Interparticle interactions in agglomerates of alpha-Fe2O3 nanoparticles: influence of grinding

We have chemically prepared a sample of antiferromagnetic alpha-Fe2O3 nanoparticles by a gel-sol technique. M?ssbauer spectra of the as-prepared sample showed that superparamagnetic relaxation was suppressed due to strong magnetic interparticle interactions even at room temperature. However, subsequent grinding of the sample by hand in a mortar for some minutes resulted in fast superparamagnetic relaxation of some of the particles. The effect was even more dramatic if the alpha-Fe2O3 powder was ground for a longer time or together with nonmagnetic eta-Al2O3 nanoparticles. Similar effects were found after low-energy ball milling. Thus it is found that the agglomeration of the nanoparticles during preparation under wet conditions results in strong magnetic interparticle interaction, but a relatively gentle mechanical treatment is sufficient to break up the agglomerates, resulting in much weaker interactions. We show that these effects can also be seen when a soil sample containing magnetic nanoparticles is ground.     

1－芳氧乙酰氧基－1－（1H－1，2，4－三唑－1－基）－3，3－二甲基－2－丁酮衍生物的研究

以三乙胺为缚酸剂，用芳氧乙酸同ω－溴代－ω－（１Ｈ－１，２，４－三唑－１－基）频哪酮反应，合成了一系列三唑类新化合物，探讨了化合物的合成方法。通过ＩＲ￣１ＨＮＭＲ、ＭＳ分析及元素分析确定了化合物的结构，生物活性测定结果表明，部分化合物具有良好的除草活性，同时表现出一定程度的植物生长调节活性及杀菌活性．     

多壁碳纳米管负载铂的甲苯加氢脱芳催化剂

以多壁碳纳米管(CNTs)为载体制备了负载型Pt催化剂Pt/CNTs并将其用于催化甲苯加氢脱芳(HDA)反应.结果表明,在1.0%Pt/CNTs催化剂上,在0.4MPa,373K,PhCH3/H2摩尔比=6/94和GHSV=120L/(h.g)的反应条件下,甲苯转化率可达100%,比反应速率为0.0523mmol/(s.m2),分别是γ-Al2O3和AC负载各自最佳Pt负载量催化剂1.4%Pt/γ-Al2O3和2.4%Pt/AC上相应值的1.17和1.18倍.甲苯加氢产物全部为甲基环己烷,其他可能的加氢产物均在气相色谱检测限以下.催化剂的表征研究揭示,用CNTs代替γ-Al2O3或AC作为载体并不会引起所负载Pt催化剂上甲苯HDA反应的表观活化能发生明显变化.与γ-Al2O3或AC负载的相应催化剂相比,一方面,CNTs负载的Pt催化剂易于在较低温度下还原活化,并且其工作态催化剂表面催化活性Pt物种(Pt0)所占表面Pt摩尔分率有所提高;另一方面,CNTs负载的Pt催化剂对H2具有较高的吸附/活化和储存能力.这些促进效应对催化剂HDA活性的提高都有重要贡献.     

CdSe/ZnS-labeled carboxymethyl chitosan as a bioprobe for live cell imaging

A simple and convenient method for the construction of CdSe/ZnS-labeled polysaccharides as bioprobes were developed, which are highly biocompatible and photostable, and have been proven to be suitable for live cell imaging.     

水溶性含C_(60)聚电解质的制备及其与重氮树脂自组装膜AFMFFM的初步研究

通过BPO引发的溶液聚合 ,合成了水溶性的星状C6 0 苯乙烯 苯乙烯磺酸钠的三元共聚物 [Star shapedC6 0 poly(St SS) ],运用自组装技术 ,在水溶液中 ,含C6 0 的三元共聚物与重氮树脂 (Diazoresin)通过正负离子间的吸附力在云母基片上交替一层一层有序地组装成固体膜 .自组装膜经紫外光幅照反应 ,通过重氮基的分解 ,层间连接的离子键转变成共价键 ,从而增加薄膜的稳定性和堆砌密度 .用原子力显微镜 摩擦力显微镜(AFM FFM)考察了C6 0 在膜中的承载作用及比较不同链结构、不同链长、不同层数自组装膜的表面形貌和微摩擦性能 .初步的研究结果显示了聚合物薄膜的微摩擦性能与聚合物的化学结构、链长和膜的层数有密切关系     

分数导数结合傅里叶最小二乘拟合处理含噪音的重迭信号

提出了一种含噪音重迭信号的综合处理方法 :先用傅里叶最小二乘法拟合噪音数据 ,然后对拟合后的信号求 2 .5次导数 ,在对模拟数据研究的基础上 ,讨论了求导后峰位漂移及其影响因素 ,给出了一个用于矫正峰位值的经验公式。用该方法对模拟和实际的紫外含噪音重迭信号进行处理 ,结果良好     

锐钛矿型纳米TiO2介孔粉体表面织构的研究

以硫酸钛和尿素为原料,聚乙二醇-1000为空间构造剂,104℃下经尿素水解均匀沉淀法研制颗粒分散均匀、粒径可控的高热稳定性锐钛矿型纳米TiO2介孔粉体,并对其晶相、颗粒大小、比表面积、形貌和孔道结构进行了表征.结果表明,未经任何热处理的TiO2粉体即为锐钛型晶相,颗粒为均匀分散的类球型颗粒,且颗粒间形成直通型的介孔孔道,其孔径在10～30nm之间.控制焙烧温度可以达到控制颗粒大小及形貌的目的,经850℃焙烧5h的样品仍保持锐钛矿型晶相,未出现向金红石型晶相转变的迹象.     

A resonance light scattering method for determination of DNA using Ru(bpy)2PIP(V)2+

A novel method for DNA detection is proposed that is based on the enhancement of resonance light scattering (RLS) of Ru(bpy)₂PIP(V)²⁺ at pH 2.7. Under optimum conditions, good linear relationships were obtained in the wide concentration range of 16–5120 ng mL⁻¹. The linear equation is I _RLS = 13.15 + 171.4 c (μg mL⁻¹), the correlation coefficient (r) is 0.9999. The detection limit of calf thymus DNA is 5.02 ng mL⁻¹. Plasmid DNA extracted from bacillus subtilis was determined by the method with satisfactory results.     

High-throughput purification of combinatorial libraries I: a high-throughput purification system using an accelerated retention window approach

We have developed a high-throughput purification system to purify combinatorial libraries at a 50-100-mg scale with a throughput of 250 samples/instrument/day. We applied an accelerated retention window method to shorten the purification time and targeted one fraction per injection to simplify data tracking, lower QC workload, and simplify the postpurification processing. First, we determined the accurate retention time and peak height for all compounds using an eight-channel parallel LC/UV/MS system, and calculated the specific preparative HPLC conditions for individual compounds. The preparative HPLC conditions include the compound-specific gradient segment for individual compounds with a fixed gradient slope and the compound-specific UV or ELSD threshold for triggering a fraction collection device. A unique solvent composition or solvent strength was programmed for each compound in the preparative HPLC in order to elute all compounds at the same target time. Considering the possible deviation of the predicted retention time, a 1-min window around the target time was set to collect peaks above a threshold based on UV or ELSD detection. Dual column preparative instruments were used to maximize throughput. We have purified more than 500 000 druglike compounds using this system in the past 3 years. We report various components of this high-throughput purification system and some of our purification results.