M_2S_3-SO_4~(2-)型催化剂合成高级脂肪酸酯

１引言脂和国民经济关系密切,既是人类食物的重要组成部份和重要的营养物质,又是工业用途广泛的原料。工业上由乙醇与脂肪酸经硫酸液相催化合成酯［‘”’］,但此法副反应多,设备腐蚀严重,后处理工序繁琐,三废处理困难。采用超强酸催化高级脂肪酸酯的合成,可以避免上述缺点。而且这类催化剂可在高温下使用,相对于液体强酸型催化剂ｌ‘１,它们以其不同寻常的酸强度使许多难以进行的反应在很温和的条件下进行,并且具有能耗低、无腐蚀、无污染、工艺简便、用量少、易再生等,因而得到越来越广泛的应用。２实验部分２．１试剂及纯废月…     

PW/SBA-15负载型催化剂的性能研究

合成、表征了一系列SBA-15负载H₃PW₁₂O₄₀(PW)催化剂.负载量高达60%以上时,XRD仍未检测到催化剂上有PW晶相峰.负载后PW保持其Keggin结构,但与载体之间存在较强的相互作用.通过改变PW负载量可调变催化剂的酸性,制得适用于中强酸和弱酸性催化反应的介孔固体酸催化剂.     

An All‐Alkynyl Protected 74‐Nuclei Silver(I)–Copper(I)‐Oxo Nanocluster: Oxo‐Induced Hierarchical Bimetal Aggregation and Anisotropic Surface Ligand Orientation

The hardness of oxo ions (O^2?) means that coinage‐metal (Cu, Ag, Au) clusters supported by oxo ions (O^2?) are rare. Herein, a novel μ₄‐oxo supported all‐alkynyl‐protected silver(I)–copper(I) nanocluster [Ag_74?xCu_xO₁₂(PhC≡C)₅₀] ( NC‐1 , avg. x=37.9) is characterized. NC‐1 is the highest nuclearity silver–copper heterometallic cluster and contains an unprecedented twelve interstitial μ₄‐oxo ions. The oxo ions originate from the reduction of nitrate ions by NaBH₄. The oxo ions induce the hierarchical aggregation of Cu^I and Ag^I ions in the cluster, forming the unique regioselective distribution of two different metal ions. The anisotropic ligand coverage on the surface is caused by the jigsaw‐puzzle‐like cluster packing incorporating rare intermolecular C?H???metal agostic interactions and solvent molecules. This work not only reveals a new category of high‐nuclearity coinage‐metal clusters but shows the special clustering effect of oxo ions in the assembly of coinage‐metal clusters.     

General π‐Electron‐Assisted Strategy for Ir,Pt, Ru,Pd, Fe,Ni Single‐Atom Electrocatalysts with Bifunctional Active Sites for Highly Efficient Water Splitting

Both the hydrogen evolution reaction (HER) and the oxygen evolution reaction (OER) are crucial to water splitting, but require alternative active sites. Now, a general π‐electron‐assisted strategy to anchor single‐atom sites (M=Ir, Pt, Ru, Pd, Fe, Ni) on a heterogeneous support is reported. The M atoms can simultaneously anchor on two distinct domains of the hybrid support, four‐fold N/C atoms (M@NC), and centers of Co octahedra (M@Co), which are expected to serve as bifunctional electrocatalysts towards the HER and the OER. The Ir catalyst exhibits the best water‐splitting performance, showing a low applied potential of 1.603 V to achieve 10 mA cm^?2 in 1.0 m KOH solution with cycling over 5 h. DFT calculations indicate that the Ir@Co (Ir) sites can accelerate the OER, while the Ir@NC₃ sites are responsible for the enhanced HER, clarifying the unprecedented performance of this bifunctional catalyst towards full water splitting.     

Lithium Bonds in Lithium Batteries

Lithium bonds are analogous to hydrogen bonds and are therefore expected to exhibit similar characteristics and functions. Additionally, the metallic nature and large atomic radius of Li bestow the Li bond with special features. As one of the most important applications of the element, Li batteries afford emerging opportunities for the exploration of Li bond chemistry. Herein, the historical development and concept of the Li bond are reviewed, in addition to the application of Li bonds in Li batteries. In this way, a comprehensive understanding of the Li bond in Li batteries and an outlook on its future developments is presented.     

