在线滤波技术在光纤马赫-德尔交叉复用器中的应用

为构造出与理想梯形滤波器接近的滤波形状，在单级光纤马赫-德尔交叉复用器的基础上，引入在线滤波技术；通过增加干涉级数和调整2对干涉臂的干涉长度和耦合器的耦合比，实现了逼近宽带陡沿的滤波输出。通过与梯形滤波器傅里叶展开式的比较，计算得到了器件的最佳参数，器件的滤波性能以及温度稳定性相对于单级结构得到了明显提高。根据理论计算，成功制作出通道间隔为50GHz的样品器件。其输出为-0.5dB，带宽大于0.185nm，相邻通道隔离度大于30dB，满足了DWDM系统指标要求。     

离子束引起的在Al／Cr双层薄膜界面处的原子混合

用600keV的Kr~ 离子轰击Al/Cr双层薄膜样品进行界面原子反应及相互混合的研究。实验样品是在单晶硅上蒸镀约500nm厚的铝膜,相继再蒸上所需厚度的铬膜而制成的。轰击剂量为2.0×10~(15)-2.5×10~(16)Kr~ /cm~2。用2.0MeVa粒子对轰击前后的样品进行了卢瑟福背散射(RBS)分析,发现界面处有明显的原子混合存在;当轰击剂量≥1.0×10~(16)Kr~ /cm~2时,RBS谱出现有明显的坪台,经拟合计算和x射线衍射(XRD)测量证实确有化合物Al_(13)Cr_2存在;还分别得到了原子混合量及混合效率与轰击剂量的关系;最后对界面处的原子混合机制进行了讨论。     

<Emphasis FontCategory="NonProportional">L</Emphasis>-Matrices and solvability of linear complementarity problems by a linear program-Matrices and solvability of linear complementarity problems by a linear program

The classes ofL ₁-matrices,L ₂-matrices,L ₃-matrices andW-matrices are introduced to study solvability of a linear complementarity problem via solving a linear program. Three sufficient conditions are presented to guarantee that a linear complementarity problem is solvable via a linear program. The new sufficient conditions are weaker than the ones introduced by Mangasarian. This fact is also illustrated by an example. Partially supported by NSFC. This author is also with College of Business Administration of Human University as a Lotus chair professor.     

Power scaling of printed-circuit-board preionized TEA CO2 laser up to 3.6 kW

A high average power, high-repetition-rate TEA CO₂ laser employing printed-circuit-board preionizer is described. The power scaling of this preionization configuration has been demonstrated. The average output power reaches 3.6 kW at pulse repetition rate of 180 pps. Furthermore, the scaling-up ability of the rotating spark gap as high-voltage switch for high-average-power gas laser has been validated.     

亚细胞器诱导的2,4,6-三硝基甲苯阴离子自由基的ESR研究

本文在无氧条件下利用ESR分别观察了肝脏和晶状体的微粒体及线粒体酶在NADPH存在下还原三硝基甲苯(TNT)的过程,检测到参数为g=2.0048±0.0005,A_对位~N=1.215mT,A~N=0.800±0.010mT,A~H=0.122±0.0206mT的自由基信号,并通过电子计算机对ESR谱的模拟证明该自由基信号为TNT硝基阴离子自由基,根据其超精细分裂常数认为,其不配对电子的电子云密度主要分布在对位硝基上。     

Diffusion via splitting and remeshing via merging in vortex methods

The technique of splitting a fat vortex element (with a core width larger than some threshold) into some thin ones in order to fix the convergence problem of the core‐spreading vortex methods is convenient and efficient. In particular, it keeps the method purely Lagrangian. In the present investigation, the splitting process is further viewed as part of the physical diffusion process. A new splitting method in which several weaker child vortices surround a thinned but still strong parent vortex is proposed. It is found that because of the survival of the parent vortex, the error arising from the splitting events can be largely reduced. The computational amount on the other hand is kept reasonably large by merging similar and close‐by vortices. The merging scheme designed herein not only involves fewer restrictions but also allows merging vortices of opposite rotations through the viewpoint of remeshing. The validity and accuracy of these techniques, proposed particularly for simulations undergoing lots of splitting and merging events, are verified by successfully simulating the interactions between two Burgers vortices under an external straining field. Copyright © 2005 John Wiley & Sons, Ltd.     

Phenylene vinylene‐based electroluminescent polymers with electron transport block in the main chain

We report a new route for the design of soluble phenylene vinylene (PV) based electroluminescent polymers bearing electron‐deficient oxadizole (OXD) and triazole (TZ) moieties in the main chains with the aryloxy linkage. Both series of the PV‐based polymers were prepared by Wittig reaction. By properly adjusting the OXD and/or TZ content through copolymerization, we can achieve an enhanced balance of hole‐ and electron injections, such that the device efficiency is significantly improved. Light‐emitting diodes fabricated from P1, P2, P3, P4, P5, P6, and P7 with the configuration of Indium–Tin Oxide (ITO)/Poly (styrene sulfonic acid) doped poly (ethylenedioxythiophene) (PEDOT)/polymer/Ca/Al, emit bright green light with the maximum peak around 500 nm. For the device using the optimal polymer (P4) as emitting layer, a maximum brightness of 1300 cd/m² at 20 V and a maximum luminance efficiency of 0.325 cd/A can be obtained. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3469–3478, 2006     

Synthesis and application as polymer electrolyte of hyperbranched polyether made by cationic ring‐opening polymerization of 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxymethyl}‐3′‐methyl‐oxetane

A novel cyclic ether monomer 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxy‐methyl}‐3′‐methyloxetane (HEMO) was prepared from the reaction of 3‐hydroxymethyl‐3′‐methyloxetane tosylate with triethylene glycol. The corresponding hyperbranched polyether (PHEMO) was synthesized using BF₃·Et₂O as initiator through cationic ring‐opening polymerization. The evidence from ¹H and ¹³C NMR analyses revealed that the hyperbranched structure is constructed by the competition between two chain propagation mechanisms, i.e. active chain end and activated monomer mechanism. The terminal structure of PHEMO with a cyclic fragment was definitely detected by MALDI‐TOF measurement. A DSC test implied that the resulting polyether has excellent segment motion performance potentially beneficial for the ion transport of polymer electrolytes. Moreover, a TGA assay showed that this hyperbranched polymer possesses high thermostability as compared to its liquid counterpart. The ion conductivity was measured to reach 5.6 × 10^?5 S/cm at room temperature and 6.3 × 10^?4 S/cm at 80 °C after doped with LiTFSI at a ratio of Li:O = 0.05, presenting the promise to meet the practical requirement of lithium ion batteries for polymer electrolytes. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3650–3665, 2006