Response of poly(vinyl chloride) electrodes based on the neutral carrier 1,4,7,10-tetraoxacyclododecane

Ion-selective electrodes based on the neutral carrier, 12-crown-4, in a poly(vinyl chloride) matrix were found to respond ideally, or almost ideally, to potassium, sodium, barium, strontium, magnesium, cobalt(II), nickel(II) and aluminum ions. The electrode showed good selectivity for Al³⁺ over Co²⁺ and Mg²⁺, and for Co²⁺ over Mg²⁺. Little selectivity was found for the other ions tested.     

Configuration interaction (CI): Approximate inclusion of fourfold and threefold excitations,an application of knowledge engineering

It is shown that even the CPMET approximation for the contributions of fourfold excitations can be replaced by a more sophisticated method. Furthermore, an approximation is presented for the contributions of threefold excitations which are neglected in CPMET . Finally, it is described how the advantages of different CEPA methods can be united in a single CEPA scheme (called CEPA -U). The various approximations are discussed in terms of Slater determinants, and it is shown how the relatively large amount of details can be handled with the help of computer programs, i.e., how knowledge engineering can be successfully applied here.     

A samarium cyclooctatetraene complex as catalyst for hydroamination/cyclisation catalysis

The cyclooctatetraene-bis(phosphinimino)methanide complex [[CH(PPh2NSiMe3)2]Sm(eta8-C8H8)] has been prepared; although this compound has no alkyl or amide ligand it shows moderate activity as a catalyst for the hydroamination/cyclisation reaction.     

Three‐Component Reactions with (S)‐Methyl Pyroglutamate: An Efficient Way to Diversely Substituted Asymmetric Amidocyclohexenes

Chiral N‐dienyl lactams are crucial building blocks for the synthesis of complex organic compounds. However, their generation is rather challenging. This paper reports the novel one‐pot reaction of (S)‐methyl pyroglutamate as the a mide component with different a ldehydes and d ienophiles (AAD reaction) to give novel chiral 1‐amido‐2‐cyclohexenes. The corresponding N‐dienyl lactams generated in situ undergo subsequent Diels–Alder reactions in good yield and diastereoselectivity. The scope and limitations of the three‐component protocol were investigated. X‐ray and NMR spectroscopic analysis of the products as well as DFT calculations of the intermediates were also performed to explain the observed stereoselectivity and structural features.     

Stepwise hydration and multibody deprotonation with steep negative temperature dependence in the benzene.+ -water system

We studied the stepwise hydration and solvent-mediated deprotonation of the benzene*+ cation (Bz*+) and found several unusual features. The solvent binding energies DeltaH on-1,n for the reactions Bz*+(H2O)n-1 + H2O --> Bz*+(H2O)n are nearly constant at 9 +/- 1 kcal mol-1 for n = 1 to 8. We observed a remarkable sudden decrease in the entropy of association accompanying the formation of Bz*+(H2O)7 and Bz*+(H2O)8, indicating strong orientational restraint in the hydration shells of these clusters consistent with the formation of cagelike structures. We observed the size-dependent deprotonation of Bz*+ in a cooperative multibody process, where n H2O molecules (n >/= 4) can remove a proton from Bz*+ to form protonated water clusters. We measured, for the first time, the temperature dependence of such a process and found a negative temperature coefficient of a magnitude unprecedented in any chemical reaction, of the form k = AT-67+/- 4, or in an Arrhenius form having an activation energy of -34 +/- 1 kcal mol-1. The temperature effect may be explained by Bz*+ and four H2O molecules needing to be assembled from gas-phase components to form the reactive species. Such large temperature effects may be therefore general in solvent cluster-mediated reactions.     

Crystal engineering of novel cocrystals of a triazole drug with 1,4-dicarboxylic acids

Cocrystals of the poorly soluble antifungal drug cis-itraconazole (1) with 1,4-dicarboxylic acids have been prepared. The crystal structure of the succinic acid cocrystal with 1 was determined to be a trimer by single-crystal X-ray. The trimer is comprised of two molecules of 1 oriented in antiparallel fashion to form a pocket with a triazole at either end. The extended succinic acid molecule fills the pocket, bridging the triazole groups through hydrogen-bonding interactions rather than interacting with the more basic piperazine nitrogens. The solubility and dissolution rate of some of the cocrystals are approximately the same as those of the amorphous drug in the commercial formulation and are much higher than those for the crystalline free base. The results suggest that cocrystals of drug molecules have the possibility of achieving the higher oral bioavailability common for amorphous forms of water-insoluble drugs while maintaining the long-term chemical and physical stability that crystal forms provide.     

