-independent relaxation mechanism. For different compositions, however, the conductivity spectra cannot be scaled properly, indicating composition-dependent relaxation dynamics.     

Comparative Study of Chromium Biosorption by Mesorhizobium amorphae Strain CCNWGS0123 in Single and Binary Mixtures

The appearance of chromium in the aqueous effluent is a major concern for the modern industry. In this work, Mesorhizobium amorphae strain CCNWGS0123 was investigated as a biosorbent to remove chromium from aqueous solutions. The optimum pH for Cr(III) and Cr(VI) biosorption were 4 and 2, respectively. This isolate showed an experimental maximum Cr(III) adsorption capacity of 53.52 mg?L^?1, while the result was 47.67 mg?L^?1 for Cr(VI), with an initial 100 mg?L^?1 Cr ions and 1.0 g?L^?1 biomass. In terms of time equilibrium, Cr(III) ion was more readily adsorbed than Cr(VI) by this isolate. The biosorption data of both ions fit the Langmuir isotherm better than that of Freundlich model. Meanwhile, this organism exhibited a good capability to release Cr ions, with desorption efficiency of 70 % for Cr(III) and 76 % for Cr(VI). Fourier transform infrared spectroscopy analysis showed that –OH, –COO, –NH, amide I, and C=O were involved in Cr(III) and Cr(VI) binding. The biosorbent was further characterized by scanning electron microscopy and energy-dispersive X-ray spectrometry, which indicated an accumulation of chromium on the cellular level. In the binary mixtures, the removal ratio of total Cr and Cr(III) increased from pH?2 to 4. The highest removal ratio of the total Cr was observed in the 25/25 mg?L^?1 mixture at pH?4. In addition, the removal efficiency of Cr(VI) was closely influenced by Cr(III) in the mixture, decreasing to 23.57 mg?g^?1 in the 100/100 mg?L^?1 mixture system, due to the competition of Cr(III). The potential usage of the chromium-resistant rhizobium for the remediation of chromium-contaminated effluents has been demonstrated based on the above results.     

Preparation and characterization of new sol–gel titanium(IV) butoxide–cyanopropyltriethoxysilane hybrid sorbent for extraction of polar aromatic amines

A new titanium(IV) butoxide-cyanopropyltriethoxysilane (Ti-CNPrTEOS) hybrid material was successfully synthesized for the use as sorbent for the extraction of polar aromatic amines. The sorbent was synthesized by hydrolysis and condensation of titanium(IV) butoxide and cyanopropyltriethoxysilane with the presence of hydrochloric acid as catalyst via sol–gel method. Several factors influencing the synthesized sorbent such as solvent selection, mol of water content, ratio of titanium(IV) butoxide and cyanopropyltriethoxysilane and aging temperature were investigated and optimized. The sorbents were characterized by fourier transform-infrared, field-emission scanning electron microscopy-energy, CHN elemental analysis and thermogravimetric analysis. The applicability of the sorbents for the extraction of polar aromatic amines by the batch sorption method was extensively studied and evaluated. Under the optimum synthesis conditions (tetrahydrofuran as solvent, 1.2 M of hydrochloric acid catalyst, 4 mol of water content with ratio of titanium(IV) butoxide and cyanopropylteriethoxysilane of 1:1 and aging temperature of 60 °C), the extraction showed high recovery towards the extraction of polar aromatic amines. The synthesized sorbent was successfully applied for the extraction of selected aromatic amines via batch sorption method in waste water samples prior to the gas chromatography-flame ionization detector separation. The synthesized sol–gel Ti-CNPrTEOS sorbent demonstrated the potential as an alternative extraction sorbent with higher selectivity towards polar aromatic amines.     

Reactivity of base catalysed hydrolysis of 2-pyridinylmethylene-8-quinolinyl-Schiff base iron(II) iodide complexes: solvent effects

Three ligands of 2-pyridinylmethylene-8-quinolinyl (L1), methyl-2-pyridinylmethylene-8-quinolinyl (L2), and phenyl-2-pyridinylmethylene-8-quinolinyl (L3), Schiff bases were synthesised by direct condensation of 8-aminoquinoline with 2-pyridinecarboxaldehyde, 2-acetylpyridine, or 2-benzoylpyridine. They coordinated to Fe(II) ion in a 1: 2 mole ratio followed by treatment with iodide ions affording complexes with a general formula [Fe(L)₂]I₂·2H₂O, (L = L1, L2, or L3). Spectrophotometric evaluation of the kinetics of base catalysed hydrolysis of these complex cations was carried out with an aqueous solution of NaOH in different ratios of water/methanol binary mixtures. Kinetics of the hydrolysis followed the rate law (k ₂[OH^?] + k ₃[OH^?]²)[complex]. Reactivity trends and their rate constants were compared and discussed in terms of ligand structure and solvation parameters. The methanol ratio affects the hydrolysis as a co-solvent which was analysed into initial and transition state components. The increase in the rate constant of the base hydrolysis of Fe(II) complexes, as the ratio of methanol increases, is predominantly caused by the strong effect of the organic co-solvent on the transition states.     

配合物(BenzMeIm)2[PtCl4]的合成与表征

通过离子液体氯化1-苄基-3-甲基咪唑（BenzMeIm-Cl）与PtCl₂的反应,合成了配合物（BenzMeIm）₂[PtCl₄],并用元素分析、红外光谱、紫外-可见光谱、¹H NMR、¹³C NMR和单晶X射线衍射对其进行了表征。单晶X射线分析表明,配合物结构属于P2₁/c空间群,晶胞参数和结构解析参数为：a=0.981 80（5）nm,b=0.861 47（3）nm,c=0.144 332（7）nm,β=92.480（2）°,V=121.96（1）nm³,R₁=0.014 4,wR₂=0.038 8。     

Solvent‐Free Williamson Synthesis: An Efficient,Simple, and Convenient Method for Chemoselective Etherification of Phenols and Bisphenols

Etherification of phenols with dimethyl‐ and diethylsulfates and benzyl chloride was performed efficiently in the presence of a suitable solid base, NaHCO₃ or K₂CO₃, under solvent‐free conditions. The reaction proceeded rapidly at low temperature, and the corresponding ethers were obtained with high purity and excellent yield. Selective etherification of electron‐poor phenols in the presence of electron‐rich ones and also selective mono‐etherification of bisphenols are the noteworthy advantages of this method. This method is environmentally friendly.