A new VOF‐based numerical scheme for the simulation of fluid flow with free surface. Part II: application to the cavity filling and sloshing problems

Finite element analysis of fluid flow with moving free surface has been performed in 2‐D and 3‐D. The new VOF‐based numerical algorithm that has been proposed by the present authors (Int. J. Numer. Meth. Fluids, submitted) was applied to several 2‐D and 3‐D free surface flow problems. The proposed free surface tracking scheme is based on two numerical tools; the orientation vector to represent the free surface orientation in each cell and the baby‐cell to determine the fluid volume flux at each cell boundary. The proposed numerical algorithm has been applied to 2‐D and 3‐D cavity filling and sloshing problems in order to demonstrate the versatility and effectiveness of the scheme. The proposed numerical algorithm resolved successfully the free surfaces interacting with each other. The simulated results demonstrated applicability of the proposed numerical algorithm to the practical problems of large free surface motion. It has been also demonstrated that the proposed free surface tracking scheme can be easily implemented in any irregular non‐uniform grid systems and can be extended to 3‐D free surface flow problems without additional efforts. Copyright © 2003 John Wiley & Sons, Ltd.     

Investigation of chemometric calibration performance based on different chemical matrix and signal-to-noise ratio.

The chemometric calibration performance was systematically investigated by two parameters (changing the chemical matrix as well as the signal-to-noise ratio) of the NIR (near-infrared) spectrum. Three different analytes (hexane, cyclohexane, toluene) were selected and heptane was used as a solvent. The degree of spectral difference significantly affected the calibration performance. The largest structural difference between the analyte and the solvent provided the best calibration result for a given signal-to-noise ratio. Additionally, the signal-to-noise ratio of the spectra also directly influenced the calibration performance. Overall, the spectral difference and signal-to-noise ratio were the major factors for governing the chemometric calibration performance, especially in the low-concentration range.     

Low-order modeling and dynamic characterization of rapid thermal processing

A low-order model of rapid thermal processing (RTP) of semiconductor wafers is derived. The first-principles nonlinear model describes the static and dynamic thermal behavior of a wafer with approximate spatial temperature uniformity undergoing rapid heating and cooling in a multilamp RTP chamber. The model is verified experimentally for a range of operating temperatures from 400° C to 900° C and pressures of 1 Torr and 1 atmosphere in an inert N₂ environment. Theoretical predictions suggest model validity over a still wider range of operating conditions. One advantage of the low-order model over previous high-order and statistical models is that the proposed model contains a small number of fundamental parameters and functions that, if necessary, are easily identifiable. Furthermore, because of reduced computational complexity, the low-order model can be used in real-time predictive applications including signal processing and process control design. In studying and verifying the model, the dynamic behavior of a semiconductor wafer undergoing rapid temperature changes is characterized. Close comparison between theory and experiment in terms of the wafer eigenvalue and dc gain is demonstrated; the strong nonlinear effects of temperature are shown. Convective heat transfer losses are also examined and are shown to increase with radial position on the wafer.     

Modulation Frequency Multiplexed Tunable Diode Laser Spectroscopy System for Simultaneous CO, CO2 Measurements

A modulation frequency multiplexed dual diode-laser system is developed for simultaneous detection of the two most common fire gas products CO and CO2. Simultaneous detection is achieved by modulating each laser at different frequencies, demodulating the signal by a pair of lock-in amplifiers for each gas. Laser beams are combined and detected by one detector after passing through an identical optical path. The experimental results show little performance degradation associated with modulation frequency multiplexing, and no cross-talk between the two multiplexed detection channels is measured.     

Dimensional Properties of Fractional Brownian Motion

Let B^α = {B^α（t）,t E R^N} be an （N,d）-fractional Brownian motion with Hurst index α∈ （0, 1）. By applying the strong local nondeterminism of B^α, we prove certain forms of uniform Hausdorff dimension results for the images of B^α when N 〉 αd. Our results extend those of Kaufman for one-dimensional Brownian motion.     

亚细胞器诱导的2,4,6-三硝基甲苯阴离子自由基的ESR研究

本文在无氧条件下利用ESR分别观察了肝脏和晶状体的微粒体及线粒体酶在NADPH存在下还原三硝基甲苯(TNT)的过程,检测到参数为g=2.0048±0.0005,A_对位~N=1.215mT,A~N=0.800±0.010mT,A~H=0.122±0.0206mT的自由基信号,并通过电子计算机对ESR谱的模拟证明该自由基信号为TNT硝基阴离子自由基,根据其超精细分裂常数认为,其不配对电子的电子云密度主要分布在对位硝基上。     

Irradiation-induced reduction and luminescence properties of Sm doped in BaBPO5

Usually, Sm²⁺ ions could be reduced by heating the materials in reducing atmospheres. Exposure to ionizing radiations is also known to cause Sm³⁺→Sm²⁺ conversion. In this work, BaBPO₅ doped with the samarium ion was prepared by high temperature solid-state reaction. Sm²⁺ ions were obtained by two different reduction methods, i.e., heating in H₂ reduced atmosphere and X-ray irradiation. The measurements of X-ray diffraction (XRD), and scanning electron microscope (SEM) were investigated. It is found that the conversion of Sm³⁺→Sm²⁺ is very efficient in BaBPO₅ hosts after X-ray irradiation. Sm²⁺ ions under these two reduction methods exhibit different characteristics that were studied by measurements of luminescence and decay. The results showed that the luminescence properties of Sm²⁺ ions in BaBPO₅ were highly dependent on the sample preparation conditions.     

Palladium-catalyzed C-N bond formation: synthesis of 1-aryl-1H-pyrazoles from β-bromovinyl aldehydes and arylhydrazines

Cyclic and acyclic β-bromovinyl aldehydes are cyclized with an array of arylhydrazines in toluene at 125 °C in the presence of a palladium catalyst and a phosphorus chelating ligand together with NaO^tBu to give 1-aryl-1H-pyrazoles in moderate to good yields.     

Measurement of small-signal and large-signal responses of packaged laser modules at high temperature

In this paper, the pulsed injection method is extended to measure the chip temperature of various packaged laser modules, such as the DFB laser modules, the FP laser modules, and the EML laser modules. An optimal injection condition is obtained by investigating the dependence of the lasing wavelength on the width and period of the injection pulse in a relatively wide temperature range. The small-signal frequency responses and large-signal performances of packaged laser modules at different chip temperature are measured. The adiabatic small-signal modulation characteristics of packaged LD are first extracted. In the large-signal measurement, the effects of chip temperature, bias current and driving signal on the performances of the laser modules are discussed. It has been found that the large-signal performances of the EML modules depend on the different red-shift speeds of the DFB and EAM sections as chip temperature varying, and the optimal characteristics may be achieved at higher temperature.