Multi-Objective Optimization of the Basic and Regenerative ORC Integrated with Working Fluid Selection

A multi-objective optimization based on the non-dominated sorting genetic algorithm (NSGA-II) is carried out in the present work for the basic organic Rankine cycle (BORC) and regenerative ORC (RORC) systems. The selection of working fluids is integrated into multi-objective optimization by parameterizing the pure working fluids into a two-dimensional array. Two sets of decision indicators, exergy efficiency vs. thermal efficiency and exergy efficiency vs. levelized energy cost (LEC), are adopted and examined. Five decision variables including the turbine inlet temperature, vapor superheat degree, the evaporator and condenser pinch temperature differences, and the mass fraction of the mixture are optimized. It is found that the turbine inlet temperature is the most effective factor for both the BORC and RORC systems. Compared to the reverse variation of exergy efficiency and thermal efficiency, only a weak conflict exists between the exergy efficiency and LEC which tends to make the binary objective optimization be a single objective optimization. The RORC provides higher thermal efficiency than BORC at the same exergy efficiency while the LEC of RORC also becomes higher because the bare module cost of buying one more heat exchange is higher than the cost reduction due to the reduced heat transfer area. Under the heat source temperature of 423.15 K, the final obtained exergy and thermal efficiencies are 45.6% and 16.6% for BORC, and 38.6% and 20.7% for RORC, respectively.     

共聚物组成对线形苯乙烯-丁二烯-苯乙烯嵌段共聚物粘弹弛豫与相形态的影响

研究了不同组成的苯乙烯-丁二烯-苯乙烯嵌段共聚物(SBS)的相形态与粘弹弛豫.用透射电子显微镜(TEM)表征了SBS的形态,结果显示,几种SBS均呈层状结构,随着苯乙烯含量的降低,聚苯乙烯(PS)相的尺寸稍有减小,而聚丁二烯(PB)相尺寸明显增大.用动态流变学方法考察了不同温度下SBS嵌段大分子的弛豫行为,结果表明,苯乙烯含量减少,PS相玻璃化转变和有序-无序转变温度均降低;苯乙烯含量少的,在有序-无序转变过程中呈现出高且宽的损耗峰,表明有序-无序转变过程中能量的耗散主要由两相溶合时分子链间的内摩擦所决定,分子链越长,内摩擦越大,能量耗散越大.     

Synergistic Treatment of Congo Red Dye with Heat Treated Low Rank Coal and Micro-Nano Bubbles

In this study, the adsorption method and micro-nano bubble (MNB) technology were combined to improve the efficiency of organic pollutant removal from dye wastewater. The adsorption properties of Congo red (CR) on raw coal and semi-coke (SC) with and without MNBs were studied. The mesoporosity of the coal strongly increased after the heat treatment, which was conducive to the adsorption of macromolecular organics, such as CR, and the specific surface area increased greatly from 2.787 m²/g to 80.512 m²/g. MNBs could improve the adsorption of both raw coal and SC under different pH levels, temperatures and dosages. With the use of MNBs, the adsorption capacity of SC reached 169.49 mg/g, which was much larger than that of the raw coal at 15.75 mg/g. The MNBs effectively reduced the adsorption time from 240 to 20 min. In addition, the MNBs could ensure the adsorbent maintained a good adsorption effect across a wide pH range. The removal rate was above 90% in an acidic environment and above 70% in an alkaline environment. MBs can effectively improve the rate of adsorption of pollutants by adsorbents. SC was obtained from low-rank coal through a rapid one-step heating treatment and was used as a kind of cheap adsorbent. The method is thus simple and easy to implement in the industrial context and has the potential for industrial promotion.     

Preparation of NaYF4:,Er3+/TiO2 composite and up-conversion luminescence properties under visible light excitation

The up-conversion luminescence composite NaYF 4:Er 3+ /TiO 2 is prepared using the sol-gel method.The specimen has good crystallinity and two shapes,i.e.,viereck and round,while the sizes of viereck and round particles are both micron-sized.The TiO 2 has an anatase structure,while the NaYF 4 has a hexagonal phase,which can be hardly obtained through the common sol-gel method.Due to the big particle size and the high crystallinity of pure NaYF 4:Er 3+,the composite has a small specific surface area that is less than Degussa P25 TiO 2.The NaYF 4:Er 3+ /TiO 2 composite shows several emission peaks at 211,237,and 251 nm under the excitation of 388 nm,at 395 nm and 411 nm under the excitation of 500 nm,and at 467,481,492,and 508 nm under the excitation of 570 nm.     

Ⅱ-Ⅵ族半导体激光器的新材料——ZnO量子点

介绍了研制Ⅱ－Ⅵ族半导体激光器方面的一个新途径－－自组织生长ＺｎＯ量子点微晶结构、ＺｎＯ已经实现了室温下光泵激发的受激发射,它将是继Ⅱ－Ⅵ族硒化物、Ⅲ－Ⅴ经物之后的又一种半导体激光器材料。     

利用BESⅢ的双层TOF寻找D0-D0混合的研究

在ψ(3770)处, D⁰→K^－π⁺是研究D⁰-D⁰混合的非常理想的衰变道. 实验上, 良好K/π识别技术将对寻找D⁰-D⁰混合过程起着决定性的作用. 在BESⅢ实验的物理预研究中, 发现利用飞行时间的信息, 能够精确测定末态中含有多条带电径迹事例的起始时间, 从而可以改善飞行时间计数器的时间分辨率. 进一步的研究表明, 应用该方法后, BESⅢ双层TOF的时间分辨率从～78ps降到～64ps. 按照20fb^－1的ψ(3770)数据量进行估算, 在95%置信度下, D⁰-D⁰混合率的上限值可以提高7%左右.     

X射线衍射多相谱中某一物相点阵参数的直接求解方法

介绍了一种新的求解点阵参数的方法--不涉及结构的谱峰拟合方法.该方法适用于单一物相或多个物相衍射谱中某一物相点阵参数的直接求解,可以避免外推函数的不同选择而造成的差异,且快速准确.根据此方法编写的应用程序已在实际工作中得到应用.程序中还包括了调整样品表面离轴偏差和零度偏差以提高拟合精确度的功能. 关键词： X射线衍射 谱峰拟合 点阵参数     

Validity of Lamb-Dicke Approximations in Ion-Trap Systems

The Lamb-Dicke （LD） approximation （LDA） is usually utilized to simplify the treatments for the dynamics of ion-trap systems, where the so-called LD parameters should be sufficiently small. In this Letter, based on the quantum dynamics of a single trapped ion beyond the LDA, we discuss the fidelities of the control-NOT （CNOT） gate generated by performing the usual LDA. It is shown that the fidelity of the generated CNOT gate under the LDA is sufficiently high for the current LD experiments, e.g., it reaches 99.9% for η=0.20. The validity of the LDA is also discussed by calculating these fidelities for slightly larger LD parameters, e.g., η=0.4, etc.     

纳米银粒子复合膜的制备及光学性质测量

本文介绍了一种制备纳米复合薄膜的简易方法.以银胶为纳米粒子的来源,将银粒子渗入明胶基质中,成功地制备出纳米银粒子明胶复合膜及染料(FS,Rh6G)包覆纳米银粒子的复合膜.并报道了所制备的复合膜的电镜(TEM)、吸收谱和荧光光谱测量结果.     

应用差分干涉技术研究气体与水两相传热

本文用脉冲红宝石激光器结合差分干涉技术研究气体与水的两相传热过程,实验结o果表明在水蒸汽与空气的分界面里存在大量的波纹状的细条纹;并分析了折射率与温度梯度的关系。