固相萃取/高效液相色谱-串联质谱法测定水中百草枯与敌草快残留

建立了水中百草枯和敌草快的固相萃取/高效液相色谱-串联质谱测定方法。样品直接经Cleanert PWCX小柱富集净化,HILIC亲水型液相色谱柱分离,5 mmol/L乙酸铵用(用甲酸调至pH 3.7)-乙腈梯度洗脱,采用电喷雾离子源正离子模式采集,选择性反应监测模式下检测,外标法定量。结果表明,百草枯和敌草快分别在10.0~200.0μg/L和1.0~200.0μg/L质量浓度范围内呈良好的线性关系,相关系数(r2)均不小于0.997,在30~200μg/L的加标水平下,百草枯和敌草快的平均回收率分别为96.8%~125.8%和97.2%~118.2%,批内相对标准偏差(RSD)分别为3.0%~6.3%和2.9%~6.0%;批间RSD分别为3.3%~8.2%和2.7%~7.9%。以3倍信噪比计算,百草枯和敌草快的方法检出限分别为5.0μg/L和0.3μg/L;以10倍信噪比计算,方法的定量下限分别为10.0μg/L和1.0μg/L。该方法简便、快速、灵敏,方法的线性范围、回收率、精密度和检出限均符合残留分析的要求,能满足水中百草枯、敌草快残留监控的要求。     

爆炸荷载作用下钢筋混凝土梁的动力响应及破坏形态分析

对基于Timoshenko梁理论建立的非线性动力有限元法作了改进。根据压区理论得到混凝土的平均剪应力和平均剪应变关系,建立了能反映箍筋的抗剪作用的材料模型;此外,对结构在爆炸荷载作用下可能出现的各种响应现象进行了描述,以准确地预测梁破坏时不同位置截面上钢筋和混凝土的受力、变形及破坏情况。应用改进的材料模型,对爆炸荷载作用下的五个钢筋混凝土试验梁的动力响应和破坏形态进行了数值模拟,结果表明,该数值方法能较好地模拟钢筋混凝土梁的弯曲、弯剪和剪切等破坏形态。     

三类有向三元系之间关系的一种猜想

一个Mendelsohn (Directed, 或Hybrid)三元系 MTS$(v, \lambda)$~(DTS$(v, \lambda)$,或HTS$(v,\lambda))$, 是由$v$元集$X$ 上的一些循环（可迁,或循环和可迁）三元组(简称区组)构成的集合${\cal B}$, 使得$X$上每个由不同元素组成的有序对都恰在 ${\cal B}$的$\lambda$个区组中出现.本文主要讨论了这三类有向三元系之间的一种关联关系,给出猜想：任意MTS$(v,\lambda)$的区组关联图$G(\     

α-可分解4-圈系统

An m-cycle system of order ν and index λ, denoted by rn-CS(ν, λ), is a collection of cycles of length m whose edges partition the edges of λκ_v. An m-CS(ν, λ) is α-resolvable if its cycles can be partitioned into classes such that each point of the design occurs in precisely α cycles in each class. The necessary conditions for the existence of such a design are m|λν(ν-1)/2,2|λ(ν-1), m|αν,α|λ(ν-1)/2 It is shown in this paper that these conditions are also sufficient when m = 4.     

Destabilization of artificial biomembrane induced by the penetration of tryptophan

The effect of tryptophan on the membrane stability was studied by using three artificial biological membranes including liposome, Langmuir monolayer and solid supported bilayer lipid membrane (s-BLM) as models. All the results indicate that the penetration of tryptophan can destabilize different artificial biological membranes. The diameter of liposome and the leakage of calcein from liposome increased with the increase of tryptophan concentration because the penetration of tryptophan was beneficial for dehydrating the polar head groups of lipids and the formation of fusion intermediates. π-A isotherms of lecithin on the subphase of tryptophan solution further confirm that tryptophan can penetrate into lipid monolayer and reduce the stability of lipid monolayer. When the concentration of tryptophan increased from 0 to 2 × 10⁻³ mol L⁻¹, the limiting molecular area of lecithin increased from 110.5 to 138.5 Å², but the collapse pressure of the monolayer decreased from 47.6 to 42.3 mN m⁻¹, indicating the destabilization of lipid monolayer caused by the penetration of tryptophan. The resistance spectra of s-BLM demonstrate that the existence of tryptophan leads to the formation of some defects in s-BLM and the destabilization of s-BLM. The values of electron-transfer resistance and double layer capacitance respectively decreased from 5.765 × 10⁶ Ω and 3.573 × 10⁻⁸ F to 1.391 × 10⁶ Ω and 3.340 × 10⁻⁸ F when the concentration of tryptophan increased from 0 to 2 × 10⁻³ mol L⁻¹. Correspondingly, the breakdown voltage of s-BLM decreased from 2.51 to 1.72 V.