Solid-state synthesis of a conducting polythiophene via an unprecedented heterocyclic coupling reaction

Prolonged storage ( approximately 2 years) or gentle heating (50-80 degrees C) of crystalline 2,5-dibromo-3,4-ethylenedioxythiophene (DBEDOT) affords a highly conducting, bromine-doped poly(3,4-ethylenedioxythiophene) (PEDOT), as confirmed by solid-state NMR, FTIR, CV, and vis-NIR spectroscopies. The novel solid-state polymerization (SSP) does not occur for 2,5-dichloro-3,4-ethylenedioxythiophene (DCEDOT), and requires a much higher temperature (>130 degrees C) for 2,5-diiodo-3,4-ethylenedioxythiophene (DIEDOT). X-ray structural analysis of the above dihalothiophenes reveals short Hal.Hal distances between adjacent molecules in DBEDOT and DIEDOT, but not in DCEDOT. The polymerization may also occur in the melt but is significantly slower and leads to poorly conductive material. Detailed studies of the reaction were performed using ESR, DSC, microscopy, and gravimetric analyses. SSP starts on crystal defect sites; it is exothermic by 14 kcal/mol and requires activation energy of approximately 26 kcal/mol (for DBEDOT). The temperature dependence of the conductivity of SSP-PEDOT (sigma(rt) = 20-80 S/cm) reveals a slight thermal activation. It can be further increased by a factor of 2 by doping with iodine. Using this approach, thin films of PEDOT with conductivity as high as 20 S/cm were fabricated on insulating flexible plastic surfaces.     

The importance of temperature and viscosity effects for surfactant adsorption measurements made using the electrochemical quartz crystal microbalance

The measurement of adsorbed surfactant is important to fields such as corrosion inhibition, metal cleaning, and separation technologies. The electrochemical quartz crystal microbalance (EQCM) is an important tool that can be used to measure adsorbed surfactant. However, such measurements are subject to significant temperature and viscosity effects that must be appropriately considered. This paper discusses the effect of temperature and viscosity on EQCM measurements in solution environments and the ability of the EQCM to measure surfactant adsorption.     

A new method for gaining insight into the chemistry of drying mineral surfaces using ATR-FTIR

Although it is understood that the chemical environment at a drying surface is likely to be quite different from that at a fully hydrated surface, the difficulty of quantitative measurement has meant that this potentially crucial aspect of surface chemistry has gone largely overlooked. As a result, most of our understanding comes from measurement before and after drying, with a gray region of speculation in between. An interesting natural example is the paradoxical reduction of Mn oxides in moist soils as they dry, because drying is usually considered an oxidative process. This phenomenon indicates that important chemical changes are occurring during drying and an approach is needed to probe the chemistry of drying surfaces. Here we show the suitability of attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectroscopy for real-time, in situ investigation of the drying solid-water interface, using the change in surface pH as an example. This was achieved by adsorbing thymol blue pH indicator (pK(a)=1.65) onto a natural Mn-rich clay and observing the real-time pH change, which dropped from pH 5 to below pH 1.65 with the removal of free water from the surface.     

Cyclization of Nitrospirobenzopyrans to Bridged Benzoxazepino[3,2-a]indoles

Condensation of 1-substituted 1,2,3,9a-tetrahydro-9H-imidazo[1,2-a]indol-2-ones with 5-nitrosalicylaldehyde afforded 1′-[(N-monosubstituted carbamoyl)methyl]indoline nitrospirobenzopyrans. Treatment of the latter with strong base led to the formation of a mixture of cis/trans-5a,13-methano-1,3-benzoxazepino[3,2-a]indoles. Results of semiempirical calculations gave evidence that such a transformation of nitrospirobenzopyrans to bicyclic indole derivatives could proceed via a single transition state, where the negatively charged carbon atom attacks the vinylic double bond of the spiropyran system.