Effect of molecular weight on the crystalline structure of polytetrafluoroethylene as-polymerized

Melting and crystallization behavior of polytetrafluoroethylene as polymerized in emulsion and suspension is shown to depend on molecular weight. DSC heating curves for virgin PTFE with low molecular weight below 3 × 10⁵ have a single peak, whereas curves for higher molecular weight samples have double peaks. With increasing heating rate the areas of higher melting peaks become larger than the lower melting peaks. The morphology of polymer exhibiting double melting peaks is mainly folded ribbons or granular particles. The phenomenon of double melting is explained on the basis of two different crystalline states which correspond to the “fold regions” and the “linear segments” in a folded ribbon. The melting temperature of virgin PTFE is almost constant at ca. 330°C for molecular weights below 1 × 10⁶, and rises as the molecular weight increases above 1 × 10⁶. The heat of melting of virgin PTFE is nearly independent of molecular weight. On the basis of these results, we propose a model for melting and crystallization of low and high molecular weight PTFE and for the crystal structure.     

Fundamental absorption spectra of transition metal chlorides

The optical absorption spectra of MnCl₂, FeCl₂, CoCl₂, and NiCl₂ have been measured over the energy range from 2 to 30 eV. The gross features of the spectra, especially broad bands above 10eV, are alike in all of the four materials. The charge transfer bands due to the electronic transitions from the 3p level of chlorine to the 3d and 4s levels of metal ions and the band due to the 3d → 4s transition are assigned in the spectra.     

Molecular weight distribution and molecular structure of polyethylene produced by radiation-induced polymerization

The molecular weight distribution of polyethylene produced by radiation was calculated according to a kinetic scheme. The calculated molecular weight distribution was compared with the results deduced from gel-permeation chromatography. The observed distribution curve from GPC was broader and showed a lower degree of polymerization than the calculated one. Discrepancies between observed and calculated curves can be explained if the polymer contains nonsteady-state products and if the reaction mechanism includes chain transfer to dead polymer. By this reaction long-chain branching would occur. Several long-chain branches per polymer molecule were indeed found, as inferred from solution properties.     

Magnetic hyperfine structure of muonic and electronic atoms

The magnetic hyperfine structure of atoms is studied. A new compact expression is introduced for the magnetic hyperfine anomaly. A theoretical foundation is given for an empirical formula discovered by Moskowitz and Lombardi. The effects of core polarization and mesonic exchange currents are discussed. There are two kinds of core polarization, Δl = 0 and Δl = 2. The latter is shown to be important to explain certain isotope shifts, though it is smaller than the former Δl = 0 effect.     

Sm(II)-Mediated Reduction in Water: Importance of the Additive in the Proportionation of SmCl3 and Sm

Mechanistic studies of the SmCl₃-Sm system in water were carried out. The addition of N,N-dimethylacetoamide (DMA) enhanced the reactivity of the one-electron reduction. According to the ultraviolet–visible (UV-vis) analysis, DMA was found to accelerate proportionation of SmCl₃ and Sm.     

Polymerization of 2-Oxazolines. IV. The Structure and the Reactivity of 2-Substituted-2-oxazolines and Oxazolinium Perchlorates

Abstract

In order to elucidate the structure and the stability of the growing cationic end in the polymerization of 2-oxazolines, the reactions of 2-bromoethylbenzamide with silver salts such as silver perchlorate, tetrafluoroborate, nitrate, nitrite, cyanate, and acetate were investigated. The reactions with silver perchlorate and tetrafluoroborate gave the 2-phenyl-2-oxazolinium salt (intramolecular O-alkylation product) quantitatively, whereas the reaction with silver nitrate gave the corresponding alkyl nitrate (staight-chain product). For the reactions with silver nitrite, cyanate and acetate, both products were obtained. In order to elucidate the ring-opening reactivity of the oxazolinium cation, the ring-opening addition reaction of N-methyl-2-oxazolinium perchlorates with pyridine was investigated. It was found that N-methyl-2-phenyl-2-oxazolinium perchlorate was more reactive toward the nucleophilic ring-opening reaction than was N-methyl-2-methyl-2-oxazolinium perchlorate. The mutual copolymerization of 2-phenyl-2-oxazoline with the other 2-substituted-2-oxazoline such as 2-methyl-, 2-isopropyl-, and 2-benzyl-2-oxazoline indicated that the monomer reactivity ratio r₂ was much larger than unity, whereas r₁ was very much smaller. Based on these results, the influence of the structure and the reactivity of the monomer and the growing cationic end of the polymerizability of 2-oxazolines are discussed.     

