Bacteria counting with impedance spectroscopy in a micro probe station

A method to quantify the density of viable biological cells in suspensions is presented. The method is implemented by low-frequency impedance spectroscopy and based on the finding that immobilized ions are released to move freely in the surrounding suspension when viable Escherichia coli cells are killed by a heat shock. The presented results show that an amount of ions corresponding to approximately 2 x 10(8) unit charges are released per viable bacterium killed. A micro probe station with coplanar Ti electrodes was electrically characterized and used as a measuring unit for the impedance spectroscopy recordings. This unit is compatible with common microfabrication techniques and should enable the presented method to be employed using a flow-cell device for viable bacteria counting in miniaturized on-line monitoring systems.     

N-Aryl Isoleucine Derivatives as Angiotensin?II AT2 Receptor Ligands

A novel series of ligands for the recombinant human AT₂ receptor has been synthesized utilizing a fast and efficient palladium-catalyzed procedure for aminocarbonylation as the key reaction. Molybdenum hexacarbonyl [Mo(CO)₆] was employed as the carbon monoxide source, and controlled microwave heating was applied. The prepared N-aryl isoleucine derivatives, encompassing a variety of amide groups attached to the aromatic system, exhibit binding affinities at best with K_i values in the low micromolar range versus the recombinant human AT₂ receptor. Some of the new nonpeptidic isoleucine derivatives may serve as starting points for further structural optimization. The presented data emphasize the importance of using human receptors in drug discovery programs.     

Tailored side‐chain architecture of benzil voltage stabilizers for enhanced dielectric strength of cross‐linked polyethylene

The synthesis and physico‐chemical properties of seven benzil‐type voltage stabilizers are reported. The benzil core is substituted with alkyl chains of different length that are linked to the benzil core via an ester, ether, or tertiary amine group. All additives can be melt‐processed with low‐density polyethylene (LDPE). Fourier‐transform infrared spectroscopy confirms that benzil compounds are not affected by the LDPE cross‐linking reaction induced by dicumyl peroxide. Moreover, a combination of gel content measurements, thermal analysis, and small‐angle X‐ray scattering indicates that the presence of benzil voltage stabilizers does not significantly alter the microstructure of cross‐linked polyethylene (XLPE). Electrical tree inhibition experiments under high‐voltage alternating current conditions show that all investigated additives substantially enhance the dielectric strength of the insulating material at a concentration of only 10 mmol kg^?1. The highest improvement in dielectric strength, of more than 70% with respect to reference XLPE, is obtained with voltage stabilizers, which carry short (methyl) side chains that are linked to the benzil core via an ester or tertiary amine group. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2014 , 52, 1047–1054     

Size separations of starch of different botanical origin studied by asymmetrical-flow field-flow fractionation and multiangle light scattering

Asymmetrical-flow field-flow fractionation combined with multiangle light scattering and refractive index detection has been revealed to be a powerful tool for starch characterization. It is based on size separation according to the hydrodynamic diameter of the starch components. Starch from a wide range of different botanical sources were studied, including normal starch and high-amylose and high-amylopectin starch. The starch was dissolved by heat treatment at elevated pressure in a laboratory autoclave. This gave clear solutions with no granular residues. Amylose retrogradation was prevented by using freshly dissolved samples. Programmed cross flow starting at 1.0 mL min(-1) and decreasing exponentially with a half-life of 4 min was utilised. The starches showed two size populations representing mainly amylose and mainly amylopectin with an overlapping region where amylose and amylopectin were possibly co-eluted. Most of the first population had molar masses below 10(6) g mol(-1), and most of the second size population had molar masses above 10(7) g mol(-1). Large differences were found in the relative amounts of the two populations, the molar mass, and hydrodynamic diameters, depending on the plant source and its varieties.     

Rational redesign of Candida antarctica lipase B for the ring opening polymerization of D,D-lactide

Based on molecular modelling, the enzyme Candida antarctica lipase B was redesigned as a catalyst for the ring opening polymerization of D,D-lactide. Two mutants with 90-fold increased activity as compared to the wild-type enzyme were created. In a preparative synthesis of poly(D,D-lactide) the mutants greatly improved the rate and the degree of polymerization.     

