High temperature reactions of titanium(IV) oxide with some alkali persulfates and their decomposition products

The solid state reactions between TiO₂ and Na₂S₂O₈ or K₂S₂O₈ have been investigated using TG, DTG, DTA, IR, and X-ray diffraction studies in the range of 20 to 1000°C.It has been shown that TiO₂ reacts stoichiometrically (1 : 1) with Na₂S₂O₈ in the range of 160 and 220°C forming the complex sodium monoperoxodisulfato—titanium(IV) as characterized by IR and X-ray analysis. The new complex then decomposes into the reactants above 190°C.An exothermic reaction has been observed between TiO₂ and molten K₂S₂O₇ at mole ratio 1:2 respectively and higher, in the range of 280 and 350°C. The IR and X-ray analyses have shown the formation of a complex namely, potassium tetrasulfato titanium(IV) for which the formula and structure have been proposed. This complex decomposes at higher temperatures into K₂SO₄ and a mixed sulfate of potassium and titanium. The mixed sulfate melts at 620°C and decomposes into K₂SO₄, TiO₂, and the gaseous SO₃.On the other hand, Na₂S₂O₈ decomposes in a special mode producing a polymeric product of Na₁₀S₉O₃₂. Decomposition of this species occurs after melting at 560°C into Na₂SO₄ and sulfur oxides. The decomposition reaction has been proved to be catalysed by TiO₂ itself.     

Two New Pyrrolizidines from Ligularia lankongensis

Two new pyrrolizidines named lankongensisine A (1), B (2) were isolated from the roots of Ligularia lankongensis collected in Lijiang, Yunnan, and their structures were established by spectroscopic analysis.     

Three New Anthraquinones from Polygonum cillinerve

Three new anthraquinones, emodin-8-β-D-（2＂-O-coumarate）glucoside 1, emodin-8-β-D-（6＇-O-acetyl）glucoside 2 and physicon-8-β-D-（6＇-O-acetyl）glucoside 3, were isolated from the roots of Polygonum cillinerve and their structures were established by spectroscopic methods. The biological activity indicated that compound 1 had the scavenging activity on 1,1-diphenyl-2-picrylhydrazyl （DPPH） radicals （the IC50 = 8.5 μmol/L）, and compound 1-3 showed no activities against HL-60 and BCJC-823 cells by MTT method in vitro.     

活性炭纤维电极电解法处理墨绿B染料废水

将铁丝缠绕在活性炭纤维(简称ACF)上制成电极,并在阴极鼓入空气,用电解生成的Fenton试剂处理墨绿B染料模拟废水.研究了电压、pH值、温度、空气流量、支持电解质的浓度等因素对染料脱色率的影响.结果表明,pH值越低,温度越高,处理效果越好,气流量的改变对于处理效果影响不大.室温时处理浓度为50mg·L-1的活性染料墨绿B,在实验电压为11V,中性条件下,无水硫酸钠的浓度为20g·L-1,通入空气流量为60L·min-1时,处理60min,色度去除率达到95%左右.55℃时,电解30min色度去除率就达到96%,60min时达到100%.     

Copper-catalyzed N-arylation of diazoles with aryl bromides using KF/Al2O3: an improved protocol

Copper-catalyzed N-arylation of diazoles can be accomplished using air-stable CuI as a copper source and 1,10-phenanthroline in the presence of KF/Al₂O₃ as a base. This is a simple and efficient method for the coupling of aryl bromide with diazoles. Different functionalized aryl bromides were coupled with diazoles using this system.     

5′-substituted-5′-deoxy nucleosides

The methyl esters of the uronic acids derived from uridine, 5-fluorodeoxyuridine, 6-aza-2′-deoxyuridine and 2′,3′-o-isopropylideneadenosine were converted to the amides with aqueous d0·88 ammonia. After protection of the sugar hydroxyls each 5′-carboxamide was dehydrated with phosphoryl chloride at ?5° to yield, after deprotection, the respective novel 5′-nitrile nucleosides. Treatment of the protected 5′-nitrile nucleosides with ammonium azide in DMF gave, after deprotection, the novel 5′-C-tetrazole nucleosides.     

Cyclic Voltammograms of Ferrocene on Multi‐Walled Carbon Nanotubes (MWCNTs)‐Modified Edge Plane Pyrolytic Graphite (EPPG) Electrode in Room Temperature Ionic Liquids (RTILs) of 1‐Ethyl‐3‐Methylimidazolium Tetrafluoroborate (EMIBF4)

In this work, the electrochemical behavior of ferrocene (Fc) was investigated by cyclic voltammetry (CV) in room temperature ionic liquids (RTILs) of 1‐ethyl‐3‐methylimidazolium tetrafluoroborate (EMIBF₄) on glass carbon (GC), edge plane pyrolytic graphite (EPPG) and multi‐walled carbon nanotube (MWCNTs)‐modified EPPG electrodes, respectively. The results demonstrated that on GC electrode, pairs of well‐defined reversible peaks were observed, while for the electrode of EPPG, the peak potential separation (ΔE_p) is obviously larger than the theoretical value of 59 mV, hinting that the electrode of EPPG is distinguished from the commonly used electrode, consistent with the previous proposition that EPPG has many “defects”. To obtain an improved electrochemical response, multi‐walled carbon nanotubes (MWCNTs) were modified on the electrode of EPPG; the increased peak current and promoted peak potential separation not only proved the existence of “defects” in MWCNTs, but also supported that “creating active points” on an electrode is the main contribution of MWCNTs. Initiating the electrochemical research of Fc on the MWCNTs‐modified EPPG electrode in RTILs and verifying the presence of “defects” on both EPPG and MWCNTs using cyclic voltammograms (CVs) of Fc obtained in RTILs of EMIBF₄, is the main contribution of this preliminary work.     

Synthesis of (R)-alpha-benzylmethionine: a novel rearrangement during alkylation of the Seebach (R)-methionine oxazolidinone

Alkylation of the enolate of the Seebach (R)-methionine oxazolidinone with benzyl bromide gave the expected benzylated product in low yield. The major product was a novel amine arising from oxazolidinone cleavage, decarboxylation, alkylation and finally hydrolysis. The rearrangement could be suppressed by using a more reactive electrophile or by using the N-Cbz instead of the N-benzoyl protecting group, and the required (R)-alpha-benzyl-methionine was obtained in 78% yield and in an enantiomeric ratio of 90:10.     

Electrocatalytic oxidation of thiosulfate on a modified nickel hexacyanoferrate film electrode

Summary A modified nickel hexacyanoferrate film glassy carbon electrode is prepared by the electrochemical deposition technique. The film is very stable upon voltammetric scanning in the potential range of 1.0 to –0.5 V (vs. SCE) and an oxidation peak occurs at 0.35 V (vs. SCE) (1 mol/l NaNO₃). The effects of electrolyte, solvent, coexisting ions and other variables on the voltammetric behaviour of the modified film have been studied. The thickness of the resulting film can be controlled by changing the number of voltammetric cycles and the concentrations of nickel(II) and hexacyanoferrate(III) ions. The film shows catalytic activity towards electrooxidation of thiosulfate with a peak potential +0.5 V (K^–-containing media). This oxidation potential of thiosulfate on the modified electrode is shifted negatively by about 550 mV as compared to the naked glassy carbon electrode. For practical application, the modified electrode can be used for the determination of thiosulfate in concentrations from 5.0×10^–5 to 1.0×10^–1 mol/l. This method has been successfully applied to the determination of thiosulfate in photographic waste effluents.