Polymerization of 2-Oxazolines. I. Cationic Polymerization of 2-Phenyl-2-oxazoline Initiated by Various Oxazolinium Salts of Monomer with Brbnsted Acids

Abstract

Various kinds of the complexes of 2-phenyl-2-oxazoline with various Bronsted acids were prepared. From the elementary analysis and spectroscopic analysis of the complex, it was identified to be an equimolar oxazolinium salt. The monomer could be polymerized with the oxazolinium salt to give N-benzoyl-polyethylenimine. The polymer yield in bulk polymerization was linearly proportional to the reaction time, and the number-average degree of polymerization of the polymer obtained at the complete conversion was proportional to the initial molar ratio of the monomer to the complex. The catalytic activities of the oxazolinium salts increased with a decrease in the pK_avalue of Bronsted acid in water. The results of the infrared spectroscopy and nuclear magnetic resonance spectroscopy of the oxazolinium salt at room temperature and elevated temperature indicated that the change of the double bond character of the imino and ether linkages is brought about by the complexation. On the basis of these results, the mechanism of the polymerization was proposed.     

Pressure-Volume Behavior of PMMA-MMA Coexistence System as Polymerized at High Pressure

The pressure-volume (P-V) isotherms were measured for the poly(methy1 methacrylate) (PMMA)-methyl methacrylate (MMA) coexistence system polymerized by γ-ray irradiation at various pressures. The P-V isotherm of the coexistence system polymerized below 3000 kg/cm² was similar to that of the monomer. The specific volume of the coexistence system polymerized above 3000 kg/cm² hardly changes in the pressure range between 3000 kg/cm² and the polymerization pressure when measurements are made with successively decreasing or successively increasing pressures. The compressibility was of the order of 10^?6 (kg/cm²)^?1 in this pressure range. This indicated that the coexistence system polymerized above 3000 kg/cm² behaves like a solid in this pressure range. Above the polymerization pressure, the compressibility was of the order of 10^?5 (kg/cm²)^?1, indicating that the coexistence system behaves as liquid. We concluded that the solid-like behavior of the coexistence system polymerized above 3000 kg/cm² is caused by a strong interaction between as-polymerized polymer chains and monomer molecules due to propagation through monomer clusters having short-range order. The present results support that MMA is aligned in short-range order at suitable pressure and temperature as reported in the preceding paper.     

Determining attenuation properties of interfering fast and slow ultrasonic waves in cancellous bone

Previous studies have shown that interference between fast waves and slow waves can lead to observed negative dispersion in cancellous bone. In this study, the effects of overlapping fast and slow waves on measurements of the apparent attenuation as a function of propagation distance are investigated along with methods of analysis used to determine the attenuation properties. Two methods are applied to simulated data that were generated based on experimentally acquired signals taken from a bovine specimen. The first method uses a time-domain approach that was dictated by constraints imposed by the partial overlap of fast and slow waves. The second method uses a frequency-domain log-spectral subtraction technique on the separated fast and slow waves. Applying the time-domain analysis to the broadband data yields apparent attenuation behavior that is larger in the early stages of propagation and decreases as the wave travels deeper. In contrast, performing frequency-domain analysis on the separated fast waves and slow waves results in attenuation coefficients that are independent of propagation distance. Results suggest that features arising from the analysis of overlapping two-mode data may represent an alternate explanation for the previously reported apparent dependence on propagation distance of the attenuation coefficient of cancellous bone.