The effect of olefinic terminal chains on the mesomorphic properties of 4,4'-disubstituted diphenyldiacetylenes

New diphenyldiacetylenes of the type with A, B = H and/or F; m = 0, 1; n = 1-4; and X = C n H 2n + 1 , F, CF 3 or CN were synthesized and their mesomorphic properties determined by hot stage polarizing microscopy and DSC. When m = 0, all of these compounds showed only a nematic phase except when X = CF 3 when both nematic and smectic A phases were seen. Both clearing and melting temperatures were higher than those reported for substitution with the corresponding alkyl chains but the much larger increase in clearing temperatures produced considerably wider nematic phases. Eutectic mixtures of a few of these olefins yielded nematic materials also having much wider temperature ranges and higher clearing temperatures than the eutectic mixtures of the alkyl compounds, while retaining their high birefringence and low viscosities. Such materials are of interest for beam-steering devices.

Four of the diacetylenes with m = 1 ( A, B = H) were also prepared ( X = C 6 H 13 , F, n = 2, 3). When X was C 6 H 13 ( n = 2), the nematic range was smaller in the 2- than in the 1-olefin but wider than in the alkyl series. When X = F, either no nematic phase or a monotropic one was observed, whereas the 1-olefins gave a much wider nematic phase. Both transition temperatures were lower than those for the corresponding 1-olefin and alkyl analogues. The compound with X = C 6 H 13 and n = 2 had a melting temperature below room temperature.     

A rapid and sensitive extractive spectrophotometric determination of copper(II) in pharmaceutical and environmental samples using benzildithiosemicarbazone.

Benzildithiosemicarbazone (BDTSC) is proposed as a sensitive and selective analytical reagent for the extractive spectrophotometric determination of copper(II). BDTSC reacts with copper(II) in the pH range 1.0-7.0 to form a yellowish complex. Beer's law is obeyed in the concentration range 0.5-0.4 microg cm(-3). The yellowish Cu(II)-BDTSC complex in chloroform shows a maximum absorbance at 380 nm, with molar absorptivity and Sandell's sensitivity values of 1.63 x 10(4) dm3 mol(-1) cm(-1) and 0.00389 microg cm(-2), respectively. A repetition of the method is checked by finding the relative standard deviation (RSD) (n = 10), which is 0.6%. The composition of the Cu(II)-BDTSC complex is established as 1:1 by slope analysis, molar ratio and Asmus' methods. An excellent linearity with a correlation coefficient value of 0.98 is obtained for the Cu(II)-BDTSC complex. The instability constant of the complex calculated from Edmond and Birnbaum's method is 7.70 x 10(-4) and that of Asmus' method is 7.66 x 10(-4), at room temperature. The method is successfully employed for the determination copper(II) in pharmaceutical and environmental samples. The reliability of the method is assured by analyzing the standard alloys (BCS 5g, 10g, 19e, 78, 32a, 207 and 179) and by inter-comparison of experimental values, using an atomic absorption spectrometer.     

Growth and study of single crystals of (Na,K)NbO<Subscript>3</Subscript> solid solutions

(Na, K)NbO₃ crystals with a perovskite structure and a KNbO₃ content up to 40 mol % were grown from flux with the use of the solvent NaBO₂. The dielectric measurements of the crystals grown revealed phase transitions that had never been observed before in ceramic samples.