A high-throughput multicomponent screening method for diuretics, masking agents, central nervous system (CNS) stimulants and opiates in human urine by UPLC-MS/MS

A simple and rapid multicomponent screening method of 130 substances for direct injections of urine samples has been developed. The fully automated method based on ultra-performance liquid chromatography (UPLC) and tandem mass spectrometry (MS/MS) is used for three different classes of doping agents: diuretics, central nervous system stimulants (CNS stimulants) and opiates. The samples are diluted with buffer containing internal standards (IS) by a pipetting robot system into 96-well plates. Samples are injected on a reversed phase sub 2-microm particle column connected to a fast polarity switching and rapid scanning tandem mass spectrometer with an electrospray interface. The software used to evaluate the results produced reports containing a small-sized window for each component and a data table list with flags to indicate any adverse analytical findings in the sample. The report can also be processed automatically using an application software, which interpret the data and indicate if there is a suspicious sample. One 96-well plate can be analyzed within 16 h.     

Contribution from a hole-conducting dye to the photocurrent in solid-state dye-sensitized solar cells

The hole transporting medium in solid-state dye-sensitized solar cells can be utilized to harvest sunlight. Herein we demonstrate that a triphenylamine-based dye, used as hole-transporting medium, contributes to the photocurrent in a squaraine-sensitized solid-state dye-sensitized solar cell. Steady-state photoluminescence measurements have been used to distinguish between electron transfer and energy transfer processes leading to energy conversion upon light absorption in the hole-transporting dye.     

Multicomponent analysis of drinking water by a voltammetric electronic tongue

A voltammetric electronic tongue is described that was used for multicomponent analysis of drinking water. Measurements were performed on drinking water from a tap and injections of the compounds NaCl, NaN₃, NaHSO₃, ascorbic acid, NaOCl and yeast suspensions could be identified by use of principal component analysis (PCA). A model based on partial least square (PLS) was developed for the simultaneously prediction of identification and concentration of the compounds NaCl, NaHSO₃ and NaOCl. By utilizing this type of non-selective sensor technique for water quality surveillance, it will be feasible to detect a plurality of events without the need of a specific sensor for each type of event.     

Synthesis, crystal structure and magnetic properties of the open framework compound Co3Te2O2(PO4)2(OH)4

The new compound Co₃Te₂O₂(PO₄)₂(OH)₄ was synthesized using hydrothermal techniques. It crystallizes in the monoclinic space group C2/m with the unit cell a=19.4317(10) Å, b=6.0249(3) Å, c=4.7788(2) Å, β=103.139(5)°. The crystal structure is an open framework having chains of edge sharing [Co(1)O₆] octahedra. Other building blocks are [TeO₃(OH)₂], [PO₄] and [Co(₂)O₂(OH)₄] connected mainly via corner sharing. The –OH groups protrude into channels in the structure. The magnetic susceptibility measured from 2 to 300 K shows two broad anomalies at around 21 K and 4 K, respectively. The peak at ∼20 K is ascribed to a two-dimensional antiferromagnetic ordering of linear [Co(1)O₆] chains coupled by interchain interaction via [PO₄] groups in the Co(1) sheets. The second transition at 4 K is ascribed to a second antiferromagnetic ordering of the moments of the Co(2) entities via super–super exchange involving [PO₄] and [TeO₃(OH)₂] groups. This assignment is strongly supported by low-temperature heat capacity measurements indicating an entropy removal within the high-temperature transition of about twice the magnitude of the low-temperature transition.     

Synthesis,characterization, and curing of hyperbranched allyl ether–maleate functional ester resins

A model two-step synthesis of a saturated hyperbranched hydroxyl-terminated ester has been developed to show a synthesis route. Three different series of hyperbranched esters with different terminations have been synthesized to relate some of their properties to their structures. This route has then been used to synthesize three different allyl ethermaleate functional hyperbranched ester resins in a two-step procedure. The resins have been characterized with respect to rheology, structure, and properties, and the differences are discussed. The allyl ether-maleate functional resins have also been studied with respect to curing performance and final film properties. © 1993 John Wiley & Sons, Inc.